2 2 ) The ratio of the lift force ( L ) to the drag force ( D ) for the simple airfoil is ( L/D = 10 ). If the resultant force ( R ) of the lift force and the drag force on a short section of the airfoil is ( 60 lb ), compute the magnitude of each of the lift force ( L) and the drag force ( D ) and the

2 2 ) The ratio of the lift force ( L ) to the drag force ( D ) for the simple airfoil is ( L/D = 10 ). If the resultant force ( R ) of the lift force and the drag force on a short section of the airfoil is ( 60 lb ), compute the magnitude of each of the lift force ( L) and the drag force ( D ) and the

Name: Q 2 )The ratio of the lift force ( L ) to the dragforce ( D) for the
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: Q 2 )The ratio of the lift force ( L ) to the dragforce ( D) for the simple airfoil is ( L/D = 10 ).If the resultant force ( R ) of the lift force andthe drag force on a short section of the airfoil is( 60 lb ), compute the magnitude of each of thel

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

An aircraft is required to climb with 10° of climb angle. The aircraft has a mass of 30,000 kg and produces 50,000 N of drag. Assume zero angle of attack and zero thrust setting angle. How much lift this aircraft must generate?
Question 2: Consider the 5000kg aircraft below being in a 1000m radius looping maneuver (Fig.2). There are 4 forces acting on the aircraft (Weight, Thrust, Lift, Drag). Assuming that they are all approximately perpendicular to eachother at points A,B,C, calculate the following: A. Calculate the Lift Forces at points A, B, C if the aircraft was at a constant speed of 350km/h throughout the maneuver. B. Calculate the Lift Forces at points A, B, C if the aircraft starts the maneuver at point A at a speed of 400km/h, but reduces its speed with constant acceleration so that the pilot feels weightless at point C. C. A human can withstand earth's gravity was more than 9 times what it is now, we would not survive. What is the maximum of 9 times the gravitational acceleration, i.e. if the maximum speed the pilot can enter this maneuver? Figure 2: Looping Aircraft
Air at a temperature of 15°C and a pressure of 1 Atm at a speed of 100 km / h figure below-a da it crashes into the visible water tower. Free at Figure-b to prevent Tower toppling as seen in the object diagram, the moment(M)that the base of the tower must resist calculate. The resistance coefficient for the cylinder part is 0.7, the resistance coefficient for the sphere part is 0.3 you may take.
A carpenter drops by accident a tool from a tall building. When falling the air resistance depends on the speed and is given by a (drag) = 0.003 v2 What is the time it takes the tool to reach a speed of 20 m/s?
On a runway of a decommissioned airport, a 2000 kg car travels at a constant speed of 100 km/h. At 100 km/h the air drag on the car is 1400 N. Assume that rolling friction is neglie (a) What is the force of static friction exerted on the car by the runway surface, and what is the minimum coefficient of static friction necessary for the car to sustain this spe As, min (b) The car continues to travel at 100 km/h, but now along a path with radius of curvature r. For what value of r will the angle between the static friction force vector and th velocity vector equal 45.00? r = For what value of r will it equal 75.1°? r = What is the minimum coefficient of static friction necessary for the car to hold this last radius of curvature without skidding? As, min = eBook
An aircraft has a wing area of 70 m? and a wing loading of 2500 N/m2. The air density could be taken as 0.45 kg/m3. The drag equation for the aircraft is given as: Cp-0.016+0.055 C2 Calculate its minimum drag speed in m/s. Keep 2 decimals.
A flat plat 1200 cm x 280 cm is kept in a fluid which has a velocity of 570 m/s.lIf resultant force acing on the plate is 280 kN then calculate 3 the lift force. Assume the density of the fluid is 2.3 kg/m³ and the viscosity of the fluid is 0.21Poise. pkg/m³ vm/s Lift Drag
B2 is flying at an altitude of 43,000 ft and a speed of 400 KTAS under standard atmospheric conditions. If the average aerodynamic chord is 39,6 ft, calculate the Reynolds number and the average % aerodynamic chord present on the wing
110 N Q2: A commercial airliner with four jet engines, each producing (110 kN) of forward thrust, and soin there are a ( 80 kN ) drag resisting the airplane, is in a steady, level cruise when engine number (1) suddenly fails. Determine and locate the resultant of the three remaining engine thrust 110 kN+ 110 kN vectors. -- --
Q1: Find the boundary layer thickness (6) equation, the shear stress (to) and the coefficient of drag (C₁) if the velocity distribution in the laminar boundary layer over the face of a spillway was observed to be: u 7- (C)-()*+C)*. U Then calculate the boundary layer thickness and drag force if the air flows over a sharp edged flat plate 0.25m long and 0.5m wide at a velocity 1 m/s, take the air density 1.23 kg/m³ and the kinematic viscosity is 1.46*10-5 m/s².
An aircraft is required to climb with 10° of climb angle. The aircraft has a mass of 30,000 kg and produces 50,000 N of drag. Assume zero angle of attack and zero thrust setting angle. How much thrust the aircraft engine must produce?
2.4 A 2650-lb car is traveling at sea level at a constant speed. Its engine is running at 4500 rev/min and is producing 175 ft-lb of torque. It has a drivetrain efficiency of 90%, a drive axle slippage of 2%, 15- inch-radius wheels, and an overall gear reduction ratio of 3 to 1. If the car's frontal area is 21.5 ft², what is its drag coefficient?