16 - The static and stagnation pressures of the fluid passing through a pipe are measured using a piezometer and a Pitot tube. Fluid heights in the piezometer and Pitot tube were read as 2 m and 2.2 m, respectively. If the density of the fluid is 1000 kg/m³, what is its velocity?    a) 1.98 m/s  B) 1.43 m/s   NS) 0.92 m/s   D) 1.65 m/s   TO) 2.39 m/s

Q: 1) Pitot tube can be used to measure the flow velocity. The equation can be derived from Bernoulli…

A:

Q: express atmospheric pressure (101325 Pa) in units of a) Hydraulic head b) J/K

A:

Q: 1) For a flow in a circle pipe, the Reynolds number is determined to be 1800. This flow is:  a)…

A: GIVEN- Reynold number=1800 to check- it is transitional flow   turbulent flow…

Q: tarting at rest, a hydroplane accelerates at a = 0.8t for the first 10 seconds and then accelerates…

A: Given:The acceleration is The acceleration after  is

Q: A) Perform an analysis of the stenosed artery (diameter D and length L)using the Bernoulli equation…

A: (A) Draw the diagram of stenosed artery which is narrowed by atherosclerosis. Here section 1 is…

Q: A beam 8 m span is freely supported at its ends and a udl of 40 KN/m is spread over the whole span…

A: The schematic diagram of the beam is as follows: The free body diagram of the beam is as follows:

Q: A boy throws a stone vertically upward from a bridge, which is 20 m above the surface water. The…

A:

Q: Please help to correctly solve all parts.

A: Step 1:Matching each case with the appropriate flow meter:1. Gasoline flow in a gas station: Rotary…

Q: A cylindrical container is filled with a liquid until it reaches a height of one meter with respect…

A:

Q: A piece of wood weighing 160 lb is pushed from the top of a plane slide which is 50 feet long and…

A: Given: W - 160 lb L = 50 ft μ=0.5 u - 8 ft/sec R - 8 lb To find: Velocity of wood after 1.5 seconds…

Q: Perform the following unit conversions. a) ΔT = 85°C to Kelvin, Fahrenheit and Rankine b) ΔT…

A: Given Data a) Temprature in 'C= 85'C                   b) Temprature in 'R = 150'R   We have to do…

Q: The coefficient of performance (COP) for a refrigerator is the rate of heat flowing into the…

A: The coefficient of performance (COP) of a refrigerator is a dimensionless number, and it is known as…

Q: The test setup shown in the figure measures the pressure difference between the inlet and outlet of…

A:

Q: An incompressible fluid flows through a pipe that has two sections: a wide section with a diameter…

A: Introduction In fluid dynamics, an incompressible flow is a flow in which the density is constant…

Q: 8:02 LTE1.ll 2% Assignment Details Fluid Mechanics - Alejandro R. MANDERICO Oil S = 0.842 Water ha…

A:

Q: A liquid drug, with viscosity and density of water, is to be administered through a hypodermic…

A:

Fluid Dynamics

The study of the flow of gases and liquids, usually in and around solid surfaces, is known as fluid dynamics in physics and engineering. Fluid dynamics, for example, can be used to evaluate the movement of air through an airplane wing or the surface of a vehicle. It can also be used in ship design to increase the speed at which ships pass through water.