1=5 ft, locate the centroid (z,y) of the composite area. (Figure 1) re 1.5 ft 1 ft -3 ft- 1 of 1 Part A Locate the centroid. Express your answer with the appropriate units. Z-Value Submit Part B μA Request Answer Submit Locate the centroid 7. Express your answer with the appropriate units. HA Value Request Answer Units < Return to Assignment Units Provide Feedback ? ?

Q: Q10: The following values were found from the corrected load versus penetration curve Satisfactory…

A:

Q: Explain why piezocone test (CPTU) is used ?

A: Cone Penetration Test Cone penetration testing (CPT) is an in-situ test is used to  identify the…

Q: compressive load P as shown in Table 1 below. Table 1. Experimental results Length b (cm)…

A:

Q: Determine whether the block shown is in equilibrium and find the magnitude and direction of the…

A: Given data:θ = 35°  P = 196 N μs = 0.20 μk = 0.15F = 800 NThe mass of the block is not given, so we…

Q: (7) Let's practice moment of inertia calculations on this built-up cross-section. It is made of four…

A:

Q: epare a datasheet and calculate the cost of plastering cement (1:5), 20mm thick for 50m². Also…

A: Given data:- Ratio of plastering cement is 1:5 Thickness of plaster is 20 mm Area of plastering is…

Q: Question 21 Especially critical with stiff concrete mixes. Over- consolidation must be avoided, as…

A: Above question is related to concrete technology

Q: This is the stiffness matrix for a horizontal roller, if the roller was vertical instead of…

A: Yes, if the roller was vertical instead of horizontal, the rows 1 and 2 of the stiffness matrix…

British Gravitational Bg System Of Units

Measuring is the comparison of a particular physical quantity with its reference value. A unit is a fixed physical quantity. The length is a physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.