12 13 4 24V R1 R4 100 20n 300 40 0 -1

Q: A 10 Q and a 20 Q resistance are connected in parallel. Another resistance of 5 Q is connected in…

A:

Q: A 9-ohm resistance is connected in parallel with a 14-ohm resistance. Another set, a 7-ohm and an…

A:

Q: A 600 meters copper wire is to be used for a three loads that dissipates 1600W, 795W, 1560W power…

A: Dissipation of power is the process through which heat is produced by electric or electronic…

Q: What is the equivalent resistance in ohms between points A and B? All resistances are in ohms * A…

A:

Q: A nine volt source is used to power 2 electrical devices that are linked in parallel.The source's…

A: Circuit diagram as per our requirement :

Q: string of two 1,000 ohm resistances is in series with a parallel bank of two 1,000 ohm resistances.…

A:

Q: A wire has a resistance R are cut into 2 pieces and the small pieces are connect in parallel…

A: resistance is directly proportional to length of the wire . if two resistors R1 , R2 are connected…

Q: What is the equivalent resistance in ohms between points A and B? All resistances are in ohms *

A: The solution can be achieved as follows.

Q: Two resistance of 1500 ohms and 4700 ohms are connected in parallel. What is the equivalent…

A: Consider the formula to obtain the equivalent resistance. R=R1R2/(R1+R2)

Q: Instructions : Write the answer in the paper only. Do not write any answer in the box. Problem : Two…

A:

Q: mine the voltage at stor RZ. (assume Zener voltage is 4 volts and LED forward voltage is 2.0 Volts)…

A:

Q: Two resistors 2.50 and 1.20 are connected in parallel and take a total current of 60A. Find the…

A: It is given that:For Series circuit equivalent resistance isFor parallel circuit equivalent…

Q: A 25mv, 2mA dArsonval movement is to be used in voltmeter whose full scale reading is 100v. The…

A: Given a voltmeter with, Meter current, Im = 2 mA The voltage across it, Vm = 25 mV So meter…

Q: What Rx in parallel with 40 ohm will provide and Req of 24 ohm?

A: *Voltage across the resistances that are in parallel is same but current is divided according to…

Q: Derive the voltage division law between series resistors.

A:

Q: WHEN CURRENT FLOWS THROUGH A RESISTOR, THE CURRENT WILL FLOW FROM NEGATIVE TO POSITIVE TERMINALS…

A: FALSE.  When a current flows through a resistor, voltage will drop across it. That means voltage…

Q: Describe how voltage, current and resistance behave in a parallel circuit

A: Parallel circuit: The parallel circuit are those in which all the circuit elements are connected…

Q: Confused on how to measure each resistors current using tinkercad...can someone help me with this?

A: Need to provide details of connecting the multimeter for current measurement in tinkercad tool

Q: A-In a Wheatstone bridge the actual resistance values of ratio arms are not known, but their ratio…

A: A wheatstone bride is a circuit that is used to measure the Unknown resiatance .    Answers below.

Q: Now, double the value of R1 and R2. Disconnect the load and make sure that VNL (No Load) is the same…

A: Take the following actions to find out if the loaded voltage divider with doubled R1 and R2 values…

Q: A galvanometer with an internal resistance of 7 ohms is connected in parallel to an unknown resistor…

A:

Q: Find the individual (not combinations of ) elements (voltage sources and/or resistors) that are in…

A:

Q: Determine the voltage across R1 in the figure below, if the source is 10 volts, the Zener is 6.8…

A:

Q: A 12 V battery of 0.05-ohm resistance and another battery of 12 V and 0.075-ohm resistance supply…

A: In this question, We need to Draw the circuit and apply the Kirchhoff's law to solve the unknown if…

Q: Two resistance are R1=10 ohm, tolerence5% R2=15 ohm, tolerance is 3% Determine the result along…

A: Given: R1=10 Ω±5%R2=15 Ω±3%

Q: Voltage sources in series Select one: a. When two or more voltage sources are connected in parallel,…

A:

Q: A circuit contains a 1200-ohms, a 2200-ohms, and a 3300-ohms resistor connected in parallel. The…

A:

Q: The total current drawn by a circuit consisting of three resistors connected in parallel is 12 A.…

A:

Q: If R₁ = 362 and R2 = 7502 each having a tolerance of ± 5% are connected in series. Then the value of…

A: Given Data:Here, we have been given two resistors  and  each has a tolerance of Required Data:Here,…

Q: A secondary cell having an end of 2v and internal resistance of 1amp is connected on series with a…

A: Resistors, inductors and capacitors form an integral part of any electrical circuit. A source,…

Q: Draw the resistor schematic symbol. What is the reason of the materials resistance in the circuit?…

A: In these question we have to give resistance symbol ,reason behind resistance and it's SI unit.

Q: How to reduce a simple series-parallel resistance circuit to a single equivalent resistance, and…

A:

Q: The circuits terminal voltage is 16.7V and then resistors A&B are in parallel. The resistance of…

A: Basic electrical circuit problem is solved as shown below.

Q: Write down the steps on how to Parallel Resistors Current Division

A:

Q: Two or more resistors

A: Ohm's law states that the current through a conductor between two points is directly proportional to…

Q: Can I see an example of how to measure a load voltage and current using breadboard with multimeter

A:

Q: 1. A 5-ohm resistance is connected in parallel with a 10-ohm resistance. Another set, a 6-ohm and an…

A: Concept: When two resistances are connected in series then equivalent resistance Req= R1+R2When two…

Q: 3. Two resistances of 100 and 150respectively are connected in parallel. The two are then connected…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.