+12U R, 2.2kA +9U, Joc R2 22te LM324N GND Ru 2.2ŁA 2.2Ł2

Q: You have been given a project to design a zener voltage regulator with the following specifications:…

A: The circuit can be made as:

Q: Determine the peak output voltage and the average value of the output voltage of the rectifier.

A:

Q: To a measurement range of -4 to 6 V, apply a 4-bit analog-to-digital converter.  1- Identify the…

A: Part (1): The circuit diagram for the 4-bit analog-to-digital converter is shown below:

Q: Question 4: In the DC/DC Boost Converter shown below, all the components are ideal. Redraw the…

A: In this question we discuss about switching mode of boost converter.

Q: 1. Design a buck converter and a resistive load operating in CCM mode with the following…

A: Given, Duty cycle D=0.04, Frequency=30kHz Vin=input voltage=20V, RL=load resistance=5.33Ω…

Q: 18. A dc-dc converter is to be built with the following specifications: Allowed dc input voltage…

A: Types of Basic DC DC Converter  Buck converter  Boost converter  Buck boost converter

Q: 2) The figure below shows a circuit made of a thermistor and a fixed resistor R2. The resistance –…

A: PART (1) From the graph: Let the Resistance of the thermistor is R1At,Temperature = 2°C the…

Q: For a fixed bias circuit Ra-470K, Rc-3KQ, B-100, Vcc-12V, Rs=0.3KQ, R₁-4.7KQ, C₂=2uF, C, -4μF. Draw…

A: The fixed bias circuit needs to be drawn based on the given specifications and the overall voltage…

Operational Amplifier

An operational amplifier also called op amp is an integrated circuit or analog circuit that takes input as a differential voltage and produces output as a single-ended voltage. It is an IC that can amplify weak electric signals.An op amp has one output pin and two input pins. The basic role of an opamp is to amplify the voltage difference between the two input voltages. It is also used in filtering or to perform mathematical operations or in signal conditioning.