100 mm 85 mm 40° 60 mm

Q: There is a wooden beam AD, as shown in the figure below, the Flexural Rigidity of the beam section…

A: Figure is as shown

Q: Given the figure, find the tension at A, B, C, D in Newton. The other photo is the continuation of…

A:

Q: Question # 3: The built-up beam is formed by welding together the thin plates of thickness 3 mm. the…

A: Shear center is a point on the beam section where the application of loads does not cause its…

Q: Determine the internal forces at point J for the structure shown, where member BD can only carry…

A: Given:- a=160 mmP=450 N To find:- Internal force at point J

Q: The length of 2-mm diameter steel wire CD has been adjusted so that with no load applied, a gap of…

A:

Q: Problem 4 The shown bent tube is connected to a guide at A and rests on a roller support at B. It is…

A:

Q: There is a beam as shown in the figure below, and the flexural stiffness of the beam section is…

A:

Q: The following truss system is Pin Supported at Joint C and Roller Supported at Joint E. Joint B is…

A: A structure is a structure or a frame that is connected in a triangular shape and all members act as…

Q: Both portions of the rod ABC are made of an aluminum for which E = 69.2GPa. Knowing that the…

A: Determine the value of P (in N) so that the deflection at A is zero.

Q: For certain values of w and P, the maximum positive bending moment in the beam is +7044 lb-ft, and…

A: Here,                M = 7044 lb.ft                 Iz  = 18.3990 in4 For positive bending moment,…

Q: The resultant of the three forces as shown in figure is vertical. determine the angle 0, and…

A: All data present in the figure Need to find 1- Resultant force (R)2-  angle ()

Q: The rigid bar BDE is supported by two links AB and CD. Link AB is made of aluminum (E = 70 GPa) and…

A:

Q: ep in digital format plea

A:

Q: 3. Rigid member ABD is connected to elastic member CDE as shown. Fo the given loading, what are the…

A: Given Data: E=70 GPa=70×103 N/mm2A=100 mm2CD=0.4m=0.4×1000=400 mm2DE=0.2=0.2×1000=200 mm2

Q: SOLVE STEP BY STEP IN DIGITAL FORMAT Determine by the method of nodes the forces at which all the…

A:

Q: The cross-sectional area of each member of the truss shown in the figure is A = 400 mm² and E = 200…

A: Area of members, Modulus of elasticity, To find:(a) The vertical displacement at joint C under…

Q: The force in the member AC of the frame as shown in figure given below is [Take AE as constant for…

A: At Joint A

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.