19. The OTA in Figure 14-58 functions as an amplitude modulation circuit. Determine the output voltage waveform for the given input waveforms assuming K = 16 µS/μA.

Q: A 16 km long transmission line consists of a pair of conductors and in diameter spaced 2 Find the…

A: Note: Line inductance depends on Conductor size (radius) Conductor Diameter  Total length of…

Q: 2. How the characteristics of the voltage follower (i.e., the high input and low output impedance)…

A: Voltage follower circuit A voltage follower circuit has a high value of input impedance and a…

Q: Two impedance coils which have resistance of 2.6 and 3.7 ohms take 5 & 10 amp respectively from…

A:

Q: R(s) + E(s) K G(s) Figure 1 Unity Feedback system with gain, K. C(s)

A: We need to find out controller gain and stability analysis for given system .

Q: The transfer function of a linear time invariant system is given as 2 Z-¹ H[2] = (1-0.5 Z-²) The…

A: Given data, Transfer function is given as, Hz=2z-11-0.5z-2. Input is given xn=un

Q: Example 4: The speed of a 50Hp series motor working on 500V supply is 750RPM at full load and 90%…

A: Solution:

Q: (a) A television receiver's folded dipole antenna has an impedance of 600 0. If a RG-6 coaxial (75…

A: Since user has asked for the solution of Question:3 (a). Hence , we will provide the solution only…

Q: 1 Construct a table similar to Table 16.2 for a 4-bit A/D converter if Va = 5 V with a reference…

A: Given, 4-bit ADC is We need to design the successive approximation table for the input analog value…

Q: ) Consider the following electrical system with the applied voltage Vi as the input and Vo as the…

A: Note: Kirchoff's Law (KCL and KVL) and Ohm's law is very important to analyze electrical circuits.…

Q: Find the attenuation constant for the medium whose properties are given below. 01) 0,616 02) 9,105…

A:

Q: b) We calculate when I will reach the maximum value of the controlled variable (CV) (hint: the first…

A: given: T.F =2(s+1)(2s+1) Kc=5 The steady-state control variable, limt→∞x(t)=lim s→0s·X(s) The…

Q: 1.Draw the constructional view of Synchronous Machine 2. List and explain the constructional…

A: Synchronous Machine  Synchronous machines are made up of both synchronous motors and synchronous…

Q: 5. For the Hartley oscillator shown in the below figure, assume r →∞ and gm = 20 mA/V. Design the…

A:

Q: (b) Monophonic music with input voltage of ±10V is sampled at 40 kHz, uniformly quantized and…

A: Given:  Am=±10 Volts, fs=40 kHz, uniformly quantized and encoded.Signal is modulated using QPSK…

Q: A 0.33 µF capacitor is charged to 150 VDC. It is then connected to another capacitor of capacitance…

A: Given data, Capacitances are given, C1=0.33 μF, C2=4C1=4×0.33=1.32 μF. Voltage on capacitor V1=50 V,…

Q: 1. A complex number is given by z = (1+j)(-1+2j). a. Find [z]. b. Find zz. c. Find Re[z]. d. Find…

A: Given: A complex number is given by, z=1+j-1+2j

Q: Aif we have pil3, 30, 45) find the point pin Cartesian and Cylindrical systes.

A:

Q: Define each of the following terms by giving an example for each term: Static sensitivity Error…

A:

Q: 3) A 555 timer is connected in the stable mode as shown in the figure below. Determine the frequency…

A: Given data A 555 timer is shown in the figure which is in stable mode.  We need to find the…

Q: Question 4 (a) A negative feedback DC motor speed controller is required to maintain a speed of 1000…

A: Solution of question (a): Given information about a feedback DC motor speed controller is written…

Q: G₁=2; G₂-7: G₂-6; G₁-3; G₁-2; G6-3; G7-6; Gg-5: H₁-0.7: H₂-0.1; H₂=0.3; H₂=0.5; !!! Not: Her bir…

A:

Q: L. Find the Laplace transfer function of the circuit. Then Identify the gain and the time constant…

A: By voltage divider rule: Vout= [Vin*(1/SC)]/[R+1/SC] Therefore Vout/Vin= 1/(SRC+1)

Q: Evaluate the controllability and observability of the following systems by making appropriate…

A:

Q: 3. The output of a shunt generator is 66A at 593 V. armature and field resistances are 0.05930 and…

A:

Q: 5. The clock frequency in the switched-capacitor circuit in the below figure is 100 kHz. Find the…

A: Consider that the clock frequency of the switched-capacitor circuit is 100 kHz.

Q: Type of sensor used to detect both metallic and non-metallic: Inductive sensor Capacitive sensor…

A: A device that measures or detects a physical attribute and records, indicates, or reacts to it in…

Q: ГО 1 Го О 0 1 x + 1 −1] 0| = x (q Lo 2 u ; y = [1 0 1]

A:

Q: Use superposition to find Le in the circuit of Figure 2. ΤΟΥ 2 Ω ww 2 Α ΓΕ 1 1Ω 0.5V. Μ

A: In this question We need to determine the value of output voltage Vo  using the super position…

Q: 3. A band-reject filter may be designed by combining a low-pass filter and high-pass filter with a…

A: Consider all the given values.

Q: The LTI system is designed into series and parallel circuit as illustrated in Figure 1. The circuit…

A:

Q: For 50 Hz system the maximum speed of a synchronous generator can be

A: Given data, Frequency f = 50 Hz. For maximum speed number of poles P = 2.

Q: Let m(t) is sinusoidal Wave form mct) = Am cos Wmt Determine The frequency Spectrum modulation…

A:

Q: 16 ImA 1002 ↑ +1 85022 loks find V₁ voltage 8505 whil 2500

A: The given problem is from operational amplifier. The detailed solution is given in the next step

Q: Q.4 In BJT transistor V. BE 0.7 V and V₁ = 25 mV and reverse saturation current is mA V 10-13 A.…

A: Given- A BJT transistor- Voltage VBE=0.7 V, VT=25 mV, Reverse saturation current- Is=10-13 A, To…

Q: 1) A monostable multivibrator is shown in the figure below. The parameters are: Rx = 5k2, Cx = 0.01…

A: Monostable multivibrator A monostable multivibrator, as the name implies, has only one stable state.…

Q: The value of Z

A:

Q: (c) A carrier signal with 2.8 V at 400 kHz is amplitude modulated with a sinusoidal signal.…

A: Since user has asked for question 3 (C). Hence we will solve only this question. According to the…

Q: A battery with an emf of 13.7 V has a terminal voltage of 13.3 V when the current is 2.46 A. HINT…

A: Given data, A battery is having, EMF E=13.7 V. Terminal voltage V=13.3 V. Current I=2.46 A.

Q: 2. A single phase full wave ac voltage controller supplies an RL load. The input supply voltage is…

A: Given: A single phase full wave ac voltage controller supplies an RL load. The input supply voltage…

Q: a) In Figure 4.1, determine (i) the total resistance RT, the supply current IS and the voltage VS…

A: here we have to find the total resistance and supply current and voltage Vs .

Q: 14. A certain OTA has an input voltage of 10 mV and an output current of 10 μA. What is the…

A: The transconductance of an operational transconductance amplifier is the ratio of output current to…

Q: 24 V a. 0.124V b. 0.160V C. -4 V d. 4V e. 0.326V 652 16 fe 1202 40 Ω Find the value of voltage (v)…

A: At t=0-  the switch is closed so the circuit will become as : Since the capacitor is connected to…

Q: For the following system represented in state space, find out how many poles are in the left half-…

A: it is asked to find how many poles are in left half plane, right half plane, on the jw-axis of the…

Q: Consider the voltage drop in a short line (1 indicates the sending end, 2 the receiving end of the…

A: Given: ∆V=V1-V2 Rl - Resistance across the line Xl - Inductance across the line Ptr - Active power…

Q: Describe the voltage across and the current through the inductor combination in both charging and…

A: Given: the circuit diagram consists dc source, resistor, and capacitor I) when the source is…

Q: The capacitance of the capacitor formed by two parallel plates, each 100 cm in area separated by a…

A: Capacitor Capacitors, along with resistors and inductors, are one of three fundamental electronic…

Q: 7. Calculation questions: The nameplate data of a separately excited DC motor is PN-5.5kW, UN-110V,…

A: Note: DC Machine Losses include Cu Loss  (shunt, series, armature coil loss) Mechanical loss…

Q: For the circuit shown in below figure, find v and the power absorbed by the resistor? 15 mA a. 90 V…

A: Given data, Circuit diagram is given by,

Q: A few measurements on the below circuit produces the labeled voltages (indicated in blue colors.…

A: The circuit can be draw as

Q: 5- If x(z) = 2-2 (2-z-²) find: (a) [x(n) + x(n − 2)]x(n) - (b)x(n-2) + 8(n − 4)

A: Given: Z-transform of a function x(n),  X(z)=z-22-z-2, To find: a)[x(n)+x(n-2)] x(n) , b)…

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.