10 mm 5 KN-m 40 mm 5 KN-m 150 mm 15 mm 120 mm Determine (a) the centroid location, the moment of inertia about the z axis, and the controlling section modulus about the z axis. (b) the bending stress at points H and K. State whether the normal stress is tension or compression. (c) the maximum bending stress produced in the cross section. State whether the stress is tension or compression.

Q: The prismatic bar has a solid circular cross section with 2-in. radius. Determine the average normal…

A: Given data : Radius (r)=2

Q: The rigid bar EFG is supported by the truss system shown. Knowing that the member CG is a solid…

A: Given Load PSpan 12 ftTo find out Normal stress in CG

Q: Which of the following is NOT TRUE as an assumption in the elastic analysis of circular members…

A:

Q: The beam is loaded by one couple at each of its ends, the beam cross-section shown below (Figure…

A:

Q: 5- The solid rod is subjected to the loading suown. Determine the state of stress at point A, and…

A: Given : Determine the state of stress at point A and show the results on a differential volume…

Q: A B C 80 kN 2 m 50 kN D E F -1m--1 m--1 m--1 m-|

A:

Q: 3. Determine the required diameter of the pins at A and B to the nearest 1mm if the allowable shear…

A:

Q: the stress system shown, calculate the magnitude of the shear stresses on Ty and the angle a, (72…

A:

Q: 9-3. The state of stress at a point in a member is shown on the element. Determine the stress…

A: To determine the stresses acting on the shown plane AB.   The stresses acting on the plane AB can be…

Q: HW. 9-3. The state of stress at a point in a member is shown on the element. Determine the stress…

A:

Mechanics of Solids

It is the study of the behavior of solid materials, their characteristics under various circumstances such as variation in external forces, temperature, and other internal factors. It is one of most important study in the field of engineering science, especially chemistry and mechanical engineering. In rigid body, the idealization of the solid body in which deformation is neglected. Deformation is known as the force acting on the solid state system which exerts change in its shape of the body but it continues to be at rest or in a uniform motion but it cannot accelerate. But those solid systems do have elasticity, compressibility and can be bent. This field is very vast since there are wide range of materials around us.