2. A beam 20 m is supported by a roller at A and hinged at B. Three moving loads of 40 kN, 20 kN and 80 kN are placed at a distance of 1 m and 2 m respectively as shown passes thru the beam. a. Determine the maximum ordinate of the influence line for maximum moment at C. b. Determine the maximum live moment at C caused by the moving loads. c. Determine the maximum live shear at C caused by the moving loads. 40 KN 10 m 80 KN 120 KNI 00 O 5m 5m

2. A beam 20 m is supported by a roller at A and hinged at B. Three moving loads of 40 kN, 20 kN and 80 kN are placed at a distance of 1 m and 2 m respectively as shown passes thru the beam. a. Determine the maximum ordinate of the influence line for maximum moment at C. b. Determine the maximum live moment at C caused by the moving loads. c. Determine the maximum live shear at C caused by the moving loads. 40 KN 10 m 80 KN 120 KNI 00 O 5m 5m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Draw the Influence Line Diagram of members HI, KL, IJ, BI, FK, CD, and EF.Determine the maximum axial tension or compressive force to this members when a moving load of 75 KN and 50 KN (2 meters apart) is at member BH (Dead Load = 6 kn/m, Live Load = 10 kn/m).
I have a test that I need to answer in half an hour
Draw the influence line for (a) the vertical reaction at A, (b) the shear just to the right of B, and (c) the moment at A. Assume A is fixed, C is a roller, and B is a pin.
Draw the influence line for the force in member BC of the Warren truss. Indicate numerical values for the peaks. All members have the same length.
Draw the influence line for the vertical reactions at A and B. Draw also the influence line for the shear and moment at D.
Draw the influence line for the force in member CD.
Draw the influence line for the shear within panel cd and for the moment at e in the girder. determine (a) the maximum shear in panel cd and (b) the maximum moment in the girder at e if a single concentrated live force of 8 kn and a uniform live load of 2 kn/m can be placed on the floor beams. assume a is a pin and d is a roller.
Use analytical method and Muller and Breslau principle L1 = 3 L2 = 9 L3 = 3
6.2 Draw the influence lines for (a) the moment at C, (b) the vertical reaction at B, and (c) the shear at C. AssumeB is a fixed support. Solve using the Müller-Breslau principle.
Solve 6-1 using detailed steps
Use the Müller-Breslau principle to sketch the influence lines for the vertical reaction at A, the shear at D, and the moment at B.
Use analytical method and Muller and Breslau principle L1 = 3m L2 = 9m L3 = 3m