14 (a) For 1.0 mol of a monatomic ideal gas taken through the cycle in Fig. 20-24, where V₁ = 4.00V, what is W/poVo as the gas goes from state a to state c along path abc? What is AEint/PoVo in go- ing (b) from b to c and (c) through one full cycle? What is AS in going (d) from b to c and (e) through one full cycle? Pressure 2po Po a Vo Volume Figure 20-24 Problem 14. b V₁

14 (a) For 1.0 mol of a monatomic ideal gas taken through the cycle in Fig. 20-24, where V₁ = 4.00V, what is W/poVo as the gas goes from state a to state c along path abc? What is AEint/PoVo in go- ing (b) from b to c and (c) through one full cycle? What is AS in going (d) from b to c and (e) through one full cycle? Pressure 2po Po a Vo Volume Figure 20-24 Problem 14. b V₁

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter3: The First Law Of Thermodynamics

Section: Chapter Questions

Problem 78P: Two moles of a monatomic ideal gas such as helium is compressed adiabatically and reversibly from a...

See similar textbooks

Similar questions

Two moles of a monatomic ideal gas such as oxygen is compressed adiabatically and reversibly from a state (3 atm, 5 L) to a state with a pressure of 4 atm. (a) Find the volume and temperature of the final state. (b) Find the temperature of the initial state. (c) Find work done by the gas in the process. (d) Find the change in internal energy in the process. Assume Cv=5R and Cp=Cv+R for the diatomic ideal gas in the conditions given.
A monatomic ideal gas undergoes a quasi-static process that is described by the function pV=p1+3(vv1) , where the stating state is (p1,v1) and the final state (p2,v2) . Assume the system consists of n moles of the gas in a container that can exchange heat with the environment and whose volume can change freely. (a) Evaluate the work done by the gas during the change in the state. (b) Find the change in internal energy of the gas. (c) Find the heat input to the gas during the change. (d) What ale initial and final temperatures?
In an adiabatic process, oxygen gas in a container is compressed along a path that can be described by the following pressure in atm as a function of volume V, with V0=1L:P=(3.0atm)(V/V)1.2 . The initial and final volumes during the process were 2 L and 1.5 L, respectively. Find the amount of work done on the gas.
In an isothermal reversible expansion at 27 , an ideal gas does 20 J of work. What is the entropy change of the gas?
In a diesel engine, the fuel is ignited without a spark plug. Instead, air in a cylinder is compressed adiabatically to a temperature above the ignition temperature of the fuel; at the point of maximum compression, the fuel is injected into the cylinder. Suppose that air at 20 C is taken into the cylinder at a volume V1 and then compressed adiabatically and quasi-statically to a temperature of 600 C and a volume V2 . If =1.4 , what is the ratio V1/V2 ? (Note: static. In an operating diesel engine, the compression is not quasi-
In a quasi-static isobaric expansion, 500 J of work are done by the gas. The gas pressure is 0.80 atm and it was originally at 20.0 L. If the internal energy of the gas increased by 80 J in the expansion, how much heat does the gas absorb?
After a free expansion to quadruple its volume, a mole of ideal diatomic gas is compressed back to its original volume isobarically and then cooled down to its original temperature. What is the minimum heat removed from the gas in the final step to restoring its state?
Statistical mechanics says that in a gas maintained at a constant temperature through thermal contact with a bigger system (a "reservoir") at that temperature, the fluctuations in internal energy are typically a fraction 1/N of the internal energy. As a fraction of the total internal energy of a mole of gas, how big are the fluctuations in the internal energy? Are we justified in ignoring them?
A dilute gas expands quasi-statically to three times its initial volume. Is the final gas pressure greater for an isothermal or an adiabatic expansion? Does your answer depend on whether the gas is monatomic, diatomic, or polyatomic?
An ideal gas expands quasi-statically to three times its original volume. Which process requires more work from the gas, an isothermal process or an isobaric one? Determine the ratio of the work done in processes.
With the help of the two preceding problems, show that S between states 1 and 2 of nmoles an ideal gas is given by S=CnplnT2T1nRlnP2P1.
The temperature of an ideal monatomic gas rises by 8.0 K. What is the change in the internal energy of 1 mol of the gas at constant volume?