Answered: 2) Stranded conductor 61/2.9 mm.…

2) Stranded conductor 61/2.9 mm. calculate the equivalent diameter of conductor? a. 14.5 mm. b. 16.9 mm. c. 26.1 mm. d. 20.3 mm.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: The differences between TWO unequal towers 70m support a transmission line conductor at road…

A: We usually come across this type of arrangement in hilly areas where conductors are suspended…

Q: A 3phase 60hz line has flat vertical spacing. The conductor have a GMR of 0.0133m with 10m between…

A: A 3phase 60hz line flat vertical spacing. The conductor have a GMR of 0.0133m 10m between adjacent…

Q: Theoretically solve an unknown resistance for Transmission line conductor by using any two methods…

A: Wheatstone bridge This bridge is used to calculates the unknown resistance by balancing two legs of…

Q: 23) Consider a 10kv şingle-phase_cable with an insulatin material between the conductor and the…

Q: A 2-wire d.c. distributor cable AB is 2 km long and supplies loads of 100A, 150A,200A and 50A…

A: It is a two wire distribution system with distributor fed at one end: Here, the distributor is fed…

Q: The towers of height 45 m and 85 m respectively support a transmission line conductor at water…

Q: Select the best transmission line from the following: Select one: a. Conductors with very low ohmic…

A: In the above question they are clearly discussing the properties of transmission line Transmission…

Q: Q4: Each conductor of a 3-phase high-voltage transmission line is suspended by a string of 4…

A: Given data, V2=13.2 KV, V3=18 KVXc= 1Ω

Q: a voltage is being induced into a conductor by electromagnetic induction, reversing the direction of…

Q: a) Explain the demerits of non-uniform potential gradient of insulated cable. b) Insulation…

A: a) Demerits of non uniform potential gradient 1) unequal potential leads to unequal stress. stress…

Q: A 84 meter long conductor with a unit weight of q=(0.8) kg/m is separated from each other. It is…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: Which among these is used to determine or compute for the Transmission Line AC Resistance? A.…

A: power losses = (current)2*Ac resistance where as dc resistance = resistivity×lengthcross sectional…

Q: A single core 66 kVolts cable has a conductor diameter of 2 cm and a sheath of inside diameter 5.3…

Q: 3. The towers of height 35 m and 95 m respectively support a transmission line conductor at water…

Q: () List any three factors to be considered for mechanical design of overhead lines

A: According to our expert policy only one individual question is to answered.kindlybrepost the…

Q: What is the different b/w solid type cables and pressure cables (oil and gas)...

A: There are various ways of classifying the cables and the classification depends upon various…

Q: 3. A two conductor main A B, 500 m in length is fed from both ends at 250 volts. Loads of 50 A, 60…

A: The solution can be achieved as follows.

Q: 82 A transmission line has a span of 150m between level supports. The conductor has a weight of…

Q: Q2. What is the benefit of using stranded conductors in transmission systems?

A: The benefits of stranded conductors are listed below:

Q: 4. The value of a at OdegC of a conductor is 1/236 per ind the value of a 18degC.

Q: An overhead transmission line is supported at a river crossing by two towers of height 34 m. The…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: Correct statement related to weight of conductor and sag is .............................. Weight of…

A: The correct statement related to weight of conductor and sag is given below weight of conductor is…

Q: Calculate the geometric mean radius (GMR) for the arrangement of parallel conductors shown below if…

A: here we have to find the Geometric mean radius.

Q: The differences between TWO unequal towers 60 m support a transmission line conductor at road…

Q: A-Define the sag of T.L and derive an expression for the total length of a Conductor and the tension…

Q: A double-circuit its capacitance to neutral per mile. line is shown below. The conductor radius is…

Q: Assume that a single-conductor belted cable has a conductor diameter of 0.681 in., inside diameter…

A: Given data: -Diameter of conductor = 0.681 in=0.681∗0.0254…

Q: An over head transmission line has a cross area of conductor of 4 cm and supported from two towers.…

Q: In the core conductor given below, the radius of each core is r. the GMR of this conductor as r.

Q: (b) Determine the inductance per km/phase of a double circuit three-phase line as shown in the given…

Q: Determine the inductance per unit length of a coaxial cable with an inner radius a and outer radius…

A: Flux through a surface is Dot product of Flux density and area. Flux is also equals to Inductance…

Q: A two-wire DC splitter of 1Km length and resistance of each conductor (m/00030.0) and feeds the…

Q: Iron material is used for the design of Fuse Select one: O True O False

A: Material required for design the fuse as per our guidelines we are supposed to answer only one…

Concept explainers

Wheatstone Bridge Method

A Wheatstone bridge is a circuit used to measure unknown resistance by measuring the ratios of the two branches of the circuit such that each branch has two resistance and out of four resistance one is unknown. The two branches are joined in between with the help of galvanometer which is used to determine the direction of the current. The main advantage of this circuit is that it can provide the most accurate measurement (different from a simple voltage separator).

Question

2) Stranded conductor 61/2.9 mm. calculate the equivalent diameter of conductor?
a. 14.5 mm.
b. 16.9 mm.
c. 26.1 mm.
d. 20.3 mm.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Pls do step by step
Do All the subpart of given question.. A 765kV circuit has flat horizontal spacing of 10ft between phases, 4 conductors perbundle, and each bundle is arranged in a square of 1.0 ft on a side. The conductor has adiameter of 1.2 inches.a. Calculate the geometric mean distance between phases. Give units.b. Calculate the geometric mean radius of a single conductor. Give unitsc. Calculate the geometric mean radius of a bundle. Give units.d. Calculate the per-phase inductance of the circuit. Give units.e. Calculate the capacitive geometric mean radius of a bundle. Give units.f. Calculate the per-phase capacitance of the circuit. Give units.
a.Why does power plants have high amounts of voltages? Explain. b.Is it safe for transmission lines to have high current instead of high voltage? Why? c.What phenomenon is avoided by having separations between three conductor phases? Explain this phenomenon.
Please. Solve this question correctly,,
Choose one or more than one option and answer in detail with principle
을 A circules ring of 3 turns iis made of Conducting wire. Now same wire The M.F. is bent to form ring of ctuong centre ( I Aome) at centre s B. Then flo M. F. at
The Cost OF Single phase overhead feeder is OMR q Per KM(a is area of cross section in sq mm) and the intrest and depre Ciation Chargs onfeeder omical carrent density are 7Y. defermain to use for the most econor requiring Full load current of 27% of the 12 baisa is year. The Cost per unit ass ume resistance of Im lenahth length and I mm² secfion of Conductor as 1/32 find Current densi ty =?
1. A Single-phase, two-wire overhead line has solid cylindrical copper conductors with 2.4 cm diameter. The conductors are arranged in a horizontal configuration with 3 m spacing. Calculate the inductance of each conductor due to both internal and external flux linkages in mH/km. (
A single core cable is to be used for 66 kV to earth. Its conductor diameter is 2 cm and its three insulating materials have permittivity 5, 4 and 3 respectively. The corresponding safe maximum stresses are 38 kV/cm, 26 kV/cm and 20 kV/cm, respectively. Find the minimum diameter of the sheath.
" Source Transformation " Use source transformation only to solve for Vo.
2) Stranded conductor 61/2.9 mm. calculate the equivalent diameter of conductor? a. 14.5 mm. b. 16.9 mm. c. 26.1 mm. d. 20.3 mm.
The cost of a single phase overhead feeder is OMR 17 a per km (a is area of cross section in sq mm) and the interest and depreciation charges on feeder are 7%. Determine the most economical current density to use for distribution requiring full load current of 70% of the year. The cost of generating electrical energy is 12 baisa per unit. Assume resistance of 1 m length and 1 mm section of conductor as 1/62 ohm. Current density =- A/mm?