Answered: 12. A hot-gas bypass valve directs…

12. A hot-gas bypass valve directs hot-gas refrigerant from the discharge line to the A. condenser B. liquid line C. liquid receiver D Jow side of the system

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Make use of T-S diagram explain the effect of under cooling on the COP of a vapour compression…

Q: B- Compare between the following: 1-Direct and reverse return closed piping systems. 2- Single stage…

A: According to the given data We need to compare The Direct and reverse return closed piping…

Q: eat expulsion occurs in what section of a heat pump system when operating in the heat mode? A.…

A: Heat expulsion means removal of heat from the system,

Q: installing a spray condenser with a wet type cooling tower is not practical Choice. explain why?

A: When installing a condenser with cooling tower than in that case there are different types of flow…

Q: The. . Are also used in areas where vapor plumes associated with cooling towers are to be…

A: A condenser is a heat exchanger used in heat transfer systems to condense a gaseous fluid into a…

Q: The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that…

Q: ct and outlet temperatures are 80°F and I 10 F, respectively. Verage latent heat of vaporization is…

A: calculate the cooling water flow rate:-25,500lbhr125Btulblb °FBtu125°F7.48 gal62.3 lbhr60 min=255…

Q: Q. Mention the main requirements gf a steam condensing plant.

A: The answer is

Q: 7. In vapor compression refrigeration systems, low freezing temperature is obtained by A. increasing…

A: In vapor compression system, low freezing temperature is obtained by decreasing the evaporator…

Q: Evaporative condenser is used only air as condensing medium to condense the hot vapour refrigerant.…

A: This question is based on evaporative condenser in a refrigeration cycle.

Q: Can you draw the schematic diagram of a cooling system for a Chiller plant that is using a cooling…

A: A centralized system that cools air is called a chiller plant. It provides the HVAC systems with…

Q: Why do all open cooling towers not have side stream filtration?

A: Cooling towers are an essential segment of numerous refrigeration frameworks, giving solace or…

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

Q: The typical temperature difference between the enteringair and the boiling refrigerant on a standard…

A: The temperature split, sometimes referred to as the approach temperature, is the difference between…

Q: Which part in the mechanical heat pump is used to increase the refrigerant pressure? Select one: a.…

A: Given Data : Mechanical heat pump

Q: What is the heating source for the station's feedwater heaters?

A: Explanation for mcq 6 The heating source for the station's feed water heater we used steam bled from…

Q: The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that…

Q: Surface condensers increase turbine back pressure, is the statement true or false

A: Required :- To state whether the statement "Surface condensers increase turbine back pressure" is…

Q: If a hot water reheat coil is installed with a two way modulating valve. A. The VAV box can only be…

A: Given :- If a hot water reheat coil is installed with a two way modulating valve. Select one A.…

Q: What are the advantages of using cascade refrigeration? I.Higher required pressure differences for…

A: This question is based on the concept of the Cascade refrigeration system.

Q: PROBLEM 1 : A 50-ton vapor compression refrigeration system is to evaporate R-12 at -20°C and to…

A: “Since you have posted a question with multiple subparts, we will solve first three sub parts for…

Q: Multi-evaporator system with individual multiple expansion compressors and valves

A: ME-VCS (multi-evaporator vapour compression systems) are used to cool numerous zones. The…

Q: How does a shell-and-coil condenser remove heat from the refrigerant?

A: Condenser is the type of heat exchanger which is used to remove heat from the refrigerant.…

Q: Contact condensers are a. sometimes referred to as shell and tube heat exchangers b. control…

A: Contact condensers are a. sometimes referred to as shell and tube heat exchangers b. control…

Q: 1. What other substance circulates in the refrigeration system with the refrigerant? 2. What would…

A: 1. Oil circulates in the refrigeration system with the refrigerant.

Q: In which part in the mechanical heat pump the refrigerant gives heat? Select one: O a. Condenser O…

A: Given Data⇒ Mechanical heat pump Refrigerant

Q: ID: A 41. what could happem if a semi-hermetic com is edith dhe waction srvice valve hack the…

A: Dear student, as per the Bartleby guidelines, we are authorized to answer the first three questions…

Q: In the absorption refrigeration cycle, which of the following componennts replace the compressor in…

A: Refrigeration: It means cooling a space, substance or system to lower and maintain its temperature…

Q: In vapour compression cycle the condition of refrigerant is superheated vapour O After passing…

Q: The condenser of the water cooled chiller -22 :is cooled by إختر أحد الخيارات tor o:rouleted by Umne…

A: To select the correct option.

Q: A device that opens when condenser pressure rises 19. to a proper level and closes to block the flow…

Q: safety measure

A: Hello you are asking about cardioxide refrigerant but currently there is no such a refrigerant in…

Q: a device that allows hot refrigerant vapor from the compressor discharge line to bypass the…

A: In cold weather, the hot gases from the compressor are most likely to drop their pressure below the…

Q: Characterize the following types of refrigeration compressors: a. Vane compressors b. Screw…

Q: Where is the only permanent suction line on a heat pump?

A: The heat pump is a device used to taken heat from the outside environment and take it to our home.…

Q: Which process would best represent the opposite ofexhausting air from a system?A. CoolingB.…

A: Given Data : Exhausting air

Q: The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that…

Q: Which part in the mechanical heat pump is used to reduce the refrigerant press Select one:

A: Given Data⇒ Mechanical heat pump

Q: 9. Define condenser.

A: Heat Pumps: The devices that transfer heat from cold bodies to hot bodies are called heat pumps.…

Question

12. A hot-gas bypass valve directs hot-gas refrigerant
1
D.
gets
17. Which ofthe
refrigerant ung
the high side
A. Fusible pl.
B. Manifold
C. Rupture d
D. Spring-loa
when the syste
11
outor
18. Which of the
valves is not
A. A blown.
B. Relief val
C. Relief va
using a p
out
from the discharge line to the
A. condenser
B. liquid line
C. liquid receiver
D. low side of the system
D. Spring-le
prevent
service
19. A device th
to a proper
refrigerant.
when cond
ssure
the
Elet of
A. conden
Ing a
В. crankc
C. receive
D. split cc
20. A device t
ering
to
compress
and direc
pressure
ring
and the l
A. conde
B. crank
C. TO

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

!
Please answer part II, the part I answer is the photo attached.
Comment on this diagram. Qu Condenser Valve Compressor Evaporator
Fraction dryness measures .9 the percent of the liquid refrigerant in the condenser. the percent of the vapour refrigerant at any point in the expansion valve. the enthalpy of the refrigerant at the inlet of the expansion valve. none of these answers. O the amount of the refrigerant in the сycle.
The food storage room requires a cooling system with a capacity of 10 tons of refrigeration that operates at an evaporator temperature of -9.2 ° C and a condenser temperature of 28.6 ° C. The refrigerant used is R-134a and the system operates in saturated conditions. a. COP =b. Refrigerant flow rate = kg / s. c. Heat loss rate in the condenser = kJ / s.
Calculate the mass flow rate of the refrigerant.
8) Which of the following components is NOT within the refrigeration cycle?A: Expansion valveB: CompressorC: EvaporatorD: Extractor
The food storage room requires a refrigeration system with a capacity of 15 tons of refrigeration which operates at an evaporator temperature of -17.5 ° C and a condenser temperature of 37.0 ° C. The refrigerant used is R-134a and the system operates at saturated conditions. A. COP = Answer. b. Refrigerant flow rate = Answerkg / s. c. Heat loss rate in condenser = AnswerkJ / sec.
The type of condenser in which the steam and cooling water flow from top to bottom and mix is called O a. central flow surface condenser Ob. down flow surface condenser evaporative surface condenser O d. parallel flow jet condenser
The subcooling temperature in a condenser can be measuredby taking the difference between theA. suction pressure converted to temperature and theboiling refrigerant.B. boiling temperature and the condensing temperature.C. condensing temperature and the leaving-refrigeranttemperature.D. condensing temperature and the entering-refrigeranttemperature.
The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that operates at an evaporator temperature of -17.5 ° C and a condenser temperature of 42.5 ° C. The refrigerant used is R-134a and the system operates in saturated conditions. a. COP = b. Refrigerant flow rate = kg / s. c. Heat loss rate in the condenser = kJ / s.
What are the advantages of using cascade refrigeration? I.Higher required pressure differences for compressors II.Higher variety of refrigerants as working fluids per cycle. a. Il only b. Both I and II c. Neither I nor II d. I only