15.i. Consider a coil whose resistance, 42 and inductance, 13.5mH is connected across 210V, 60HZ AC supply. The inductive reactance is calculated as a. 4.24H b. 4.242 c. 5.082 d. 5.08H 15.ii. The power factor of the circuit is calculated as, a. 0.618 b. 0.786 c. 0.845 d. 0.547

15.i. Consider a coil whose resistance, 42 and inductance, 13.5mH is connected across 210V, 60HZ AC supply. The inductive reactance is calculated as a. 4.24H b. 4.242 c. 5.082 d. 5.08H 15.ii. The power factor of the circuit is calculated as, a. 0.618 b. 0.786 c. 0.845 d. 0.547

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: derive the RMS formula for the following a.) b.)

A: The solution is given below

Q: A series circuit consisting of a resistor that dissipates 640watts, a coil and an ideal capacitor is…

A: Given: In this question, the given details are, A series circuit consisting of a resistor that…

Q: An industrial installation has a power factor of 0.85 in backward. The demand is 150 KVA, and the…

A: In the given questions we need to calculate the type of compensator, reactance of the compensator…

Q: Determine the capacitor required to be connected in parallel with the motor so that the power factor…

Q: A single-phase AC voltage controller has a resistive load R = 10 Ohm, and %3D the RMS input voltage…

Q: A sinusoidal AC voltage source has the equation, e=311sin377t, find the maimum voltage Rm, the RMS…

A: The solution is given below

Q: Problem 14. with a 40 2 resistor across a supply of frequency 60 Hz. A current of 3 A flo ws and the…

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: A 400 resistor is connected in parallel to a coil having a resistance of 10 and an inductance of 3H.…

A: As per the guidelines of Bartleby we supposed to answer first three subpart only for solution of…

Q: An AC series circuit has R=300 ohms, L=0.90H, and C=2.0microfarad with a generator of 50V andw= 1000…

Q: Required information An ac motor with impedance ZL = (2.8 +1.60) Q is supplied by an RMS value of…

A: The given problem is from circuits. The matched solution is not for the given problem. The detailed…

Q: series RC circuit with R=4k ohms and C= 0.40 mF is connected to an AC voltage source e(t)= 100…

A: In this question we will find overall power factor and voltage drop across impedance...

Q: A coil of inductance 318.3 mH and negligible resistance is connected in series with a 200 ohm…

Q: The rms value of a 60HZ single phase ac voltage source is 100V and its internal resistance is 0.1 Q.…

A: In the question, A voltage sources V= 100V & 60Hz is supplied to resistance R= 1ohm Inductance…

Q: A 220 V, 60 Hz voltage is applied across a series circuit figure comprising a coil of resistance R,…

A: NOTE: as per our company guidelines we are supposed to answer only first three sub-parts. kindly…

Q: 4. The AC generator in the circuit shown below supplies voltage with amplitude 5.0 V at frequency…

A: Given V=5 V f=336 Hz

Q: ) A heater with resistance 10 N is driven by an AC voltage source (120 V). For the circuit shown…

A: As per the guidelines, we supposed to answer first three part of the question at a time so please…

Q: A 120 V, 60 Hz power source is connected across an 800 ohm resistance in series with an unknown…

Q: d & e

Q: A 102 resistor, a 100µF capacitor and an inductor of 0.15H are connected in series to a supply at…

A: Given data:Asked to calculate,The impedanceTotal current potential differance across each…

Q: nas a reactance of 330 ohms in a circuit with a supply of frequency 16 kHz. coil. nce in mH= circuit…

Q: 9. What will be the impedance of a LR-C circuit if it has a circuit current of 3A and a supply…

A: 9. Answer: 40 ohm Explanation: a. It is not a valid option, By using ohms law the resistance is the…

Q: A circuit consists of an AC voltage source, a 10-ohm resistor, and a capacitor, all connected in…

A: A resistor of 10 ohm is connected in series with a capacitor of impedance 10 ohm. We have to…

Q: 5. An impedance draws a current i(t) = 10sin(wt-30°) ampere from a voltage v(t) = 220cos(wt-65°)…

A: As per our company guidelines we are supposed to answer only first three subparts kindly repost the…

Q: Consider the circuit shown in figure 3. Use Kirchhoff's voltage law to derive a differential…

A: In the given questions we need to derive the differential equations and calculate the phase…

Q: A circuit consisting of a resistor in series with an inductance consumes 210W at a power factor of…

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and…

Q: 1. The single phase ac voltage source is v = 141.4cos(377t)V, the load can be modeled as a 16mH…

A: In the question, Voltage given v=141.1cos(377t)V Resistance R=8 ohm inductance L= 16mH…

Q: A single-phase motor draws 180 W at a power factor of 0.8 lagging when connected across a 240 Vrms,…

A: Given the single phase motor, P=180 WP.F=0.8 lagggingVrms=240 V at 60 HzC=? at unity P.F where P.F…

Q: pure capacitor

A: Conductor-Materials which have free electrons in valence which can flow when comes under any…

Q: one (360 degrees), all of the instantaneous power falls under positive loops (no negative loops),…

A: Option A Resistor is the correct answer.

Q: 7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To…

A: According to guidelines we need to solve only the first question. According to the question we have…

Q: An impedance load consisting of 12 ohms resistance and 16 ohms inductance reactance is connected…

Q: electric units a & b are connected in parallel and its rms current is 15A. If the current in b lags…

A: The solution is given below

Q: 1.For one AC Wheatstone bridge at balance, given that ZA= 100 2, ZB=200 2, Zc-150 Q Zp is a ceil…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: A d.c. Buck converter operates at frequency of 2000 Hz from 200 V d.c. source supplying a 5 2…

A: It is given that:

Q: 186-V/120-Hz source is connected to an inductance L = 0.4 H and a capacitance C = 9 μF, the elements…

A: To solve this question we find the reactance value of inductor and Capacitor and connect them…

Q: 2.) An AC circuit is shown below. The AC power supply has Vrms = 120 V, frequency = 60 Hz. AC power…

Q: A load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the…

Q: An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a…

A: Given R = 100 ohm, L = 0.5 H, C = 10 mF

Q: If E = 1.05 p.u. leading by 25 degrees, feeding infinite bus bar through a reactance of 0.35. Find…

A: Simple problem on powrt system stability. Look below for solution:-

Q: For the coupled circuit shown, find the 12 J52 A J82 value of mutual inductance "M" and put the dots…

A: The solution is given below

Q: Assuming that a nonzero ac voltage source is applied, state whether the power and reactive power are…

A: a) The circuit diagram for a circuit with resistance in series with an inductance with non-zero ac…

Q: Write a report to compare between Ac Through capacitance and AC through in inductance then: For the…

Q: 220 V 60 Hz R R = 25 Q2 L V₁ L=6 mH C HI Ve C= 100 μF

Q: Determine the apparent power, power factor & power factor angle when connected in a) series; b)…

Q: load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the power…

Q: Problem #7) Specify whether each of the statements are TRUE or FALSE. Reactive Power is a measure of…

A: Specify whether each of the statements are TRUE or FALSE. a. Reactive Power is a measure of the…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Please please answer all subparts. I will really upvote
a) Write down the expression of instantaneous voltage for an AC voltage having a Peak value of 220 Volts and a frequency of 50 Hz provided at time t=0, the instantaneous voltage is 220 Volts. What is the instantaneous voltage of the source at time “t = 5 seconds” What is its RMS voltage? b) Two 200Ω resistances are connected in series with one 0.5 H Inductance and two 100μF Capacitance with the power supply of part (a). (i)Draw the circuit diagram of the above network (ii)What is the total impedance of the circuit (iii)What is the max current that flows through the Inductance? (iv)What is the max current that flows through each of the Capacitance? (v)What is the power dissipated in the circuit (vi)What is the power factor of the circuit (vii)What is the resonance frequency of the circuit? (viii) What is the maximum power dissipated by the circuit when it is in resonance
A 200-kVA, 230-V/230-kV testing transformer having a resistance and leakage reactance of 2% and 7% respectively, is to be used as a resonant transformer at 50 Hz to test a piece of cable at 400 kV. The load capacitance is 0.01μF and inductor coil is assumed to 3% resistance. Determine the series inductance required and the input voltage. ..
Question in the attachment
Two impedances Z1 and Z2 are connected in series with the primary and secondary winding of an ideal transformer as shown in the figure below, where the primary coil has jó N and secondary coil has 9 O reactance. The mutual inductance if w = 1000 rad/sec is, mH. 1 C0000
A 5-ohm resistor is connected in series with a 25 micro-farad capacitor. A source voltage of158 volts, 50 Hz supplies the combination. Determine the following: e. Reactive power supplied by the sourcef. Apparent power of the circuitg. Power factor of the entire circuit
In the figure below, all impedances are in ohms, all voltages are in volts and currents in Amperes. Both sources operate at 60 Hz. X, = 200 n X, = 600 n 80 sin (wt + T/2) x, = 600 2 0.2 ain wt Determine the time dependent current i (A) due to the current Choose... source Determine the time dependent current (A) flowing through the inductance with a Choose... reactance of 200 Ohms due to the current source Determine the time dependent current i (A) due to the voltage Choose... source Choose... Determine the total effective current (A) flowing through the Choose... inductance with a reactance of 200 Ohms
An impedance coil, in series with a resistor takes a current of 3A when connected to a 120V AC source. Using a voltmeter, the voltage across the coil was found out equal to 90V and that across the resistor equal to 30V. Find the power factor of the impedance coil only. The frequency is 60 Hz
A series circuit of two pure elements has the following applied voltages and resulting currents of 162.635 sin (314.159t + 36.87°) volts and 35.355 sin (314.159t -16.26°) amperes respectively. Determine the: a. the voltage in polar and rectangular forms; b. the current in polar and rectangular forms; c. the circuit impedance, resistance and reactance; d. the apparent power, S in waveform equation; and e. P, Q, S, and pf of the circuit.
The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH and a capacitor (C) = 800uF. The circuit is supplied by a voltage source of e = 120 sin (125t) Volts. What is the angular frequency of the ac source? What is the period of ac source? What is the circuit impedance? What is the power factor? What is the real power of the circuit? What is the rms value of the circuit current?