2. A block of wood with a horizontal section of 0.40 m x 0.40 m floats in water with 0.20 m. projecting above the water surface. If this block is placed in a body of oil having a sp.gr. of 0.80, if floats with 0.18 m. projecting above the oil surface. a. Determine the height of the object. b. Determine the sp.gr. of the object. c. Determine the weight of the object.

2. A block of wood with a horizontal section of 0.40 m x 0.40 m floats in water with 0.20 m. projecting above the water surface. If this block is placed in a body of oil having a sp.gr. of 0.80, if floats with 0.18 m. projecting above the oil surface. a. Determine the height of the object. b. Determine the sp.gr. of the object. c. Determine the weight of the object.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

i need the answer quickly
The hollow core panel is made from plain stone concrete. Determine the dead weight of the panel in kips. The holes each have a diameter of 5 inches. The unit weight of concrete is 144 lb/ft³. 10 in. | -12 in 12 in 12 in 12 in 12 in 12 in. 12 ft
A timber column, 8 in. × 8 in. in cross section, is reinforced on each side by a steel plate 8 in. wide and t in. thick. Determine the thickness t so that the column will support an axial load of 300 kips without exceeding a maximum timber stress of 1200 psi or a maximum steel stress of 20 ksi. The moduli of elasticity are 1.5 × 106 psi for timber, and 29 × 106 psi for steel.
If a 18-kg steel plate is attached to one end of a 0.1 m x 0.3 m x 1.20 m wooden pole, what is the length of the pole in meter above water? Use s.g. of wood of 0.7 and that of steel 6.4.
A TIMBER BLOCK “B x B” mm SQUARE IS REINFORCED ON OPPOSITE SIDES BY A “B” mm AND ‘t’ mm THICK STEEL PLATES. DETERMINE THE THICKNESS ‘t’ SO THAT THE ASSEMBLY WILL SUPPORT AN AXIAL LOAD OF 1000 KN WITHOUT EXCEEDING A MAXIMUM TIMBER STRESS OF 12 MPa OR A MAXIMUM STRESS IN STEEL OF 350 MPa. MODULUS OF ELASTICITY OF STEEL AND TIMBER ARE 210 GPa & 7 GPa RESPECTIVELY.
The assembly is subjected to a vertical shear of V=55 kip Figure B- 2 in. 0.5 in. 0.5 in. 6 in.. 2 in. 0.5 in. 6 in. < 1 of 1 0.5 in. 0.5 in. Part A Determine the shear flow at point A (Eigure 1) Express your answer with the appropriate units. 9A= Submit Part B μA 9B = Value Request Answer HÅ Determine the shear flow at point B Express your answer with the appropriate units. Value lb in ● Submit Request Answer - 1) ? B ? lbin-1)
Plz
Unit for Concrete a. Pieces b. Sack c. Cubic Meters d. All of the above
ASAP dont round off initial values, round off final ans only
Calculate the resultant force acting on the curved surface BC. Assume section is 4m perpendicular to the paper. List the given, required, graph and box the final answer
Please show your solution on a paper with FBD
Note: I need both right solutions with clear calculations.