15- ...... are the wave of energy caused by the sudden breaking of rocks within the Earth. from the fault break to the site are of two main types: body (P and S) radiating and surface (L andR) waves. a) Seiche Acoustic waves Seismic waves Tsunami Boş bırak

Q: Q.1.11 The logarithmic decrement for a damped freely vibrating SDOF system is 0.08. The damping…

A: From the question, We have to determine ratio is in percentage.

Q: Consider the gravity dam (Figure 2) whose concrete density is noted Pb. The vertical dam profile has…

A: Dam height, hb = 30 m Dam width, lb = 44 m Dam length, Lb = 25 m α = 650 β = 450 Find:

Q: Problem 4: If the material of the beam has an allowable bending stress of Galow = 175 MPa, determine…

A:

Q: 550 KN/m www w 170 KN/m A 3m 3 m 5 m 7 m

A: Schematic diagram of the given problem:

Q: Determine the resultant of the coplanar force system shown in (FIG. Q1) and locate it with respect…

A:

Q: etramine Ke Strain if tuss is 20N/m and E50 Nlem

A:

Q: 9 - Transverse waves propagating fromn the earthquake focus to the ........ - It i the waves that…

A: The point at which the energy got exploded or the energy released is called as focus or hypocentre…

Q: In an undamped free vibration of single degree of freedom, the maximum velocity is 0.3 m/s and…

A: Here ,given details are Maximum velocity = 0.3m/s natural frequency= 10 rad/sec

Q: Drow shear Force Diagram wwith Calculation. - Draw Bending sdoment ŏ iagram with Caleulation. ) Find…

A: Given:- Channel section To find:- a) SFD b) BMD c) Maximum bending stress

Q: in the shaded plane in the figure Gn= 700 kp lem2 Co= 350 kp lcu İn the stress 2. 19 Gx=? O=?

A: Consider the free body diagram of the given member with oblique plane subjected to pure direct…

Q: 26. Determine the Reaction at A in the below figure. • 40.83 KN • 31.37 KN • 30.00 KN 25.83 KN None…

A: Find reaction at A:Take moment about D∑ MD=0

Q: 12- What is the value of earthquake velocity response spectrum for Tn=0? a) b) c) d) e) Zero ton. 0.…

A: Earthquake velocity also known as seismic velocity.The speed of a seismic wave travels through a…

Q: 15 - The (known also as the Ring of Fire, due to the --- -- presence of some very active volcanoes),…

A: Ring of fire

Q: Air fl ows at supersonic speed toward a compression ramp,as in Fig. . A scratch on the wall at point…

A: The wave angle of the compression ramp is β=50∘. The wave angle at small scratch upstream of the…

Q: Q.33 ' A viscously damped system having resonant amplitude of 1.5 m, spring of stiffness of 1600 N/m…

A: We have to find Damping coefficient in percentage. Using given data

Q: 3. Shock waves can be normal, oblique ane bow. a) True

A: To find : Whether the statement is true or false.

Q: Q.12 The logarithmic decrement for a damped freely vibrating SDOF system is 0.08. The damping ratio…

A: Now we find, damping ratio is in percentage

Q: Q1) An oblique shock wave has the following upstream static conditions and Mach Dumber : P=150 kPa…

A:

Q: Q.23 The logarithmic decrement for a damped freely vibrating SDOF system is 0.08. The damping ratio…

A: SDOF SYSTEM, Logarithmic decrement is 0.08

Q: In a seismic survey, an air wave can be best described as

A: A seismic survey is a low impact, non-invasive method of gathering information about the location…

Q: 3. Explain the types of carthquakes that engincers and architects use as a basis in building design,…

A:

Q: Q.24 In a damped freely vibrating SDOF system, the damping ratio is 0.012 and critical damping…

A: Given, Damping ratio=0.012 Damping coefficient = 1600Ns/m

Q: What is the degree of static indeterminacy of the structures shown? 2m

A: Brief Concept- Degree of Indeterminacy- The Degree of Indeterminacy can be divided into two…

Q: For the structure shown below, if E is constant, what is the distribution factor at ?joint B (DFBA)…

A: Finding out distribution factor of BA.

Q: Find the maxeimum ben 75 Nm 60 N/m 5m ØIcm

A: The stress developed in the beam due to the bending action in the beam is called bending stress. The…

Q: Show that the maximum shearing stress for a thin-walled circular tubes acting as beams  having a net…

A: Given data: cross section: thin-walled circular tube  Area=A τmax=2τavg

Q: Single choice question:  7. About the vibration period of the structure, which of the following is…

A: Vibration period is the time required to  complete one cycle.    frequency =1time period   ωn=12πkm…

Q: Determine the friction force between the block and the surface after P was gradually increased from…

A:

Q: Given a 2° standard gauge, the maximum speed of 160 km/h and the equilibrium superelevation as…

A: The given data are: Standard Gauge, D=2° equilibrium super elevation , V1=90 km/h Maximum speed , V2…

Q: Q- Find the intensity of u.d.l. which when its acts over the entire span of 1 m of a cantilever beam…

A: Given: Cantilever length = 1m Cross section= 100mm*200 mm  Maximum shear stress= 1.5 N/mm² Required:…

Q: c. Find the seismic moment of an earthquake having the moment magnitude of 6.4.

A:

Q: Q.15.8 The logarithmic decrement for a damped freely vibrating SDOF system is 0.08. The damping…

A: We calculate, damping ratio is in percentage is,

Q: A GPI-65 "I-Beam" at a 14" depth will have an "EI" value that is equal to

A: Depth=14 in

Q: 11 The shortest distance from the earth where the energy is released during an earthquake is called…

A: focus is the point from where earthquake starts epicenter is point on earth above focus

Q: A water source has a mass of m = 15 tons, which is located on 6 metal columns, the connection of…

A:

Q: Design a steel hollow column of length 15-m with minimum weight for a water tank such that it can…

A:

Q: Determine the reactions for the strucure shown below using the metherd t anestent defamation. 50kW…

A:

Sediment transport

Sediment transport or Soil transport is the movement of solid particles, usually due to the combination of gravitational forces acting on the sediment, and the movement of the liquid at which the sediment enters. Soil erosion occurs in natural systems where the particles are sandstones (sand, rocks), mud, or clay; the liquid is air, water, or ice; and the gravitational force that works to move particles to the landing surface. Sediment transportation or soil migration due to the movement of liquids occurs in rivers, lakes, lakes, oceans, and other bodies of water as a result of currents and waves. Transportation is also caused by glaciers as they flow, and to places on earth under the influence of wind. Soil erosion due to gravity alone is possible in most sloping areas, including hills, scarves, cliffs, and the continental shelf — the continental boundary of the slope.