10. The plug and empty cylinder shown in figure weigh 1500 lb. Calculate the height h needed to lift th plug if the radius R of the 10-ft-long cylinder is: (a) 12 in. (b) 16 in. (c) 20 in. R Water 15 ft Plug

Q: The horizontal nozzle in the given figure has D1 = 12 in and D2 = 6 in, with the inlet pressure p1 =…

A: Compute the horizontal force provided by the flange bolts to hold the nozzle fixed?

Q: TANK TANK DATUM DATUM. DRAW AND LABEL VELOCITY HEAD DRAW AND LABEL PRESSURE HEAD (STATIC) Pressure…

A:

Q: Include all necessary FBD

A: Co-efficient of FrictionThe Coefficient of friction is the measure of the relative surface…

Q: A Pitot tube shown in the figure below has air of velocity V flowing as shown. If one of the…

A:

Q: Water exits a pipe as a free jet and flows to a height "h" above the exit plane. The flow is steady,…

A:

Q: Use Moment Distribution to determine all final member-end-moments for the continuous beams given…

A: We will calculate the final member-end moments, reactions, and create the shear and moment diagrams.…

Q: Calculate the hydrostatic force and components of the semicylindrical protuberance located at the…

A: height of water in tank = 10 ft.radius of semi-circular cylinder = 2ft.length of cylinder = 9 ft.…

Q: t’s required to determine the height (H) when the flow is 120 L/s ؟

A: Flow rate Q = 120 L/s Area A = π4*0.252 = 0.049 m2  V = 1200.049 = 2.45 m/s Calculation of 'Re'  Re…

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.