104. The nominal T'circuit of a transmission line has R = 10 Q; X = 20 22 and Y = 400 µS for each phase. The generalised constant of the line is (1) 22-25 Z63-45° 2 (ii) 16-5238-5° Q (iii) 7.62 14.5° (iv) 11-4223-2° 2

104. The nominal T'circuit of a transmission line has R = 10 Q; X = 20 22 and Y = 400 µS for each phase. The generalised constant of the line is (1) 22-25 Z63-45° 2 (ii) 16-5238-5° Q (iii) 7.62 14.5° (iv) 11-4223-2° 2

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: Calculate and graph the random process power spectral density given by x(t) = sen(100*pi*t + phi)…

A: First we will find out auto correlation then by taking Fourier transform of autocorrelation we will…

Q: For an end condenser transmission line representation, transmission parameter A is

A: Given, An end condenser transmission line. The transmission parameter A is ?

Q: Three phase star connected system has I = 1040, I = 104270 c=154135 determine the Symmetrical…

Q: If T = 0.6260° and A = 20cm find the position of the second voltage maximum on the line. Select one:…

A: In this question we need to find a position of the second voltage maximum on the line

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: We will find out the characteristics impedance for given transmission line with give open circuit…

Q: X4 3 X3 XG1 1 (F) X2 X5 Figure 1 Table 1 Component Reactance (pu) X1 0.1 X2 0.2 X3 0.3 X4 0.4 X5 0.5…

A: In this question we need to find a short circuit capacity for the given system. We replace the given…

Q: For the circuit shown below the admittance parameter matrix [y) is 30 20 10

A: A port is a pair of terminal. A two port network have two port that is input port and output port A…

Q: The B parameter of transmission line is obtained from O a. the open circuit test at the sending end…

Q: single phase transmission line has two parallel conductors 1.5 meters apart with 2.5cm diameter. The…

A: We know direct formula for loop inductance ,we will use that formula to find loop inductance.

Q: IA 5.) J₁ ION 1₂ забу 12V Find Is. In, and Iz using nodal and Cramer Rute

A: Given: Using Nodal analysis and Cramer's rule find all the currents.

Q: Find Y bus ?

A: In this question , we have to find out Y bus from given data..

Q: dax dta x = A = 2 + W₂²x = 0 Wo X Ae jw a tjb real imaginary part Xz Acos wt Χτ where How did they…

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: Frequency = 1.5 kHz Length of transmission line Zoc = 800∠-50° Ω Short circuit impedance Zsc =…

Q: 10 co s(2ot +45) SP1O :A transmission line is driven by a source voltage lts = The L = 5Hm and C = 4…

Q: A 125 m cable weighing 2 kg.s per m is suspended between two towers at the same level. The sag is 3…

A: Given cable length = 125 m sag =3 m arc-length =2a×sinhx2a

Q: Consider a step down converter with a resistive load. It is supplied by a DC power source of…

A: f (switching frequency) = 1 / 0.25 ms or = 4 kHz L (inductance) = 10 mH = 10 * 10^-3 H k = 0.5R =…

Q: The answers according to the book are 0.285 -j0161, - 456, 1.7

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

A: Given,At frequency 1.5 kHz,The open circuit impedance is,Zoc = 800∠-50° ΩandThe short circuit…

Q: For the transmission line below find Zin.Assume the frecuency of operation is 1GHZ and velocity of…

Q: A short circuited stub is shunt connected to a transmission line as shown in the figure is, if Zo =…

A: Solution is done according to the problem !!

Q: 2. Determine the Z-parameters for the network shown if Ra=10 02, Rb-2002, Rc-400, and B-5 V₁ Ra Re…

Q: What is the electrical length of the transmission line measured from the source to the load if the…

Q: For 0 <(<0.69, natural frequency when the system pole moves away vertical. jo s-plane w = 0, V1-5? O…

Q: * for a distortionless line a does inversely depend on frequency O linear depend on frequency O not…

A: A distortion less line is the one in which there is no attenuation and delay distortion. The…

Q: 12-10. Determine the SWR for a 50-02 transmission line that is terminated in a load resistan ZL = 75…

Q: 5. Use Routh Hurwitz criterion for following system, is the system stable o Unstable? Why? SA+ 2S³+…

A: Given the characteristics equation, s4+2s3+6s2+8s+5=0.

Q: 1. Solve for the loop currents I1,12 & 13. (a) what are the loop current equations (b) use Cramer's…

A: given here a circuit and asked to write the loop current equation. and by using crammers rule and…

Q: Simplify the following complex numbers. (Write your answers in rectangular form a. i257 + i388 + i4…

A: The solution is given below

Q: The transmission line with Z0-5092 is connected with a load Z₁=15+j209. Please use Lumped-Element…

A: Given the data, Z0=50 ohm load impedance ZL=15+j20 Ω f =2.4 GHz

Q: A54 conductors/phase single phase line has a GMR of 15.9mm and a GMD of 2.3m. The axial length is…

A: In this question we will find total inductance of single phase line.....

Q: 4. The characteristic impedance of a transmission line with impedance and admittance of 16 and 9…

A: In this question, We need to choose the correct options What is characteristics impedance Zc?

Q: Calculate magnitudes and angles for the line currents IaA, IbB, and IcC.

Q: A single-phase transmission line consists of 3 wires for the forward path and 2 wires for the return…

A: The above question is based on the inductance L of a transmission line given by mH/kmGMR or…

Q: This is the third tym that I post it all time the given answers was wrong and was chat gpt or I…

A: First, we need to normalize the load impedance. Normalization is done by dividing the load impedance…

Q: At a frequency of 1.5 kHz, the open circuit impedance of the length of the transmission line is…

Q: Exercise 3.2: A ring of radius R has a uniformly distributed charge q as shown in the figure.…

A: In this question we need to find a electrical field at point P

Q: xplain how increasing the frequency affects: a. The total impedance of the circuits b. The phase…

A: The total impedance of an AC circuit and the phase angle between the generator voltage and the…

Q: 6. A 4.6-kV, three-phase transmission line is 100 km long. This line has a per-phase series…

A: In this question, We need to determine the sending end voltage using the short line approximately.…

Question

104. The nominal T'circuit of a transmission line has R = 10 Q; X = 20 22 and Y= 400 µS for
each phase. The generalised constant
of the line is
(1) 22-25 Z63.45° Q
(ii) 16.52 Z38-5° Q
(iii) 7.62 14.5° Q
(iv) 11-42 223-2°

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transmission Line Parameter and Scattering Parameter (S-parameter)

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

step by step solution and explain the process please no AI answer. handwritten very much appreciated
2. Determine V and I of a short transmission line, if Z is... a. -300 +1200 22 and 200- j300 are in series then in parallel with a 400 resistor b. 2002 is in series with 5H and 15µF that are in parallel j320 230230° 60Hz 2002 I M N V
At a frequency of 1.5 kHz the open circuit impedance of a length of transmission line is 800∠−50◦ and the short-circuit impedance is 413∠−20◦ . Determine the characteristic impedance of the line at this frequency.
Thankssssssssss :D
I am trying to find the character impedance and wave propagation speed on the line and do they depend on frequency? Thank you for the help.
I need the answer quickly
In a symmetrical component method, the operator λ has a magnitude of unity and rotation through 120°. Find 0.5-j0.866 0.5+j0.866 -0.5+j0.866 0 -0.5-j0.866
A 1-phase transmission line has two parallel conductors 1.5 meters apart, the diameter of each conductor is 0.5 cm. Calculate the per phase inductor and the per phase capacitor for a line length 80 km.
3:54 Lpdf - Adobe Acrobat Reader DC (64-bit) Sign Window Help ETEEAP FINAL EXA... x 8 (₂) 1/1 135% & D ANALYSIS Instruction: Solve the following. Show your solution and box your final answer. 1. A 3 phase, overhead transmission line has a total series impedance per phase of 200 ohms and a total shunt admittance of 0.0013 siemens per phase. The line delivers a load of 80 MW at a 0.8 pf lagging and 220 kV between the lines. Determine the sending end line voltage and current by Rigorous method. 2. Obtain the symmetrical components of a set of unbalanced currents: IA = 1.6 425 IB = 1.0 4180 lc = 0.9 4132 3. Given Vo = 3.5 2122, V₁=5.0-10, V₂ = 1.9 292, find the phase sequence components VA, VB Vc. 4. The following are the symmetrical components of phase B current. Positive sequence component 10 cis (45°) Negative sequence component = 20 cis (-30°) Zero-sequence component = 0.5 + j0.9 Determine the positive-sequence component of phase A. ||| O □ Q
Determine z-Bus For the Network eee lee joz 13) jol5 13 1, jisg ら

The ABCD constants of a 3-phase line are: A = D = 0.98182 + j0.0012447, B = 4.035 + j 58.947 and C = j0.00061137. If the sending end voltage is 387.025 kV L9.542o and the sending end current is 529.29 Amp L-27.325o. Find the receiving end voltage and current delivered to the load.
Given a 50MVA, 3.3kV generator has a synchronous impedance of 10%. Find the per unit impedance on a base of 100 MVA and 5 kV. None of these 1 Z pu= 8.7%.20 Z pu=0.87 pu 30 Z pu=0.087 pu