19 10 cm Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The inner cylinder was forced to move a distance X yielding a new capacitance of 5 pF. Hence, the distance moved is approximately found to be C 2n Eo mm Eo = 8.85 x 10-12 F.m-1 3.75cm 6.25cm 2.5cm None of the choices D:4

19 10 cm Consider a cylindrical transducer making a capacitance of 8 pF, as shown in the figure next. The inner cylinder was forced to move a distance X yielding a new capacitance of 5 pF. Hence, the distance moved is approximately found to be C 2n Eo mm Eo = 8.85 x 10-12 F.m-1 3.75cm 6.25cm 2.5cm None of the choices D:4

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
A step up dc/dc converter has input voltage Vs = 9 V, the average output voltage Va = 15 average load current la = 0.8 A. The switching frequency is f = 20 kHz, inductance is L = 0.3 mH and the parallel capacitance is C = 0.44 mF. Which one is the ripple current of inductor, Al ?
1)The value of the capacitance reactive power in VAR is? /2) The value of the capacitor in micro farad is?
A resistor of 20ohms and a capacitance of unknown value when connected. In in parallel across a 100V, 50Hz supply take a current of 6A. The combination is now connected across a 100V supply of unknown frequency and the current falls to 5.5A . What is the frequency?
QUESTION 4 A 1kO resistor, a 5mH ideal inductor, and a 1nF capacitor are connected in parallel. Find the total impedance if a 12kHz voltage is applied across the circuit. O 1.26KNL79.9° O 1.890412.4° O 1.61KOL-74.4° O 3620268.8
Question 4 A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must be no less than 50% of the average. The output voltage ripple must be less than 1%. The switching frequency is 30kHz. Determine the duty ratio, minimum inductor value, and minimum capacitor value. Verify your answers using Matlab, show the inductor current is continues and its minimum is no less than 50% of its average. Furthermore, the output voltage ripple is less than 1%.
Answer the following with illustration and solution. 1.) A circuit consisting of a resistor of 5kohms in series with a capacitor of 10 nanofarad is connected across a 16v sinusoidal supply. Calculate the output voltage at a frequency of 60Hz and again at frequency of 120Hz. This is the example/guide that might help.
C5 What is the correct explanation for the voltage seen at Va in Figure C5? Va 1 Sost We will assume that the Vout Out Vb, capacitor is charged to a value determined by the feedback and the supply voltage +BVsat. Figure C5 A. The waveform on the capacitor looks like a discharge, and then a charging waveform to an equal but opposite magnitude voltage, B. The capacitor simply reverses its charge, with a charging waveform, C. The capacitor simply reverses its charge, with a discharging waveform, D. None of the above.
b) Derive a block diagram model for the RLC series circuit shown in Figure Q1, relating input voltage Vin to output voltage Vout derived across the inductor. Your answer should identify the state variables, list the governing equations, and clearly show the direction of flow of signals in the block diagram. R + Vin(~ C Figure Q1 0.000 Vout
Which of the following is true for pure capacitive circuit? O a. Current lags the voltage by 90 degree O b. Voltage lags the current by 90 degree O c. Voltage leads the current by 90 degree O d. Voltage and current are inphase
Find the current that flow through capacitor Ic IR Ic Vs = 20V425° f = 30KHZ R = 1000 C = 100nF (1)125. 65mAZ135° (2)251. 32mAZ120° (3)376. 9mAZ115° (4)628.31MA2110°