14. A dumpy level is set up with its eye-piece and the reading on peg B is 0.705 m. The level of peg A to the center of the eye-piece is 1.50 m vertically over a peg A.The height from the to is then setup over B. The height of the eye-piece above peg B is 1.490 m and reading on A is 2.195 m. The difference in level between A and B is (a) 2.900 m (b) 3.030 m (c) 0.770 m (d) 0.785 m

14. A dumpy level is set up with its eye-piece and the reading on peg B is 0.705 m. The level of peg A to the center of the eye-piece is 1.50 m vertically over a peg A.The height from the to is then setup over B. The height of the eye-piece above peg B is 1.490 m and reading on A is 2.195 m. The difference in level between A and B is (a) 2.900 m (b) 3.030 m (c) 0.770 m (d) 0.785 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

G
Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following measurements. i. ii. iii. 2.265 m 1.442 m 2.418 m iv. 3.415 m Example:
Q- The levelling staff held at a distance of 200 m is read at 4.54 m with the bubble out of centre by 2 divisions towards the observer. If the sensitiveness of the bubble is 25 secs/division, and 1 division = 2 mm, then actual staff reading must have been..
The difference of levels between two points A and B is determined by using a tacheometer. The instrument was setup at another point Cand following observations were taken: [Assume staff to be held verticle during measurements] Staff at A Vertical angle Stadia Reading (in m) A -6°30' 3.50, 2.815, 2.130 B -8°30 1.87, 0.99, 0.110 Assume additive constant, C = 0.50 and multiplying constant, k = 50.0. Find the difference of level between A and B.
Determine the value of angle Q.
Draw a sketch of level rods (as seen from the eyepiece of an engineer's transit) with the following measurements. i. ii. 2.275 m 1.772 m ii. 3.715 m iv. 0.250 m v. 2.718 m Example: DS
Q- The staff reading taken on a workshop floor using a level is 0.645 m. The inverted staff reading taken to the bottom of a beam is 2.960 m. The reduced level of the floor is 40.500 m. Find the reduced level (expressed in m) of the bottom of the beam