2 m, as shown in the figure below. Constructed, load P=5,000 N is given perpendicular to point C. The pq plane with each α = 36° at the bar AC. There is. The elastic coefficient of all materials is E=150 GPa. a) Draw a free object diagram and seek repulsion at points A and B. b) Obtain the vertical and shear stresses acting on the pq plane. c) Find the vertical and horizontal displacement at point C.

Q: Find the maximum P that can be applied at point E given that:

A: The below approach entails using material mechanics ideas to the issue of determining the maximum…

Q: Consider a structure including the horizontal beam AB hinged to the wall at point A and supported by…

A:

Q: Q: A rigid block of negligible mass is supported by three rods as shown in figure, if a load (P) is…

A:

Q: Example: A bar with a rectangular cross section and a central circular hole in tension F+ W O Id F w…

A:

Q: (b) V brakes Question Four A long retaining wall is braced by wood shores set at an angle of 30° and…

A:

Q: A1 A uniform bar of length L and cross sectional area A is held vertically at the upper end and…

A: When a uniform bar is hanged hanged vertically, the weight of bar varies from zero to W. At tip, it…

Q: Calculate the support reaction force for the uniformly distributed load b LAB = 1 m. The downward…

A: Given:Intensity of uniformly distributed load = Let,horizontal reaction at hinge support Avertical…

Q: D = 90 mm d = 60 mm r = 12 mm t = 10 mm F = 9000 N What is the magnitude of the maximum stress at…

A: Given:Width of larger section, D=90 mmWidth of smaller section, d=60 mmRadius of fillet, r=12…

Q: 5. The rigid beam is supported by a pin at Cand a steel wire AB (Esteel = 200 GPa). a) If the wire…

A:

Q: 2. The uniform beam shown in Figure 2 weighs 500N and supports a 700N load. Find the tension in the…

A: Answer: (a) The tension in the tie rope is 2899.34 N. (b) The force of the hinge on the beam is…

Q: The beam is supported at A and B as shown in (Figure 1). Suppose that F = 4 kip and w = 250 lb/ft.…

A: To Find : The normal force at point D The shear force at point D Give : The free body diagram is,

Q: Q.1 (15%) Bar with cross-sectional area A and length L is inclined at angle a. Determine the element…

A: Step 1:    Step 3: Step 4:

Q: The frame shown in Figure 3.1 has internal pins at points B, C and D and is supported by a pin at…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.