16. An impedance of 100 Q resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 Q if w= 10 rad/sec. Calculate the values of inductor and capacitor. a. 1µF & 2mH b. 5µF & 1mH c. 7µF & 3mH d. 0.04µF & 2mH

Q: After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience…

A: Given: After reduction, the current carrying capacity of a conductor is referred to as the ___.

Q: How does IoT fit into the concept of the "smart grid" in energy distribution

A: We need to explain How  IoT fit into the concept of the smart grid in energy distribution.

Q: Explain with neat diagram of any one solar energy thermal application.

A: SOLAR WATER HEATERS:- The Solar water heaters are comparatively easy application of solar thermal…

Q: Make three plots using Excel: 1. Voltage vs current for the linear resistor data (voltage on…

A: Fill all the data points given in the data in Excel file Then Click on charts Select Scatter plot…

Q: In the figure, the ideal batteries have emfs ℰ1 = 25.0 V and ℰ2 = 0.500ℰ1, and the resistances are…

A: Given circuit is - Given values are -

Q: Describe in-depth the different types of power outlets located in the operative environment and the…

A: Different types of power outlets for use in the home are  (1) 15A, 120V outlets It can be used for…

Q: 3List out common electrical hazards and give risk level for each of them

A: 1. discharge of current through insulating materials: If the appliance is not connected through an…

Q: where is the value of 10/sqrt(2) coming from?

A:

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: in this Lab you will be laying out and installing an emergency service panel. Emergency service…

A: (1)  Legally Required standby systems provide electric power to selected loads during firefighting…

Q: In reality, wires do not have zero resistance. Where does the resistance of wires come from, and…

A: We need to answer the following two questions: In reality, wires do not have zero resistance. Where…

Q: How Rth connected with the load resistance, explain

A: RL will be  connected in series with  RTH  as shown in the example.

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.