1| 2 | 3 | 4| 5 | 6 7 8 9 10 Measurement Flow Rate (liters/hr)| 1066 1022 | 1143 995 1004| 927 | 1024 | 945 979 | 1059 1. The table above contains 10 measurements taken of the volume flow rate through a pump running at a fixed operating conditions. Find the following statistical quantitie for this data set: a. The average flow rate: Vave liters/hr. b. The median flow rate: Vmedian liters/hr. c. The sample standard deviation: 0, liters/hr.

1| 2 | 3 | 4| 5 | 6 7 8 9 10 Measurement Flow Rate (liters/hr)| 1066 1022 | 1143 995 1004| 927 | 1024 | 945 979 | 1059 1. The table above contains 10 measurements taken of the volume flow rate through a pump running at a fixed operating conditions. Find the following statistical quantitie for this data set: a. The average flow rate: Vave liters/hr. b. The median flow rate: Vmedian liters/hr. c. The sample standard deviation: 0, liters/hr.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Given the following Atmospheric Data: Altitude (m) Pressure (kPa)0 - 101.331000 - 89.872000 - 79.503000 - 70.114000 - 61.66 Use linear interpolation to estimate the atmospheric pressure at: Altitude (m) Pressure (kPa)4MM ?2689 ?3500 ? (where MM is your birth month, so if you were born in December, evaluate at 312 meters)
Please solve this question
4. It is determined that an experimental data taken for T as a function of time, is a first order system, following the trend line of y = yoe. The data taken for various times is shown in table below. Approximate the time constant for this experiment. Show your work. T 0.00 0.50 3.00 5.00 5.50 6.00 6.50 7.00 7.50 11.00 14.00 17.00 22.00 25.00 Y 23.00 22.43 20.13 18.81 18.54 18.29 18.05 17.84 17.63 16.57 16.01 15.64 15.31 15.20
Pls help me with the VSR
760 ۱۲:۳۱ Note: Answer All The Questions. Moody Chart is allowable. 01) Select the most suitable complement among listed options for the 10 items: 1) Real fluids (a) are viscous (b) possess surface tension (c) are compressible (d) possess all the above properties (e) possess none of the above properties. 2) In a static fluid (a) resistance to shear stress. small (b) fluid pressure is zero (c) linear deformation is small (e) viscosity is nil. (d) only normal stresses can exist 3) When the flow parameters at any given instant remain same at every point, then flow is said to be (d) uniform (e) Static. (a) Turbulent (b) Steady state (c) laminar 4) The increase of temperature results in (a) increase in viscosity of gas viscosity of gas (b) increase in viscosity of liquid (c)decrease (e) (a) and (d) above. d (d) decrease in viscosity of liquid 5) Consider the flow in pipe in figure. If P₁ -AP/y. b) The flow direction is from 2 to 1 if AZ <-AP/y. c) The flow is zero if AZ=-AP/y. d) The flow…
For the given data generate the forecast for each of the time period using moving average for n=3 periods and weighted moving average for n=D4, also find the forecast for the 9th 10th and 11th. S.NO DEMANDS MOVING AVERAGE n=3 WEIGHTED MOVING AVERAGE n=4 1 100 2 120 3 110 4 130 110 140 120 119 160 126.67 129 7 150 143.33 143 8 140 150 148 9. 150 147
I want the value of Cd from the graph and Results & Discussion for this ASAP
Pressure distribution measurements are made on a two-dimensional wing model placed in a wind tunnel. The difference between the static pressure sockets on the surface and the static pressure of the free stream is measured. 30 data is taken at each measurement point. The average of the values measured from one of the sockets near the trailing edge was calculated as 2.30 Pa, and the standard deviation was calculated as 2.65 Pa. After applying the Chauvenet criterion to these measurement values, it was decided to eliminate 3 measurements and the new mean value was found to be 2.18 Pa and the standard deviation was 2.42. It was verified that the unexcluded data fit the normal distribution curve. Data above how many Pa and below how many Pa were eliminated? Estimate how many data have negative value (?<0) after elimination.
i need the answer quickly
1. To determine the dynamic viscosity of a liquid you take repeated measurements of the liquid density and kinematic viscosity. These data are summarized in the following table: Avg. measurement Total Uncertainty P 999 kg/m³ ±0.5% V 1.23 mm²/s ±0.01 mm²/s kg Ns What is the dynamic viscosity? Give dynamic viscosity in units of; which is the same as ms 2. Determine the absolute and relative uncertainties in the dynamic viscosity.
1 The following observations are recorded during a test on a four-stroke petro engine, F.C = 25cc of fuel in 10 sec, speed of the engine is 2600 rpm, B.P = 22 kW, Qair 0.00134 m, piston diameter 90 mm, density of the fuel = 0.85gm/cc , compression ratio = 7.5, CV of fuel = 42000KJ/Kg, room temperature = 24 °C %3D = 140mm, stroke length = %3D %3D %3D 2 A six-cylinder 4-stroke cycle petrol engine is to be designed to develop 250 kW of (b.p) at 2200 rpm the stroke / bore ratio is to be 1.3:1. Assuming nm =80% and an indicated mean effective pressure of 9.5 bar, determine the required bore and stroke. If the compression ratio of the engine is to be 7.5 to 1, determine consumption of petrol in kg/h and in kg/bp.hr. Take the ratio of the indicated thermal efficiency of the engine to that of the constant volume air standard cycle as 0.65 and the calorific value of the petrol as; 44770KJ/kg.
Q: Experiment of venturi meter. Please give a brief description for Bernoulli’s equation. What typeof parameters can be derived from an experiment?