16. Fig. 2.49 shows a glass funnel fitted to a U-type manometer. The manometer reading is 0.25 m when the funnel is empty. What is the manometer reading when the funnel is completely filled with water? [Ans. 0.4 m] Im diat Water (S= 1) Mercury – (S = 13.6) Fig. 2.49 0.25m

16. Fig. 2.49 shows a glass funnel fitted to a U-type manometer. The manometer reading is 0.25 m when the funnel is empty. What is the manometer reading when the funnel is completely filled with water? [Ans. 0.4 m] Im diat Water (S= 1) Mercury – (S = 13.6) Fig. 2.49 0.25m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Find the differential mercury manometer gauge reading shown in the given figure if the pressure…

Q: Calibration: 11.69 kg 15.47 kg 3.78 kg = 28° 1. Mass of the measure plus plate, kg (Mm+p) %3D 2.…

A: Percentage absorption of the aggregates is the absorption calculated at saturated surface dry…

Q: A siphon tube is useful for removing liquid from a tank. The silphon tube is first filed with…

A: Let us assume that surface of the water is at position B and the exit of the hose is at position C.…

Q: The following observations were made to determine the sensitivity of two bubble tubes. Determine…

Q: To what height mercury rises in the U-tube in the figure below? Elev 6 m Elev 5 m Air pressure-30 k…

A: To find value of h

Q: For the shown inverted manometer, all fluids are at 20°C. If P - P = 97 kPa, what must the height X…

A: Using concept of Pressure in left limb of manometer = pressure in right limb solution = 1.31m

Q: A clean circular glass tube is to be selected in the design of a manometer to measure the pressure…

A: Given data Specific gravity Surface tension Cappilary rise Angle of contact is zero for glass and…

Q: HYDROSTATIC FORCE ON PLANE SURFACES I need help analyzing my experiment. For a Fully Submerged…

A: Data given

Q: Ex.1 Ans. A glass tube 0.25 mm in diameter contains a mercury column with water above the mercury.…

Q: An orifice meter was calibrated by the manufacturer for air at 25℃ and 1atm. It is installed in an…

A: ∆P = 4.8″H2O (inches of water) Temperature during operation = 33℃ Pressure during operation = 0.9atm

Q: A tank is fitted with a manometer on the side, as shown. The liquid in the bottom of the tank and in…

Q: s in oil (op.gr.=o.82) e water sarface

A: Given data- Specific gravity (SG) = 0.82 Head at point A = 2m Difference between level of tubes (x)…

Q: Figure 1 shows the manometer apparatus with different fluids. mercury and oil are 13.56, and 0.9…

A: Given data in question Specific gravity Depth Area ratio Volume x = Volume y To find out Delta Z…

Q: The velocity of a particle traveling along a straight line is v = (8t2 - 9t) ft/min, where t is in…

Q: 5) Determine the value of y in the manometer shown in the figure. 1m Alr, 5 KPa Oil S- 0.8 3 m 1 m…

A: Given data in question Pressure of air Depth Specific gravity To find out Value of Y Note Density…

Q: A 3mm Ø tube is inserted in water. Assuming a clean tube and the angle of contact with water is 0°,…

A: Given, Tube diameter (d) = 3 mm or 0.003 m

Q: 3.64 For the manometer shown in Fig. 3.28, calculate (PA - PB). 33 in 8 in 12 in BOY Oil (sg = 0.85)…

Q: In a given setup, distilled water flows towards the inside and goes outside of the vessel as shown…

A: Velocity of inflow through pipe 1, V1=30ftsecdiameter of pipe, d1 =3in =312ft =0.25ftOutflow rate…

Q: The velocity through the throat of a venturi meter is four times that of the velocity through a pipe…

Q: A mercury Manometer is attached to a pipe having suction pressure. The right limb is open to the…

A: Right limb which is open to atmosphere as per given data : For equilibrium condition a) Difference…

Q: nere are two (2) mercury barometers at the mountain. At the top reads 500 mm and at the base reads…

A: To find the height of the mountain (H)-

Q: C.6 (a) A manometer shown in Fig. C.6a is used to measure the pressure difference between two points…

Q: A U-tube manometer is arranged, as shown in Fig. 2.15, to measure the pressure difference between…

A: The objective of the question is to calculate the pressure difference between two points in a…

Q: Q.1 (50%): Determine the pressure difference between points A and B in Fig. below. Kerosene…

Q: 7. A simple U-tube manometer can measure negative gauge pressures.

A: A simple U-tube manometer can measure negative gauge pressures. This is true statement

Q: What is the gage pressure at A? in

A: To find pressure at point A

Q: 9. For dynamic fluid motion in a pipe, the pressure measurement cannot be carried out accurately by…

Q: s immersed Lermine the height of the capillary rise of water Given at 20°C unit weight of water

Question

16. Fig. 2.49 shows a glass funnel fitted to a U-type
manometer. The manometer reading is 0.25 m
when the funnel is empty. What is the manometer
reading when the funnel is completely filled with
water?
[Ans. 0.4 m]
Im dia
Water
(S= 1)
Mercury
+ (S= 13.6)
Fig. 2.49
40.25m

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

225 mm P1=8 P2=10 MJ=15 q1=18 -9 2(m) 1(m) 4.50(m) 1.50(m) 225mm 66 6
13 PLEASE PROVIDE COMPLETE AND DETAILED SOLUTION
Liquids A, B and C, in the containers shown, have SG of 0.60, 1.00 and 1.60 respectively. At what elevation (EL. C) will the liquid C stand in each of the piezometer tubes? Round your answer to the nearest hundredths. Pair = 12.5 kPa EL. 8 A (SG =) EL. 6 B (SG =_) %3D EL. 2 C (SG = EL. 0
The surface tension of mercury at 60°C is 0.47N/m. What capillary height in mm will occur in this fluid whe in contact with a glass tube of radius 0.3mm? Use 130° for mercury. O 11.5mm fall O 11.5mm rise O 15.1mm fall O 15.1mm rise
Question 3: A lab test was used to identify the headloss coefficient of a confusor k'e where: h = kE' ,V² -V₂² 2g that is shown in the figure. Two pizometers were installed at A1 and A2, which measured piezometric head of 40 cm and 44 cm, respectively. The diameters are 5 cm, and 10 cm at A1 and A2 respectively Flow was measured as 0.02 m³/s. Find kE' V₁- A1 a A2 -V₂
a 150 mm by 50mm venturi meter is installed in an inclined pipe carrying oil. the venturi distance between the inlet and throat is 20cm. the flo is upward through the meter. a differential manometer containing mercury the (sp. gr=13.6) is attached to the inlet base and throat. compute the deflection of the mercury if the actual discharge of pipe is 0.55 m³/s. assume the venturi coefficient to be 0.97.
please include figure
A manometer is attached to a tank containing three different fluids. Find the value of y in the mercury column in the manometer