12. Calculate the number of series turns per pole required on a compound generator to enable it to maintain the voltage constant at 460 V be- tween no load and full load of 100 kW. Without any series winding, it is found that the shunt current has to be 2 A on no load and 2-65 A on full load to maintain the voltage constant at 460 V. Number of turns per pole on the shunt winding = 2000_ If the series coils were wound with 8 turns per pole and had a total resistance of 0-01 N, what value of diverter resistance would be re- quired to give level compounding?

12. Calculate the number of series turns per pole required on a compound generator to enable it to maintain the voltage constant at 460 V be- tween no load and full load of 100 kW. Without any series winding, it is found that the shunt current has to be 2 A on no load and 2-65 A on full load to maintain the voltage constant at 460 V. Number of turns per pole on the shunt winding = 2000_ If the series coils were wound with 8 turns per pole and had a total resistance of 0-01 N, what value of diverter resistance would be re- quired to give level compounding?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: uèstion 7 A shunt generator running at 1000 r.p.m. has generated e.m.f. as 300 V. If the speed…

A: In this question, choose the correct option What is emf at speed = 1200rpm

Q: 1. Variable loss in a dc series generator = la2 Ra. 2. Lap winding is suitable for high current,…

A: The explanation is as follows.

Q: A single-phase power system consists of a 600-V 50-Hz generator supplying the circuit shown in…

A: The given circuit diagrams (1-a) and (1-b) are shown below: It is given that: V=600 Vf=50…

Q: An approximate E.m.f. per turn of 26 V of a single phase transformer is connected a 5 kV/ 124 V, 50…

A: as per our company,s guidelines we can answer only one question , please re-post the second question

Q: Explain how Y-connected stator winding of alternator requires 58% of turns with respect to that of…

Q: Draw the developed diagram for the stator winding of a 3-ph, 2-pole 1.M. The winding is double layer…

A: Here, The stator winding is a double layer with a full pitch coil. The number of slots is 2 per…

Q: For dc machines, the series field windings have many turns of fine wire true False

Q: a 3 phase, 50 hz synchronous generator has 200 conductors per phase. The flux per pole is 30mwb and…

A: 3 phase synchronous generator frequency f = 50 Hz number of conductors per phase Z = 200 number of…

Q: In a three-phase star connected alternator it is necessary to generate 7200 line voltage at…

Q: 2.1: The following data refer to a single-phase transformer: Turn ratio (2:1), R=2 S2, X-12 n,…

Q: What is the Shunt de generator and Draw equivalent circuit?

A: In DC generator field current is needed to excitation. DC field current excited separately through…

Q: The leakage flux passes through the primary winding but not in the secondary winding and vise-versa

A: The leakage flux passes through the primary winding but not in the secondary winding and viceversa

Q: 4- With the increase of the winding of a d.c. generator, terminal voltage wil c) Remain same a)…

A: (4) With the increase of winding of a dc generator, the armeture resistance of winding also…

Q: If it is desired to bring alternating current out of a generator, what kind of a "take-off" system…

A: If the alternating current is required from the generator a copper or brass rings are connected at…

Q: The DC shunt generator with the terminal voltage 300 V, armature drop 6 V and the each brush drop 4…

A: Please upload only one question at one time for better explanation

Q: 3. When an alternator connected to a particular load the calculated voltage regulation is -10.6%.…

Q: (Q1f, Draw and compare the per-phase electrical equivalent circuits of a transformer and of an…

A: To draw and compare the per-phase electrical equivalent circuits of a transformer and of an…

Q: 1) (17 points) The input voltage and current of a single-phase power transformer are as indicated in…

Q: An alternator rated for 490 kVA, 3.3kV, 10 poles, 3 phase, 50 Hz, Delta connected has 182 term per…

Q: Q-2.B. Explain what are the principle operation of alternators ?

Q: - Indicate whether the following statement are true or false *

A: Dc series generator consists of the field winding connected in series with the generator. .

Q: 1. If the number of poles in a lap wound generator is doubled, then the generated emf will be a)…

A: Given: Number of poles in lap wound generator are doubled.

Q: Q.1: The following data refer to a single-phase transformer: Tum ratio (2:1), R-2.4 n, X-2.5 1,…

Q: Figure Ql shows a two-legged iron core with air gap on the middle leg. Primary winding and secondary…

A: Fringing effect Flux when pass through air gap, it tends to bulge out as shown below Bulging of the…

Q: 025 4- The no- - lood primary current of a certain transformer is 1A at a lagging power factor of…

A: First refere the secondary current to primary side and then add the no load current and referred…

Q: Explain how Y-connected stator winding of alternator requires 58% of turns w.r.t. that of…

Q: 2A. What is another term for "shunt"? a) in series b) in parallel c) compounded d) none of the above…

Q: A 1-ph transformer 25kVA, 330/110V, 50Hz, Req2 = 0.0452 and Xeq2 = 0.06592 draw the Kapp regulation…

A: Single Phase Transformer: A single phase transformer is a transformer that uses only one phase of…

Q: Draw and explain the phasor diagram for two transformers in parallel.

A: Transformer connection in parallel : The parallel Operation of a Single Phase Transformer means…

Concept explainers

Single Phase Transformer

A single-phase transformer is a type of power transformer. It is an electrical device that accepts converts the single phase alternating power into single phase alternating power. In this power conversion the voltage is stepped up or down. If the voltage is stepped up, the current will be stepped down and if the voltage is stepped down, the current will be stepped up.

Question

(Ipp. I., D. O.)
12. Calculate the number of series turns per pole required on a compound
generator to enable it to maintain the voltage constant at 460 V be-
tween no load and full load of 100 kW. Without any series winding, it
is found that the shunt current has to be 2 A on no load and 2-65 A
on full load to maintain the voltage constant at 460 V. Number of
turns per pole on the shunt winding = 2000
If the series coils were wound with 8 turns per pole and had a total
resistance of 0-01 2, what value of diverter resistance would be re-
quired to give level compounding?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

i need the answer quickly
In DC Shunt generator, the armature winding and field winding are connected in series Select one: O True O False The efficiency of a transformer is maximum when
An 8.2kW seriesd generator has an armature resistance is 0.25 ohms with a generated voltage equal to 4212.43 V. Determine the series field resistance should be installed in this machine in order to supply a load at 400V.
Which of the given circuit breaker can success fully interrupt Lightning Surges? O a. Vacuum CB O b. Air blast CB O c. SF6 CB O d. Oil CB
Three single phase transformers each having a 240 V primary and two 250 V secondaries, as shown in the figure below, is to be connected to a 400 V, 3–phase supply to give a six phase output. A d e В f Show how this is done and find the voltage between adjacent phases of the 6-phase output.
I need the answer as soon as possible
4. The portion of the flux that goes through one of the transformer coils but not the other one is called. A) Average flux C) Total flux B) Mutual flux D) Leakage flux 5. The ------- are represented in the induction motor equivalent circuit by the resistor Rc (or the conductance Gc). A) Stray losses. C) Air-gap losses B) Friction and windage losses D) Core losses 6. The per-phase voltage Vo can be calculated by dividing the total voltage on. A) √3 B) √1.404. C) √0.707. D) √2.
Please solve in 15 min
Why are alternators connected in parallel? What are the conditions for parallel connection? Explain.
H.W-1: 1. Draw a developed diagram of a simple 2-layer lap-winding for a 4-pole generator with 8 coils. 2. Draw a developed diagram of a simple 2-layer wave-winding for a 4-pole generator with 9 slots.
An autotransformer have two separate windings, and are known as double-wound transformers. Select one: O True O False A 8 pole generator has a wave wound armature with 67 slots with 29 conductors per slot. Then the number of parallel paths in armature is
We have 3 Phase, 24 Slot, 6 Pole Double Layer Winding. Solve then construct its Winding Diagram.