(2) jkbi During the test of separately excited generator the speed of rotation must be held constant and the generator field resistance must be adjusted to make the generator terminal voltage * .220V at no load True False During the test of shunt excited generator the voltage نقطتان )2( initially must be adjusted to 220V. then the generator is loaded and the generator field circuit current must be * .held constant True False

(2) jkbi During the test of separately excited generator the speed of rotation must be held constant and the generator field resistance must be adjusted to make the generator terminal voltage * .220V at no load True False During the test of shunt excited generator the voltage نقطتان )2( initially must be adjusted to 220V. then the generator is loaded and the generator field circuit current must be * .held constant True False

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A 100KVA, 6.6 kV 3 PHASE star connected cylindrical pole synchronous generator has 20-ohm as synchronous reactance and the armature resistance is negligible and the generator is working at the full load and unity power factor then find the value of the induced emf voltage(line to line). Answer fast
Four similar synchronous generators are sharing equally the feed to a load of 1 pu referred to the base value of the the synchronous generator, hence,. a) The per unit output of each generator is 0.25 b) The power factor of each generator is 0.25 c) The available info is insufficient to calculate the per unit impedance of the load d) None of these
Question 3. Parameters for a 400 V three-phase synchronous generator with 5 kVA power are given as X = 12 2 and X ₁ = 72, and armature winding resistance is neglected. Calculate the induced voltage in the generator since this generator feeds a load with its nominal current at its nominal terminal voltage, cos=1.0.0
A 10-kVA, 230-V, three-phase, delta-connected, the synchronous generator has a winding resistance of 0.2 ohms/phase and a synchronous reactance of 0.5 ohms/phase. Determine its voltage regulation when the power factor of the load is (a) 86.6% lagging, (b) 86.6% leading, and (c) unity.
A 40 MVA, 24-KV, 0.85-PF-lagging, 50-Hz, 4-pole, Delta-connected, 3- phase, steam-turbine generator has a synchronous reactance of 10 per- phase, and a negligible armature resistance. The field current is adjusted for 26-KV generator output line voltage at no load. This generator is connected to operate in parallel with a large power system (infinite bus). If the field current is unchanged, determine the absolute maximum output power of this generator. Select one: a. Pout, max = 187.2 MW b. Pout, max = 108 MW O c. Pout, max = 62.4 MW %3D O d. None
A cylindrical rotor generator delivers 0.5 pu power in the steady-state to an infinite bus through a transmission line of reactance 0.5 pu. The generator no-load voltage is 1.5 pu and the infinite bus voltage is 1 pu. The inertia constant of the generator is 5 MW-s/MVA and the generator reactance is 1 pu. The critical clearing angle, in degrees, for a three-phase dead short circuit fault at the generator terminal is
Please solve it quickly
The maximum efficiency of a 200KVA, 6000/230volt, 50HZ, single phase transformer occurs at half load and is 95% at unity power factor. What is the full load efficiency at 0.7 power factor?
Subject:machines topic: synchronous machines
Energy Question-1) Three identical synchronous generators were connected in parallel and the idle frequency values of each generator were set to 54 Hz. The frequency - power characteristic slopes of the first and second generators are 5.3 MW/Hz and the slope of the third generator is 3.9 MW/Hz. When these three identical synchronous generators feed a load together, the system frequency becomes f=51.7 Hz. According to this;a-) Calculate the active power value that the first generator will provide to the load.b-) Find the active power that the second generator will provide to the load.c-) Find the active power that the third generator will provide to the load.d-) Calculate the power of the load.(All values in options a, b, c, and d in this Question will be entered as two digits after the comma.) NOTE: If the information in the text and the photo is different, please solve the question using the information given in the photo. Help me please... Thank you so much.
To understand how the problems can be done in complex number format Problem 4: A 3600 rpm, 60 Hz, 13.8 kV synchronous generator has a synchronous reactance of 2002. The generator operating at rated voltage and speed with the per phase excitation voltage Eo=11.5kV and the torque angle 8-15° Calculate Stator current. Power factor. Total output power. The maximum power that can be converted from mechanical to electrical form without loss of synchronism. The value of armature current for the condition stated in (d). a) b) c) 10/19/2020 e)
Electrical machines