(2) The tank below is cylindrical with a diameter of 10 m . The outlet is a cylindrical frictionless nozzle, with a diameter 1 m. The top of the tank is open to the atmosphere. Page | 1 When the level in the tank is 10 m above the centerline of the outlet, how fast is the level in the tank falling?

(2) The tank below is cylindrical with a diameter of 10 m . The outlet is a cylindrical frictionless nozzle, with a diameter 1 m. The top of the tank is open to the atmosphere. Page | 1 When the level in the tank is 10 m above the centerline of the outlet, how fast is the level in the tank falling?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A nozzle of inner radius 1.06 mm is connected to a hose of inner radius 9.05 mm. The nozzle shoots out water moving at 25.0 m/s. Re 3. At what speed is the water in the hose moving? cm/s
HYDRAULICS an irrigation line carries water from a lake down into an arid valley floor 810 ft below the surface of the lake. The water is discharge through a nozzle with a jet velocity of 220 ft/s, the diameter of the jet is 4 inch. Compute the head loss in friction.
3. A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 N per cubic meter enters the bottom of the tank with a uniform velocity of-assume values with at least 3 decimals between 3 to 4 m per second-enters the stack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Graph velocity at the abscissa against height at the ordinate.
A pump is required to transfer water at the rate of 350 kg/s from an open sump to an open storage tank located 30m above the pump. The suction pipe is 350mm in diameter and 12m in length, and the delivery pipe is 550mm in diameter and 40m in length. The friction factor of the pipe system is f=0.005. Q. Calculate the maximum height at which the pump may be placed above the sump, so that pressure at the inlet is not less than -80 kPa
#10 only
A water tank with a depth of h open to the atmosphere will be discharged through an outlet pipe with a diameter of 1 cm. The density of water is 1000 kg/m3, dynamic viscosity is 0.001 kg/ms. The pipe is 20 m long and there is a pump and a full open angle valve on the pipe. If the pump head supplied by the pump is hp = 2 m, the pressure at the outlet is 150 kPa and the outlet flow rate = 0.001 m3/h, calculate the height h. (Take atmospheric pressure as 100 kPa).
The water is flowing with a velocity of 1.5 m/s in a pipe of length 2500 m and of diameter 500 mm. At the end of the pipe a valve is provided. Find the rise in pressure if the valve is closed in 25 seconds. Take the value of C=1460 m/s.
A vertical circular stack 30 m high converges uniformly from a diameter of 6 m at the bottom and 4.5 m at the top. Gas with a unit weight of 0.12 Nper cubic meter enters the bottom of the tank with a uniform velocity of—assume values with decimals between 3 to 4 m per second—enters thestack. The unit weight increases by 7.5 percent every 2 meters. Find the velocity of flow at every 5 meters along the stack. Please add the figure , thank you!
A pump draws water from a large open sump through a short length of the suction pipe. The water is delivered through a 21.1 m length of 9 cm diameter pipe and via a submerged exit into an open tank. A control valve is installed in the delivery pipe, for which f = 0.0085. Dissipation other than friction and the loss at the valve may be ignored. The bottom of the tank is 10 m above the free surface of the water in the sump. What power will be required in kW if the water will be delivered to 1.5m above the pump?
A venturi meter with a 10.16 cm throat installed in a 15.24 cm pipe which is inclined upward with an angle of 45 degrees to the horizontal. If the distance between pressure tape along the pipe is 1.5 m, the differential pressure is 70kpa and the water temperature is 70°C, what is the discharge of water in cubic meter per second? Assume coefficient of 0.985.
solution only
7. A 20hp suction pump operating at 70% efficiency draws water from a suction line whose diameter is 200mm and discharges into air thru a line whose diameter is 150mm. The velocity in the 150mm line is 3.6m/s. If the pressure at point A in the suction line is 34kPa below the atmosphere, where A is 1.8 m below B on the 150mm line, determine the maximum elevation above B to which water can be raised assuming a headloss due to friction.