[2] A D.C. to D.C. chopper operates from a 48 V battery source into a resistive load of 240hm. The frequency of the chopper is set to 250Hz. When chopper on-time is 1 ms the load power is A. 6W B. 12W C. 24W D. 48W

Q: 93uF 7 L 301 3302 5 Pa ssband ain190 vj İVJ I got the exact ftsl98.0549Hz- vil is the Voltage gan…

A: Write the expression to find exact value of lower cutoff frequency for the given circuit as follows:

Q: Ex (H.W) Calculate the value of R₁ for which it will receive maximum from Power the Load. and…

A:

Q: + 17V 14A+ R, 25V 0.41

A: Applying the nodal analysis at the node:

Q: What are the branch currents, 12 and 13? R₁ 4 kOhm V₁ 35 V R2 7.5 kOhm R 12.5 kOhm

A: Introduction Current divider rule: The current divider rule is an electrical principle that explains…

Q: Vs= 12V R= 200ohm Inductor = 400T with I core Frequency 60hz Find the reactive power

A: Given: Let L=400 mHVs=12VR=200Ωf=60 Hz

Fault Analysis

In an electrical engineering system, a fault is an abnormal electric current flowing through the system, and fault analysis is the study of these faults. For instance, a short-circuit is a fault where the live wire touches the ground or neutral wire. If a circuit is interrupted by a failure of a current-carrying wire then an open circuit fault occurs. The open-circuit faults are also called series faults. One or more phases or ground may be involved in a three-phase fault or may occur only between two phases. Current flows into the earth in case of a ground fault or earth fault. For most situations, the prospective short circuit current of a fault that is predictable can be calculated. To limit the loss of service because of a failure, the protective devices can detect fault conditions and operate circuit breakers and also other devices. All phases equally can be affected in a poly-phase system which is known as symmetric electrical fault. The asymmetric fault becomes more complicated to analyze if only some phases are affected. By using methods such as symmetrical components, the power system analysis of these types of faults is often simplified. The main objective of power system protection is to design, detect, and interrupt power system faults.