11. A ping wall, having a diameter of 3.6 cm and weighing 2.4 g is served with a horizontal velocity of 10 m/s and a spin that gives rise to a coefficient of lift of 0.2. Assuming the density of air to be 0.129 x 10-2 gf/ cc. The lift experienced by the wall is nearly (a) 13 gf (c) 0.13 gf (b) 1.3 gf (d) 0.013 gf

11. A ping wall, having a diameter of 3.6 cm and weighing 2.4 g is served with a horizontal velocity of 10 m/s and a spin that gives rise to a coefficient of lift of 0.2. Assuming the density of air to be 0.129 x 10-2 gf/ cc. The lift experienced by the wall is nearly (a) 13 gf (c) 0.13 gf (b) 1.3 gf (d) 0.013 gf

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectuangular wooden beam ( fb = 7.0 MPa, E = 12.9 GPa) ha s across-sectional area of300 mm by 600 mm. The beam has a simple span of five meters. A vibrating machine weighing800 kg is located at the midspan. The machine is working under a constant force of 500 N andaccidentally stopped after 0.7 sec (rectangular pulse). Determine the following:Stiffness, ? = _____________________Angular natural frequency, ?? = _________________ Displacement at t = 0.7 seconds ?(? = 0.7) = _______________________Displacement at t = 1.5 seconds ?(? = 1.5) = _______________________(???)? = _______________
Prob. 4 Consider a slender 2 meter uniform homogeneous 7-kg bar that rests on, and makes 45-degree angles with, a smooth vertical wall and a rough horizontal floor. What is the minimum coefficient of friction required to prevent the bar from slipping?
4. The 50-kg uniform pole is on the verge of slipping at A when 0 = 45°. Determine the coefficient of static friction at A. 8'm 5m
1. A bundle is projected 10 m upward on a 0.26 rad inclined plane so that it reaches the top of the plane with zero velocity. Knowing that the coefficient of kinetic friction between the package and the incline is 0.08, determine (a) the initial velocity of the package at A, (b) the velocity of the package when it returns to its original position.
A rectangular tank 7m long by 2.4m deep and 2.65m wide, contains 1.2m of water.If the linear acceleration horizontal in the direction of the tank's length is 2.75m/s²a) Compute the total force due to the water acting on each end of the tankb) Show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid massc) If the tank is filled with water and accelerate in the direction of its length at the rate 1.72m s³, how many litres of water are spilledd) What is the maximum acceleration should be to keep no water will spill out
An equilateral triangular plate of side 2.4m placed horizontally in a liquid (sp. gr. 0.80) in such a way that the center of the plate is 2.5m below the free surface of water. (a) Determine the area (in sq. meters) of the plate. (b) Determine the magnitude (in kN) of the resultant force on the plate.
A crate of 400 lb is resting on a rough horizontal surface having a coefficient of friction of 0.40.Determine the force P required to cause a motion to impend if applied to the crate on thefollowing listed below.a. Horizontallyb. Downward at 30° with the horizontal
A tank containing water moving horizontally with a constant linear acceleration (3.5m/sec2), and vertical acceleration decreases by (25%) from the horizontal acceleration. The tank was (3m) high, (2.5m) length and (1m) width. Determine the force on the bottom of tank if the water level at rest was (2m)
Complete solution, please. Thanks!
H.W. 6.32 Q: in a (45°) bend a rectangular air duct of (1) m² cross-sectional area is gradually reduced to (0.5) m² area. Find the magnitude and direction of the force required to hold the duct in position if the velocity of flow at (1) m² section is (10) m/s and pressure is (2.943) N/cm². Take density of air as (1.16) kg/m³. 66
2. A semi-cylindrical concrete structure having a radius of 3 m and length of 5 m is rested on ground. Wind (air having a density ρ=1,2 kg/m3 ) at a free-sream speed of 10 m/s with an atmospheric pressure of 100 kPa far upstream the structure blows over the structure. The air entrance to the structure is at ground level corresponding to the forward stagnation point . Since the magnitude of minimum pressure is acting on the top of the structure determine the magnitude of lift force due to the pressure difference in vertical direction .Assume flow potential
, shown below is being hoisted up with the force 1. The cylinder of weight, W= 380 kN F against the vertical wall. If us = 0.57 Ms W Ms a. Determine the reaction force (resultant of normal force and frictional force) against the vertical wall. b. Calculate the force, F, needed to set the cylindrical roller in motion.