13,600 kg/m) is con- 1-72 A mercury manometer (p = nected to an air duct to measure the pressure inside, The differ- ence in the manometer levels is 15 mm, and the atmospheric pressure is 100 kPa. (a) Judging from Fig. P1-72, determine if the pressure in the duct is above or below the atmospheric pressure. (b) Determine the absolute pressure in the duct.

Q: cury. 3.83 A barometer indicates the atmospheric pressure to be 30.65 in of mercury. Calculate the…

A: Given:h=30.65 in

Q: The pressure of water in a pipeline was measured by means of a simple manometer containing mercury.…

A:

Q: At the sea level, a manometer reading gives the gage pressure of 1 atm. Determine a) the local…

A:

Q: 5) Determine the pressure exerted on a submarine at 300m below the free surface of the sea. Assume…

A:

Q: A manometer shows a vacuum of 260 mm Hg. What will be the value of this pressure in KPa in the form…

A: Given data, Manometric reading, Pm,v = 260 mm Hg vacuum = - 260 mm Hg Atmospheric pressure, Patm =…

Q: What is the h of mercury in the following setup filled with mercury if the total atmospheric…

A: As Question we have determine  Height mercury

Q: The value of the pressure gauge A in the B tank is 1.4 bar. The U-type manometer connected to tank B…

A: Given Data :- L= 20cm Patm= 101 Kpa

Q: H1.4 Air is contained in a vertical piston-cylinder device. The piston, with a mass of 30 kg and…

A: Given:The mass of the piston, The diameter of the piston, The outside ambient pressure,

Q: Q1) Both a gage and a manometer are attached to a gas tank to measure its pressure. If the reading…

A:

Q: A rigid, hermetically sealed container contains two fluids: water (103 kg / m3 ) and air. A pressure…

A:

Q: ine, and the water level in the other sid inlet line in in. H₂O and in lb/ft², gage? in. H₂O gag

A:

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.