*13 A rectangular loop of N closely packed turns is posi- tioned near a long straight wire as shown in Fig. 30-68. What is the mutual inductance M for the loop-wire combination if N = 100, a = 1.0 cm, b = 8.0 cm, and / = 30 cm? ILW

*13 A rectangular loop of N closely packed turns is posi- tioned near a long straight wire as shown in Fig. 30-68. What is the mutual inductance M for the loop-wire combination if N = 100, a = 1.0 cm, b = 8.0 cm, and / = 30 cm? ILW

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter14: Inductance

Section: Chapter Questions

Problem 36P: The current shown in part (a) below is increasing, whereas that shown in part (b) is decreasing. In...

See similar textbooks

Similar questions

Check Your Understanding How much energy is stored in the inductor of Example 14.2 after the current reaches its maximum value?
In an oscillating LC circuit the maximum charge on the capacitor is 2.0 × 10-6 C and the maximum current through the inductor is 8.0 mA. (a) What is the period of the oscillations? (b) How much time elapses between an instant when the capacitor is uncharged and the next instant when it is fully charged?
Two coils close to each other have a mutual inductance of 32 mH. If the current in one coil decays according to I=I0eat , where I0= 5.0 A and =2.0103s1 , what is the emf induced in the second coil immediately after the current starts to decay? At t=10.0103s? ?
A 5000-pF capacitor is charged to 100 V and then quickly connected to an 80-mH inductor. Determine (a) the maximum energy stored in the magnetic field of the inductor, (b) the peak value of the current, and (c) the frequency of oscillation of the circuit.
Show that the self-inductance per unit length of an infinite, straight, thin wire is infinite.
In Figure 14.12, =12V , L = 20 mH, and R=5.0. Determine (a) the time constant of the circuit, (b) the initial current through the resistor, (C) the final current through the resistor, (d) the current through the resistor when t=2L , and (e) the voltages across the inductor and the resistor when t=2L .
Check Your Understanding (a) Calculate the self-inductance of a solenoid that is tightly wound with wire of diameter 0.10 cm, has a cross-sectional area of 0.90 cm2, and is 40 cm long. (b) If the current through the solenoid decreases uniformly from 10 to 0 A in 0.10 s, what is the emf induced between the ends of the solenoid?
If emf of the battery of Figure 14.12(b) is reduced by a factor of 2, by how much does the steady-state energy stored in the magnetic field of the inductor change?
Check Your Understanding (a) If the current in the circuit of in Figure 14.12(b) increases to 909 of its final value after 5.0 s, what is the inductive time constant? (b) If R=20 , what is the value of the self-inductance? (c) If the 20 resistor is replaced with a 100 resister, what is the time taken for the current to reach 90% of its final value?
A small, rectangular single loop of wire with dimensions 1, and a is placed, as shown in the plan of a much larger, rectangular single loop of wire. The two short sides of the larger loop axe so far from the smaller loop that their magnetic fields over the smaller fields over the smaller loop can be ignored. What is the mutual inductance of the two loops?
An inductor is connected across the terminals of a battery. Does the current stance of the battery? Does the time required for the current to reach its final value depend on this resistance?
In the circuit sho in the accompanying figure, the rtd slides along the conducting rails at a constant VelOCity v. The velocity is in the same plane as the rails and directed at an angle 6 to them. A uniform magnetic field Bis directed out of the page. What is the emf induced in the r?