14. A technician uses an oscilloscope to measure the peak value of an AC wave. He tells you that the voltage has a peak value of 100 V. What is the RMS value of the voltage? A. 10 V B. 707 V C. 70.7 V D. 100 V

14. A technician uses an oscilloscope to measure the peak value of an AC wave. He tells you that the voltage has a peak value of 100 V. What is the RMS value of the voltage? A. 10 V B. 707 V C. 70.7 V D. 100 V

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Potential wave power at a certain location depends Select one: O A. only on the wave amplitude. O B.…

A: In this we will write about potential wave power dependence...

Q: A Red, Voltage 21 A. Blue, Current 2mA Determine the period of the waveforms Determine the frequency…

Q: A voltage wave having an equation 220 sin(314t + 45°) + 100 sin(942t - 45°) is impressed across a…

A: Given parameters:Voltage wave expression- Resistance, R = 10 ohmCapacitance, C = 250 uFInductor, L =…

Q: For the waveform as shown in the figure 2, If the average voltage is 60.679 volt, Find the value of…

Q: 5. Let's change our square wave to be less square. We're only going to have it be at the high…

Q: The voltage waveform during the first half cycle are from t = 0 to t = 0.01 increases linearly from…

Q: A The value of: A=5 ms C= 15 ms Peak to peak = 10 B D Figure 1 (a) From Figure 1 above, identify the…

A: An a.c circuit differs from a d.c circuit in many respects. First, in a d.c circuit we consider…

Q: Determine the RMS amplitude of this sinusoidal waveform, as displayed by an oscilloscope with a…

A: Peak voltage of the signal =sensitivity × no of divisions peak of the signal occupied. For…

Q: A supply voltage has a mean value of 150V. Determine its maximum value and its rms value.

A: Given, Mean voltage of a supply, Vavg=150 V.

Q: Consider the characteristics of alternating current (ac). Find the false statement below. A.…

Q: For the given waveform, the current the voltage by an angle V ot (rad) T/2

A: From the given waveform , we can easily found which one leading or lagging.

Q: If the peak value of a certain sine wave voltage is 10 V, what is the peak-to-peak value? (a) 20 V…

A: Peak to peak voltage is nothing but the maximum possible voltage change during one complete of…

Q: If the peak value of a certain sine wave voltage is 10 V, what is the peak-to-peak value? (a) 20 V…

A: Peak value vm = 10 V We have to find the peak to peak voltage

Q: For the waveform as shown in the figure 2, If the average voltage is 60.679 volt, Find the value of…

A: Evaluating the average value of the above graph:

Q: Q1/if the magnitude of the sine wave is 8 squares at Range=1 what is the voltage value?

A: In this question we need to find a voltage of sin wave.

Q: Indicate the rms value and frequency in Hz of a voltage signal with value 200sen(1000t+30°) V

Q: Solve the frequency and the rms value of the sixth harmonic of a sawtooth wave that has a…

Q: In an ac circuit if the peak value of the voltage is 200 V what is the rms value?

Q: 1. If maximum value of current is 5√2 A, what will be the value of RMS current?

A: It is given that:

Q: In an experiment, the function generator is adjusted to generate a square voltage at a certain…

A: Given oscilloscope peak to peak voltage is 10Vp-p at certain frequency. Hence maximum voltage Vm=5V…

Q: An alternating current has the frequency of 62 Hz, then the value of angular velocity is

A: f=62 Hz

Q: Determine the r.m.s. value of the waveform of Figure 1, (mV): The sine wave 10 20 30 10 t(ms) Figure…

A: Given waveform:

Q: For the sine waveform shown in figure, determine (a) periodic time, (b) frequency, (c) peak voltage,…

Q: sinusoidal waveform is displayed on an oscilloscope and has a peak-to-peak amplitude of 15 V. At the…

A: In this question we will find analogue multimeter reading....

Q: 50 - cycle current has a maximum value of 7.5 amp. What will be the instantaneous value of current…

A: In this question we will find instantaneous value of current...

Q: Ratio of dc output voltage to rms voltage is a. 0.318 b. 0.637 c. 0.45 d. 0.9

A: In half wave rectifier Vdc= Vm/π Vrms = Vm/2

Q: Describe and Compare the curve of the oscilloscopes in the image

A: Two oscilloscope curves are given in the question. We need to describe and compare both the curves.

Q: The average (DC) value of a half-wave rectified voltage with a peak value of 200 V is: a. 63.7 V b.…

Q: A sine-wave has a frequency of 1 kHz. Ten complete cycles will require a time of ... a) 10 ms b) 100…

A: Given, Frequency of sine wave is f = 1KHz Ten complete cycles will require a time of .....?

Q: Q1. A square waveform with following specifications RMS Voltage 163.21 Time for two cycle 35ms…

Q: 1. Draw your own visualization of the waveform(s) using the following information. each) a. Waveform…

A: Given Time for one complete cycle = 0.100 seconds Hence frequency =1\0.1000 =10 Hz

Q: Describe the curve of the oscilloscope in the image given.

A: Electrical devices are used for measuring electrical parameters. Current, voltage and power are…

Q: What is the form factor of this waveform...

A: The given waveform is shown below.

Q: If the waveform of a voltage has a Form Factor of 1.15 and c Peak Factor of 1.5, and if the peak…

A: Given: A voltage waveform with, Form factor = 1.15 Peak factor = 1.5 Peak value, Vm=4.5 kV

Concept explainers

Digital Integrated Circuit Design

Digital IC design is a procedural interaction that involves converting determinations and highlights into computerized blocks, which are then further transformed into basic circuits. A significant number of the imperatives related with advanced IC plan come from the foundry cycle and innovative restrictions.

Question

14. A technician uses an oscilloscope to measure the peak value of an AC wave. He tells you that the
voltage has a peak value of 100 V. What is the RMS value of the voltage?
A. 10 V
B. 707 V
C. 70.7 V
D. 100 V

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

P-channel Metal-Oxide Semiconductor (PMOS), N-channel Metal-Oxide Semiconductor (NMOS), and Complementary Metal-Oxide Semiconductor (CMOS)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

B）Determine the voltage ??(??) and current ??(??) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms.
3. A double beam oscilloscope displays 2 sine waveforms A and B. The time/cm switch is on 100us/cm and the volt/cm switch on 2V/cm. The width of each complete cycle is 6 cm for both the waveforms. The height of waveforms A and B are 3 cm and 3.5cm respectively. Determine their a) frequency, b) phase difference, and c) peak and r.m.s value of voltages. The difference between the two waveforms is 0.6 cm.
An oscilloscope screen produces the waveform shown. The vertical blocks represent 20 V per division, and the horizontal blocks represent 100 us per division. What would the frequency of the displayed waveform be? O a) 1.25 kHz O b) 2 kHz Oc) 1 kHz O d) 10 kHz
Find the RMS value of a 50% chopped ac wave
For the given waveform, the voltage the current by an angle 2 ot (rad) T/2
Kindly solve this clearly. Solve and maintain in 4 decimal places. Box the final answers.
What is the average voltage of the voltage wave having a peak-to-peak voltage of 20V? A 12.7 V B) 6.4 V c) 14.1 V D 7.1 V
What is the frequency of a power waveform compared to the corresponding voltage and current sine waves? Explain why.
When measured by an analog meter, a sinusoidal voltage shows a reading of 100 Vrms. What is the amplitude of the voltage source? A 140 V B) 141 V c) 142 V D 143 V
sistance of the resistor is 100 Ohm. urce is 100 W. what is the rms voltao
The waveform displayed on an oscilloscope is as shown in Figure . Determine: (1) amplitude of waveform 'A' (ii) RMS value of waveform 'B' (ii) frequency of waveform 'A' and (iv) phase angle difference between 'A' and 'B' in Degrees. A 2 1 0.5 ,0.2 5 10. 20 30 V/cm 50 5 ms ,100 us fimeom 50 ms . 500 ms 2s Unload vour Answers stens in the "Cinal Evam Answer Suh ission"Link provided in the MMoodle
Find the RMS value..