2) Mr. X performs the laboratory test and determines that 12 mg/l of alum dose is required to treat the water. What is the quantity of alum required to treat 14 million liters of water per day at a treatment plant. Also determine the amount of carbon dioxide gas produced per liter of water during treatment.

Q: 1. It is desired to design a bromide chloride contact tank to be used to disinfect a…

A:

Q: During a chlorination experiment of a secondary settling tank effluent, the results show that the…

A: Types of Chlorination:

Q: A high-rate digester is being operated at a constant temperature of 100°F. The sludge loading rate…

A: Given data- High-rate digester- Temperature = 100oF, Sludge loading rate SLR=396 m3/d, To Find- The…

Q: The urban heat islands occur when cities replace natural land cover with pavement, buildings and…

A: Clay tiles- It is a type of building material. It is mainly used as a roofing material.

Q: 224. is as follows: An average operating data for conventional activated sludge treatment plant (1)…

A:

Q: Disinfection: Graph the following data for the inactivation of a virus using hypochlorous acid…

A: The data for inactivation of a virus using HOCl is as followsThe graph has to be plot and time…

Q: The hydroxide ion concentration in a solution of NaOH is 2.0 x 10-¹ M at 25 °C. What is the pH of…

A: Given data in question  Concentration of NaOH 2×10-1 M To find out  p(H)

Q: QI/ A tank is initially filled with ( 250 gal) in which 50 lb of salt are dissolved. salt Fresh…

A:

Q: Q1) A city discharge 629 ft³/sec of sewage into a river whose flow rate is 5040 m³/hr. Determine the…

A: Discharge=629 ft3/sec=17.811 m3/sec River flowrate=5040 m3/hr=1.4 m3/sec Downstream distance=25 km

Q: What percentage of the BOD is being removed by this treatment plant (6)?

A: BOD means biochemical oxygen demand.It is the amount of oxygen required for microorganisms to…

Q: Answer fast

A: Step 1:part a  Step 2:part B

Q: Question 8 Given the following dissolved oxygen data for an aeration test with Cs = 9 mg/L, the KLa…

A: When a supersaturated solution is to be degassed or removal of gas takes place,then equation can be…

Q: Consider an ideal refrigeration cycle that has a condenser pressure 1000 KPa and an evaporator…

A: Pressure is acting on the inclined wall while the load is generating in the area of the element. The…

Q: The amount of chlorine residual remaining when gases start evolving during disinfection and when…

A: The amount of chlorine residual remaining when gases start evolving during disinfectionand when they…

Q: If the alum dose required to coagulate is 10 ppm, find out the amount of alum (in quintals) needed…

A:

Q: You are treating 10 million gallons per day (MGD) of water with alum at a dosage of 50.0 mg/L. Alum…

A: (a) The monthly alum dosage required in metric tons/month (1 metric ton =1000 kg) 1 Gallon=3.78…

Q: 11.61 A 4.0% sodium fluoride solution is applied to increase the fluoride concentration from 0.4 to…

A: Given, Strength = 4% Initial fluoride = 0.4 mg/L Final fluoride = 1 mg/L

Q: 01: A sample of industrial waste water have BOD: (1254 6mg/L) and biological oxidation (3.4 day) at…

A: biological oxygen demand - the amount of oxygen required for the decomposition of bio degradable…

Q: In a wastewater treatment plant, the supply of oxygen supply is 073 kgO2/h is necessary…

A: Given data:  oxygen supply under operating conditions, Ns = 73 kgO2 /kwh = 73 MJ Liquid temperature:…

Q: (a) A strain of E. coli bacteria taken from a sample of waste water in a treatment plant are…

A: (a) N = Aekt (i) A/q at t=0 N = 20 So, 20 = A * ek*0 or, A = 20

Q: A water contains 100.0 mg/L CO2-3 and 75.0 mg/L HCO-3 at a pH of 10 (T =25C).  Calculate the exact…

A: Given, CO2-3 = 100 mg/L HCO-3 = 75 mg/L pH = 10

Q: A BOD test is conducted using standard size BOD bottles. The technician prepares  two BOD bottles on…

A:

Q: The tank shown below contains 80 lbs of salt dissolved in 500 gal of water. The inflow per minute is…

A:

Q: A sewage has a suspended solid contents as 250 mg/litre. The sedimentation tank removes 55% of the…

A: Suspended solids So=250 mg/L Efficiency=55%=0.55, water content of sludge=95% Water to be treated =…

Q: If you are designing a monitoring program for dissolved oxygen in a stream that receives inputs from…

A:

Q: Pumps that lift surface water and move it to a nearby treatment plant are called:

A: Hydraulic machines:

Q: A Brine containing 2 lb of salt per gallon runs into a tank at 2 gal/min, brine from this first tank…

A: The figure is shown below,

Q: A container of water is being mixed to raise its dissolved oxygen concentration. The transfer…

A:

Q: Determine the rate constant of a pesticide which has a half life of 9 days. Also determine the time…

A: Given: Half-life of pesticide, t1/2 = 9 days

Q: After aerating a water sample, you measured the dissolved oxygen (DO) and the DO meter showed a…

A: Given data :    RPD = 11% =11/100 =0.11 Determining the saturation concentration oxygen = R1 After…

Q: (d) COD levers of 60 mg/L were measured in groundwater. contamination is the main cause. It is…

A: It is assumed that fuel hydrocarbons have an average unit formula of CH2

Q: 2. You are asked to design a disinfection system with a capacity of 50,000 L/hr to achieve 3 log…

A: To determine the volume and dimensions of a chlorine contactor without assuming the length and…

Q: Q2// It is required to produce a granulated product (P) from the feed material (F) by the process…

A: The flow of fluid includes movement of an unbalanced fluid. As long as unequalled forces are in…

Q: 4. A simply supported reinforced concrete beam with a width of 230mm and an effective depth of 500mm…

A:

Q: Given concepts of water quality: Some of the more important general water quality parameters can be…

A: Some of the more important general water quality parameters can be listed as  a) Turbidity b)…

Q: An effluent at flow rate of 2670 m3/day is to be treated. The dosage of chlorine is 15 mg/lt and the…

A: Given: Flow rate = 2670 m3/day Chlorine dosage = 15 mg/lt Disinfection model = Nt = Noe-0.145t

Q: Use the table below to calculate the following: The concentration (in mg/L and mol/L) of the…

A: Calculate formula weights (FW) for Al2O3 and Al2(SO4)3.14H2O Take molecular weight of Al=27 g/mol,…