11- The weight of the gate separating the two fluids is such that the system shown in Figure is at static equilibrium. If it is known that F1/F2 = 1.70, determine h/H. SG= 0.86 H F₂ SG = 1.25
Q: Piston 1 in the figure has a diameter of 0,25 in.; piston 2 has a diameter of 1,5 in. In the absence…
A: Diameter of piston 1 , d1 = 0.25 in , r1 = 0.125 in Diameter of piston 2 , d2 = 1.5 in , r2 = 0.75…
Q: d = 6mm d = 15mm The left common carotid artery (shown) has an axisymmetric constriction because of…
A:
Q: A simple hand-operated hydraulic press can generate a pressure of 6.O X 109 N/m2 If the system is…
A: Let, P be defined as the pressure, V be defined as the volume, ΔV be defined as the change in…
Q: 5 The tube shown in the figure below is called Venturi tube which can be used as a fluid flowmeter.…
A: (a) Using equation of continuity,
Q: A hydraulic lift is used to jack a 960-kg car 41 cm off the floor. The diameter of the output piston…
A:
Q: A person who weighs 671 N is riding a 85-N mountain bike. Suppose the entire weight of the rider…
A: Given data: Weight of person = 671 N Weight of mountain bike = 85 N Pressure in each tire (P) =…
Q: Part A The concrete "gravity dam is held in place by its own weight (Eigure 1). The density of…
A:
Q: Ex./2: Find the increase in pressure required to decrease volume of mercury by 0.001% (Bulk modulus…
A: We need to compute-Increase in pressure(dP)=?The data given as-Change in volume (decrease)=dV=0.001%…
Q: QUESTION 9 An empty 80-g can with a base radius of 8.0 cm and a height of 15 cm floats upright in…
A:
Q: Question 1 A differential manometer shows the following readings: a = 1.1m, b = 0.8m and h = 0.08m.…
A:
Q: Determine the kinematic viscosity of a liquid having a dynamic viscosity of 1.2 Ns/m2 and a specific…
A: Viscosity is a parameter of a fluid that defines the resistance of a fluid against flow. Viscosity…
Q: 4. The plunger and the needle of a syringe have areas 0.250 cm^2 and 0.0003 cm^2, respectively. To…
A: we are given area of plunger AP = 0.25 cm2 area of needle An = 0.0003 cm2 Force applied on the…
Q: The buoyant force on a sailboat in seawater (Psw=1.03gcm3) is _______ in freshwater (Pfw=1.00gcm3).…
A:
Q: Draw a FBD for this scenario. The buoyancy force, FB, points up. The weight of the anchor, W, points…
A: The direction of the buoyant force (FB) is upward.The direction of the weight (W) of the anchor is…
Q: Calculate the absolute pressure at an ocean depth of 1.0 km. Assume that the density of Water Pwater…
A: Given, Depth of the ocean = 1 km = h Density of water = ρW = 1.025×103 kg/m3 Atmospheric Pressure =…
Q: A regular solid of height 30.0 cm is placed in water of density 1 gram/cm^3 and 7.00 cm of its…
A:
Q: Q4: The pressure of a pipe needs to be minimized using the Aspen optimization tool. Write how you…
A: Answer..
Q: a.) What minimum force must you exert to lift a car of mass 1500 kg. If rout = 0.71 m and Ain = 0.2…
A:
Q: .. BIO Predict/Calculate The patient in FIGURE 15-41 is to receive an intravenous injection of…
A: In the given scenario, an intravenous injection of medication needs to be administered to a patient…
Q: a- Determine the magnitude of the force Fin that the small piston exerts on the fluid in the small…
A:
Q: A dentist's chair with a patient in it weighs 1720 N. The output plunger of a hydraulic system…
A:
Q: Two chambers are filled with a fluid. The ceiling of chamber 1 is at the same level as the floor of…
A:
Q: A pulley-load system is used to open and close the gate AB as shown. The gate is 5 m long and 2.5 m…
A: force act on a wall is F= Pav A A= WL Pav= ρliq x g x h / 2 L= h cos 30…
Q: The ratio of the diameters of the two pistons in a hydraulic press is 1:4. What is the area ratio,…
A: We have, Given that ratio of diameters of two pistons in a hydraulic press is 1:4. Ratio of the…
Q: An input force of 300 N is applied to a hydraulic jack piston that is 0.033 m in diameter. If the…
A: F1= 300 N d1= 0.033 m d2= 0.25 m g= 10 m/s2 A hydraulic system follows the following expression: F/A…
Q: An object hangs from a spring balance.The balance registers 32 N in air, 22 N when this object is…
A: Weight of the object is 32 N Apparent weight in the water is 22 N Apparent weight in liquid is 25 N
Q: 4. Assume that the pressure acting on the back of a swimmer's hand is 120 000 Pa which its surface…
A: 4 Consider the given data as below. Pressure, P=120000 Pa Surface area, A=84 cm2=0.0084 m2…
Q: What is the greatest average speed (in m/s) of blood flow at 37° C in an artery of radius 1.60 mm if…
A: Given data : T = 37°C R = 1.60mm Flow is laminar Density, p = 1050kg/m3 To find : Greatest…
Q: FTS Oil with viscosity 6.8 x10 lbs and specific weight 5716. flows through the funnel below…
A: Total heigh of the fluid column H = 1.6 in
Q: 1. A common nonstandard metric unit of fluid volume or capacity is the blank? 2. An object will…
A: As per guidelines, the three questions have been answered.
Q: 1 m 2 m E 2 m H 1 m -2 m -1 m-
A:
Q: A kidney machine has a membrane permeability coefficient wRT = 0.5 x 10^-3 cm/s. If the membrane…
A: Given: The membrane permeability coefficient of kidney machine, ωRT=0.5×10-3 cm·s-1. Area of the…
Q: a.) What minimum force must you exert to lift a car of mass 1500 kg. If rout = 0.71 m and Ain = 0.2…
A: Mass of car, m = 1500 kg Inner area, Ain = 0.2 m2 Outer radius, rout = 0.71 m Distance, d2 = 25 cm =…
Q: As the initially empty urinary bladder fls with urine and expands, its internal pressure increases…
A: Given: The internal pressure increases by 3900 Pa. The edge length is 0.0091 m.…
Q: A hydraulic piston assembly filled with hydraulic fluid, has 2 pistons, 1 with an area of 1 m2, and…
A: GivenArea of Piston 1, A1=1 m2Area of second piston, A2=10 m2Force applied on piston 1, F1=10 N
Step by step
Solved in 2 steps with 2 images
