2 and 7₂ and =205 reflection coefficient =?

Q: 5,-Find the values indieated · below For the tol circuit. l 20K when switch is in lov JOV 10uF Ne ビニ…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v 0.5 O 0.06 0 3

A: The given waveform is saw tooth waveform.

Q: For the trapezoidal current wave-form, determine the effective value. I (A) 1.22^2* peak current I B…

A:

Q: You read 10 Vpk on the oscilloscope across a resistor in a series RC circuit. With a 15 Vpk AC…

A: Current in resistor and capacitor is same as thay are connected in series with each other.  Take…

Q: B4 (i) For the given square waveform, calculate (a) frequency and (b) magnitude. 2! 0.5 5 0.2 10-…

A: From the given waveform we can able to find the amplitude and frequency of the given square waveform…

Q: Two cycles of a Triangular wave signal observed on an oscilloscope is found to occupy 12 cm at a…

A:

Q: WAVEFORM. DH 47 k V

A: Here we have to draw the output waveform.

Q: Arectangular wavegúde for cwhich r=0, = a =1:5 cm 6= Oo8 cmo It is operated at 50 G Hz Determine…

A: Wave is function of space and time. The mode at which waveguide have lowest frequency is said to be…

Q: Problem: Caleulate Average valur, Runs value and Form fuctor of the sawtuutlh wave shon in the…

A: we need to find the average value,rms value,form factor.

Q: a) frid Dens for This periodic wave form Us(t) b) find the porer burned Power in the load Re <)…

A: We need to calculate RMS value of given wave form , we know the formula for RMS value. We also…

Q: 7. (30cis87.6)/24cis48

A: The question is about polar form.

Q: A voltage applied across a circuit with pure element  and draws a current of i = -3 sin (377t - 400)…

A:

Q: 2.A series R -L-C circuit is to be made resonance when connected to a 200 – volt 500 cycle source.…

A:

Q: Find the core diameter for a SMF in the 2nd window if ncore=1.48 & ncladd=1.478 ?

A: Given, Refractive index of core, ηcore=1.48 Refractive index of cladding, ηcladd=1.478 As for 2nd…

Q: Give me the reactance of inductor of inductance 500 mH and frequency of 10 MHz?

A: The given values of inductance and frequency are:

Q: The current flowing throup h 2H induc toz ie おuen 6. 5 . Find expressi ans for the voeboge,…

A: Inductor is passive element that store energy in magnetic field. The voltage across inductor is…

Q: With the same timebase of 250us what is the Frequency of the following wave?(?) Please solve with…

A:

Q: In a BJT fixed bias configuration, if the base supply voltage (VBB) is set to zero, what will be the…

A: We need to select correct option for given statement

Q: How do we effectively and correctly analyze the waveform from ISim?

A: It is asked how to effectively and correctly analyze the waveform from ISim.

Q: Why the magnitude of the voltage across the capacitor is many times larger than the source voltage…

A:

Q: 7. Find the average and r.m.s. values of the voltage wave shown. 0 n 3 2

A:

Q: / Electric field intensity is  defined by

A:

Q: what's the value of magnitude?

A: It is given that:

Q: 9 - In what ways do reflectors direct the light as given below?   A) Reflection and cutout…

A: We need to tell about what do reflectors .

Q: Determine the Q-factor of a 4MHz crystal with the following values: L=100mH, R=100Ω, C=0.015pF, and…

A: We need to find out the Q factor .

Q: If voltage standing wave ratio, (VSWR) of a wave is 2, it's reflection coefficient will be ?

A: Given: Voltage standing wave ratio, (VSWR) of a wave is 2 Reflection coefficient, Γ = ?

Q: 2. Find the correlation between the two waveforms shown below analytically.

A: Given:

Q: 4. What is ripple factor of the Full-waverectifier? 5. What are the applications of arectifier? 6.…

A: 4.  The ripple factor for a full wave rectifier is= 0.482.

Q: current required to radiate apower

A: Antenna- An antenna is a structure made up of metal which captures or transmits radio…

Q: A plane wave of frequency 100 KHz propagates in a copper alloy. The magnetic permeability of the…

A: Frequency, f=100KHz Wavelength, λ= 0.5mm

Q: skuch the waveform 3.

A:

Q: vo Vị

A: I am attaching detailed solution image of this question.

Q: What is the RMS voltage of a square wave with a 10% duty cycle that swings between ground (OV) and…

A: Given Data: Duty cycle = 10% voltage swing = 0 to -5V

Q: What will be the impedance of a 100 mH inductor at 1 GHz?

A: At the frequency of f Hz, the impedance of an inductor of inductance L H will be

Q: 2. For the given circuit, sketch the waveforms for W, X and Y. D EN CIk A Y Cik

A: Considering the positive edge trigger flip flop. Characteristic table of D-FF: It can be concluded…

Q: edefine the avuage 4. How do f an ACO wavefloum.? Determine the aaverage value of a full "sectified…

A: Rectifier: This is an electrical circuit that converts ac into dc. This is used where dc input is…

Q: A 3V sinusoidal signal with frequency 100 Hz amplitude is applied to channel A of an oscilloscope. A…

A:

Q: 8. If kr = Eripplerms/Eave, determine kr of the given waveform. 2Vp-p 10v 1 0.5 0.06 0.3

A:

Q: . Determine the RMS values of the waves shown in the Figures 5.6, 5.7 and 5.8. Figure 5.6 15 Figure…

A:

Q: x=2V sinft-) Consider the above series AC circuit, determine the series current I, in its phasor…

A: Note: Only active power will be available in purely R Load Only Reactive power will be available in…

Q: In a BJT, Ico= ICBO =2 μA. Given a = 0.99, the value of ICEO is?

A: Given: In a BJT the parameters are, Common base current, ICO=ICBO=2 μA The current gain, α=0.99

Q: Why the sinusoidal waves are considered analog signals? a- It moves in both positive and negative…

A:

Q: A stationary closed Lissajous pattern on an oscilloscope has 3 horizontal agencies for a horizontal…

A: Given- Horizontal tangencies = 3, Vertical tangencies = 2, Frequency of Horizontal input = 3 kHz,…

Q: Channel 1 and Channel 2 Time (ms) Phase problem. In the above figure the time base is 1 ms/div, what…

A: Given: Time base=1ms/div