17-35. The sports car has a mass of 1.5 Mg and a center of mass at G. Determine the shortest time it takes for it to reach a speed of 80 km/h, starting from rest, if the engine only drives the rear wheels, whereas the front wheels are free rolling. The coefficient of static friction between the wheels and the road is u, = 0.2. Neglect the mass of the wheels for the calculation. If driving power could be supplied to all four wheels, what would be the shortest time for the car to reach a speed of 80 km/h? G 0.35 m A -1.25 m-- -0.75 m

Q: The box is at rest at point I when it is sliding down the incline. If the coefficient of kinetic…

A:

Q: The 28-kg wheel is rolling under the constant moment of M = 84 N.m. The wheel has radius r = 0.53 m,…

A:

Q: Under the man's pushing force P = 37.3 lb, the uniform cabinet is sliding on the ground with a…

A:

Q: Determine the largest acceleration of the truck so that the safe will not slip or tip on the truck…

A:

Q: he 10 N cylinder moves in a friction tube. Spring constants are k1 = 150 N / m and k2 = 200 N / m.…

A: Given: k1 = 150 N/m k2 = 200 N/m w = 10 N v = 9.825 m/s

Q: ent roll no is A20 then X=2

A: M = Mass of central load = 18 kg m = mass of ball = 2kg F = Friction = 14 N h = height of governor…

Q: The block has a mass of 151 kg and rests on a surface for which the coefficients of static and…

A: Given:-m=151 kgμs=0.5μk=0.4F=(60t2) Nt= 5sTo find:-Power developed, P

Q: The car has a mass of 1.50 Mg and a mass center at G. Power is supplied only to the rear wheels.…

A:

Q: The spool has a mass of 150 kg and a radius of gyration of Kc = 240 mm about its centre of mass G.…

A:

Q: The racing car has a mass of 690 kg and a center of mass at G. If there no slip, determine the value…

A:

Q: The spring-mounted 0.97-kg collar A oscillates along the horizontal rod, which is rotating at the…

A:

Q: The 50-kg uniform pole is on the verge of slipping at A when?=45°. Determine the coefficient of…

A: This question is based on the concept of friction.

Q: e necessary static frictional force between the wheel andomized. Your answer must include 2 places…

A:

Q: 0.7 m 0.4 m 0.75 m 0.5 m The lift truck has a mass of 60 kg and mass center at G. The lift truck…

A:

Q: The system is released from rest with the cable taut, and the homogeneous cylinder does not slip on…

A: Given:The mass of the cylinder is: The radius of the cylinder is: The angle of the slope is: The…

Q: 02 A small object A is held against the vertical side of the rotating cylinderical container of…

A: To determine the monimum rotational rate of the container which will keep the object from slipping…

Q: The 18-Mg truck hauls the 38-Mg trailer. If the unit starts from rest on a level road with a…

A: Mass of truck, mTruck=18 Mg=18000 kgMass of Trailer, mTrailer=38 Mg=38000 kgTractive force between…

Q: With the block initially moving up the inclined, the acceleration is:

A:

Q: The 88-kg man with center of mass G supports the 36-kg drum as shown. Find the greatest distance x…

A:

Q: The 13-kg wheel is rolling under the constant moment of M= 89 N-m. The wheel has radius r= 0.47 m,…

A: Gg

Q: The 43-kg man with center of mass G supports the 31-kg drum as shown. Find the greatest distance x…

A:

Q: The 13-Mg truck hauls the 27-Mg trailer. If the unit starts from rest on a level road with a…

A: Answer: (a) The tension in the horizontal  bar 16.875 kN. (b) The acceleration of the rig is 0.625…

Q: The 5-kg cylinder is initially at rest when it is placed in contact with the wall B and the rotor at…

A: Given Mass of the cylinder = 5 kg Angular velocity = 6 rad/s Coefficient of the friction = 0.2 To…

Q: A brake mechanism is used to lower body A with a constant velocity of 3.0 m/s. The coefficient of…

A: Given:To find:(a) Mass of body A.(b) Power dissipated by the brake.

Q: The man pushes on the roller with force P through a handle that connects to the central axle of the…

A:

Q: Figure Part A t = Submit Part B Determine the shortest time it takes for it to reach a speed of 85…

A: Mass of the car m = 1.7 Mg = 1.7×106 g= 1700 kg Initial and final velocity, u = 0 V = 85 km/hr =…

Q: Determine the distance s to which the 53-kg painter can climb without causing the 3.5-m ladder to…

A: Draw the free-body diagram.

Q: The horizontal force P = 90 N is applied to the upper block with the system initially stationary.…

A: Write the given information.

Q: A cylinder is rolling down a plane which has the angle theta with the horisontal. The cylinder…

A: Rolling Motion : it is a combination of translation motion and rotation motion. if we consider a…

Q: The sports car is traveling along a 25∘ banked road, circular with a radius of r = 400 ft If the…

A:

Q: Problem 3: As shown block B drops 4m from rest before striking the ground. The pulley is mounted on…

A:

Q: Under the man's pushing force P = 37.3 lb, the uniform cabinet is sliding on the ground with a…

A:

Q: Under the man's pushing force P = 37.3 lb, the uniform cabinet is sliding on the ground with a…

A: Find the acceleration of the cabinet .

Q: A 15-kg uniform disk is placed in contact with the ground and a constant couple moment M = 32 N.m is…

A:

Q: The uniform cylinder has a mass of 30.0kg and is  rotating about a horizontal axis through O at 1200…

A: Given data: mass of the cylinder M = 30 kg Rotational speed of the cylinder N = 1200 rpm Coefficient…

Q: A package of mass m is placed inside a drum that rotates in the verticalplane at the constant…

A:

Q: The coil has a mass of 90 kg and a rotating radius of 0.3 m. If the static and kinetic friction…

A:

Q: F. 30° 4 -2 pies-- 1.5 pies 1.5 pies 1.5 pies 1.5 pies Each box in the stack of four boxes weighs 3…

A: Weight of box = 3 lb Weight of the dolly = 38 lb μs = 0.5   To find out:- Maximum force F that the…

Q: The 66-kg man with center of mass G supports the 33-kg drum as shown. Find the greatest distancex at…

A: Given that ,  Mass of man m=66kg Mass of drummd=33kgStatic frictionμs=0.45

Conservation of Energy

In physics, the rule of the conservation of energy states that energy doesn’t disappear from the atmosphere; instead, it changes its form from one type to another. Energy is one of the most important physical quantities in nature, and it cannot be created or destroyed — only transformed.