11. Refer to the graphic C. Answer the following question. The circuit has a total current of 100 mA. Determine the source voltage. 80 Volts 70 Volts 37 Volts 40 Volts

Q: Current is being discussed. Technician A says that DC current is produced in a sine wave. Technician…

A: Ac current is alternating current which has both positive and negative values. Which means that AC…

Q: 13. What are commonly used to perform two functions in a circuit? a. resistors b. rheostats c.…

A: Elements that perform two function in a circuit.

Q: What is the current through the resistor RC, IC, in amperes?  (Enter the number, not the units.

A:

Q: 79. Which of the following formulas can be used with Ohm's law to determine the amount of voltage…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: 4.1 Calculate the current on the LED D1 4.2 Calculate the current on the LED D2 4.3 Calculate the…

A:

Q: -) In the following circuit using Kirchhoff's find: a) The current in each branch of the circuit. b)…

A:

Q: 20. Refer to graphic H. What is the resistance needed to be equivalent to the circuit in the box,…

A:

Q: A DC electrical circuit with a 24-volt power supply has two resistors in series of 150 ohms and 430…

A: Let us find the voltage drop across the 430 ohm resistor using ohm's law and finding the current in…

Q: What is factor of a cable at 5 degrees celcius when calculating resistance

A: The solution is provided in the following section.

Q: 48 15 e 9) Use The Path abefa to determine the Current throog the b) Determine the emf of the…

A: ELECTRICAL NETWORK: When addressing a circuit problem or constructing a balanced circuit, the word…

Q: Question 27 To turn on all the LEDS with the instruction "OUT AL, 7B", AL should be first set to 7B…

A: Given OUTAL 7B So AL will assign 7B value

Q: What is the resulting voltage when you connect two 9- Volt batteries in parallel?

A:

Q: A voltage sources an IR drop across a 20 ohms R1, 60 volts across a 30 ohms R2, and 180 volts across…

A:

Q: Immediately after the switch is closed: a) Rank the brightness of the light-bulbs from brightest to…

A: According to the question, we need to find the brightest and dimmest.

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.