1m° of saturated liquid water at 200°C is expanded until its quality is 80 percent and the pressure is equalto 600 kPa. Determine the following:The initial pressure (P1 (kPa)) is equal to:The initial specific volume (v1(m³/kg)) is equal to:The final specific volume (v2(m/kg))) is equal to:The final temperature (°C) is equal toThe water mass (m (kg)) is equal to:The total work produced by this expansion, in MJ is equal to:Activate

Answered: Image /qna-images/answer/5feb737b-5f3d-4543-9530-237e1571ad69.jpg

1m of saturated liquid water at 200°C is expanded until its quality is 80 percent and the pressure is equal to 600 kPa. Determine the following: The initial pressure (P1 (kPa)) is equal to: The initial specific volume (v,(m³/kg)) is equal to: The final specific volume (v2(m³/kg)) is equal to: The final temperature (°C) is equal to The water mass (m (kg)) is equal to: The total work produced by this expansion, in MJ is equal to:

1m of saturated liquid water at 200°C is expanded until its quality is 80 percent and the pressure is equal to 600 kPa. Determine the following: The initial pressure (P1 (kPa)) is equal to: The initial specific volume (v,(m³/kg)) is equal to: The final specific volume (v2(m³/kg)) is equal to: The final temperature (°C) is equal to The water mass (m (kg)) is equal to: The total work produced by this expansion, in MJ is equal to:

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A tank of air is expanded via heat transfer at a constant pressure such that its volume is 2.5 times its original volume. If the initial temperature of the tank was 23 Celsius, what is the amount of heat transfer required for this process in kJ/kg? Calculate this with the following 3 approaches: Constant Specific Heats (use the average temp) The equation as seen on table A-2 Air property tables
In a piston cylinder assembly, air is compressed slowly from an initial state of 1.3 bars and 500 cc to a state where the volume is 90 cc. If the process is isothermal, determine the final pressure in kPa. 722 а. с. 895 b. 814 d. 1210
One third of a kilogram of a gas contained within a piston-cylinder undergoes a process at constant pressure at 400 kPa. The initial specific volume is 0.72 m^3/kg. The work for the gas in the system is -100 kJ/kg. Determine the final volume of the gas in m^3
A mass of 10 g of oxygen fill a weighted piston-cylinder device at 20 kPa and 94.0°C. The device is now cooled until the temperature is 0°C. Determine the change of the volume of the device during this cooling. The gas constant of oxygen is R = 0.2598 kPa.m³/kg-K. (Round the final answer to three decimal places.) The change of volume is m³.
10
1-109E Consider a U-tube whose arms are open to the atmosphere. Now equal volumes of water and light oil (p 49.3 lbm/ft') are poured from different arms. A person blows from the oil side of the U-tube until the contact surface of the two fluids moves to the bottom of the U-tube, and thus the liquid levels in the two arms are the same. If the fluid height in each arm is 30 in, determine the gage pressure the person exerts on the oil by blowing. -Air Oil Water 30 in FIGURE P1-109E
A machinist wishes to insert a brass rod with a diameter of 3 mm into a hole with a diameter of 2.998 mm. By how much would the machinist have to lower the temperature (in °C) of the rod to make it fit the hole?
A cold drink initially at 40°F warms up to 44°F in 3 min while sitting in a room of temperature 70°F. How warm will the drink be if left out for 30 min? If the drink is left out for 30 min, it will be about (Round to the nearest tenth as needed.) °F.
The barometer of a mountain hiker reads 729.66 mbars at the beginning of a hiking trip and 644.42 mbars at the end. Neglecting the effect of altitude on local gravitational acceleration, determine the vertical distance (meters) climbed. Assume an average air density of 1.20 kg/m3. (Use 2 decimal places for the final answer.)
A gas compressed according to the law PV1.5 = constant from the initial pressure and temperature of 105 kN/m? and 26 °C respectively to a pressure of 900 kN/m² .The gas is then cooled at constant pressure, then the gas was expanded isothermally to the initial conditions. Take y= 1.5.
Oxygen (molar mass 32 kg/kmol ) expands reversibly in a cylinder behind a piston at a constant pressure of 3.102 bar. The volume initially is 0.0119 m and finally is 0.0327 m; the initial temperature is 18.24 °C. Calculate the heat supplied during the expansion in the correct unit to two decimal places. Assume oxygen to be a perfect gas and take the specific heat at constant pressure as = 0.917 kJ/kg Kand molar gas constant as = 8,314 J/ kmol K