13. A coil has a resistance of 6 ohms and an inductance of 0.02 H. When a non-inductive resistor is connected in series with the coil, the current drawn when connected to a 220 V DC source is equal to the current drawn by the coil alone across a 220 V, 60 Hz source. Determine the resistance of the non- inductive resistor. A) 3.63 0 B. 6.39 N C. 3.69 N D. 3.96 N

13. A coil has a resistance of 6 ohms and an inductance of 0.02 H. When a non-inductive resistor is connected in series with the coil, the current drawn when connected to a 220 V DC source is equal to the current drawn by the coil alone across a 220 V, 60 Hz source. Determine the resistance of the non- inductive resistor. A) 3.63 0 B. 6.39 N C. 3.69 N D. 3.96 N

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Eddy currents can be induced only in metals that are not ferromagnetic, for example, copper and aluminium. Select one: True False
A sinusoidal voltage with effective value (73 V), and a Frequency its value (80 Hz), was applied on a series circuit that consists of a coil with inductance of value (0.05 H), and a resistor of value (5 N). Calculate: 1. The maximum value of the voltage? 2. The inductive reactance of the coil? 3. The electric impedance of the circuit? 4. The maximum value of the generated current in the circuit? 5. The phase angle? 6. The power factor? 7. The power dissipated inside the coil? 8. Draw a diagram showing the results?
Question- A solar cell of 350 V is feeding power to an ac supply of 440 V, 50 Hz through a 3-phase fully controlled bridge converter. A large inductance is connected in the dc circuit to maintain the dc current at 20 A. If the solar cell resistance is 0.5 Q, then find the period for which each thyristor be reverse based.
Mixing (non reacting fluids), Electric circuits. Problem: If the circuit is moved to position 2, find the current after 2 seconds. The circuit before disconnecting the RL circuit from the battery is 20 A. The resistance is equal to 5 ohms while the inductance is equal to 2 Henries. A. 19.865 A B. 0.135 A C. 11.013 A D. 8.987 A
show step by step solution please thank you
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
Define the term Capacitance and Inductance? Capacitance: It is the amount of charge that is stored inside a capacitor at a given voltage. Inductance: It is defined as the property of a coil to resist any changes in electric current flowing through it. Mutual inductance happens when a secondary coil opposes current change in the primary coil. Mention what is the difference between generator and alternator? Both generator and alternator work on the same principle they convert mechanical energy into electrical energy. Generator: It converts induced emf (Electro Motive Force) into direct current, where it based on stationary magnetic field and revolving conductor which rolls on the armatures with slip rings and brushes riding against each other. Alternator: It has rotating magnetic and stationary armature for high voltage and stationary magnetic field and a rotating armature for low voltage
i need the answer quickly
(b) i. The power taken by an inductive circuit when connected to a 200 V, 50 Hz supply is 500 W and the current is 5 A. Calculate the resistance and the impedance of the circuit. ii. Calculate the power factor for the circuit in Q4 (b) i. iii. Calculate how much capacitance in uF will be needed to correct power factor to 0.9.
Inductance
Please answer this NEATLY, COMPLETELY, and CORRECTLY for an UPVOTE. The coil of a generator has an equivalent resistance of 1.5 ohms at 20 °C. After being used for several hours, the resistance is found to be 1.75 ohms. Determine the temperature of the coils at this time. The temperature coefficient of resistance at 0 °C of the coil is 0.004 OC-1.
5. An iron core 0.4m long and 5 cm?. In cross section, is wound with 300 turns. When a current of 0.5 A flows in the coil, how much is the inductance of the coil. Assume the core has a pemeability of 2500.