10 + A (kN) 3 + B (kN/m) A C D с (m) -3 m- 3 m - 4 m 2 m 7. Determine the horizontal reaction at A. (N) 8. Determine the vertical reaction at A. (N) 9. Determine the reaction at C. (N) 10. Determine the reaction at E. (N)

Q: Comment on the relationship between the depth of the center of pressure and the depth of immersion.

A: The center of pressure measured from the free surface, is given by: Cp = hc + IGA.hc Here, Cp is…

Q: SAMPLE PROBLEM The fink truss shown is supported by a roller at A and a hinge at B. The given loads…

A:

Q: 2 +Y 1+Z +X the letter corresponding to the view on the right that shows the result of rotating the…

A: To indicate the correct option among the given answers

Q: It is required to layout the front corners of a building with distance of 210.08 feet. The tape used…

A:

Q: 38. The wagon wheel has a diameter of 28 inches and an angle of 30° between the spokes. What is the…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: Locate the centroid of the shaded area between the two curves y y = k, x x = k, y² X% D 2 - 0. 13

A: The given figure is shown below:

Q: This is a photograph of Claude and Holly Duval from Montreal in Canada. They are on holiday in New…

A: Step 1

Q: Q2/ A page of a level book with some missing readings is reproduced below. Fill in the missing…

A: Given data Back sight Intermediate sughts Fore sights. R.L. I ll use rise and fall method to solve…

Q: Calculate the flight height above average terrain that is required to obtain vertical photographs at…

A:

Q: _feedback is used by Schmitt trigger

A: Schmitt trigger is a comparator circuit with hysteresis.  A Schmitt trigger is a logic input type…

Measuring site work, Excavation and Piling

Bid drawings typically include very little material about the precise requirements of site work operations, measuring site work and excavation work differs from measuring most other works on a construction project. The actual site work conditions are not provided and also the dimensions of the excavations are not known during the pre-construction phase. The precise measurement of the excavation and backfill of the earth material and topsoil is important for a contractor to decide upon the total cost required for the process. All the works should be carried out under OSHA (Occupational Safety and Health Administration) standards to ensure the safety of the workers.