10 30 50 Wa (1000 rad/s) In an alternating current circuit, the current amplitude versus driving angular frequency wa is shown in the figure. The inductance is 200 µH. What is the capacitance of the circuit approximately? the 100 uF 10 F 10 μF 1.25 uF 8F 1.25 F 8 µF 100 F None of them I (A)

10 30 50 Wa (1000 rad/s) In an alternating current circuit, the current amplitude versus driving angular frequency wa is shown in the figure. The inductance is 200 µH. What is the capacitance of the circuit approximately? the 100 uF 10 F 10 μF 1.25 uF 8F 1.25 F 8 µF 100 F None of them I (A)

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: 2.5 0, L = 5.0 mH, and C = 500 pF. What is the angular frequency of the oscillations (in

Q: The rms current in an RLC circuit depends on the frequency of the power source as shown below. It…

A: The rms value of voltage is calculated as, Vrms=ImaxZ Where Z is the impedance. Z is calculated as,…

Q: In the circuit from problem 2, what is the rms power? O 1.26 W O 2.53 W 9.57 W O 4.78 W

A: RLC SERIES CIRCUIT.

Q: An ac circuit is shown in the figure. The rms current in the circuit is 1.3 A. What is the peak…

Q: In a series RLC circuit, the amplitude of the voltage source must be greater than the amplitude of…

A: The amplitude of the inductor's voltage is VL = IXL = IωL where I is current ω is angular frequency…

Q: "In the RLC circuit of the following figure: R = 100 N, C = 0.1 µF, and L = 0.5 Henry. ww QUESTION…

A: Given that, Resistance, R = 100 Ohms Capacitance, C=0.1 μF Inductance, L = 0.5 H The frequency of…

Q: A 11 m H inductor capacitor is connected to Resistor R=13 N and 12.0 V AC. Determine f 100 200 XL…

Q: "In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. QUESTION 16…

A: Resistance R = 100 ohms Capacitance C = 0.1 uF Inductance L = 0.5 H We need to determine…

Q: An electric motor has an effective resistance of 34.6 Q and an inductive reactance of 49.2 Q when…

A: The alternating source is 406v To find the r m s current

Q: What is the inductance of a series RL circuit in which R = 20 2 if the current increases to…

A: Step 1 :The current, i in the circuit becomes 2/3 of its initial value, i0.Now, in terms of the time…

Q: A series RL circuit is connected to an emf source of angular frequency @. The current O is zero. @R…

A: Here is the step-by-step explanation:Step 1: Key Concepts:A. Inductive Reactance (XL)In a series RL…

Q: The I vs t graph shown below is for an LR circuit with a battery. I (A) 18 13.5 9. 4.5 3 6 9 12 15…

Q: an rlc circuit has a resistance of 2.0 k omega, a capacitance of 8.0 uF, and an inductance of 9.0 H.…

Q: A 3-H inductor is connected in series with an AC voltage supply (rms voltage 120 v, frequency f = 60…

Q: An ac circuit is shown in the figure. The rms current in the circuit is 1.3 A. What is the peak…

A: Given Irms = 1.3 A R = 30 ohm L = 190 mH = 0.19 H XL = 60 ohm XC = 120 ohm

Q: URGENT An L-R-C series circuit has inductance 42.0 mH, capacitance C, and resistance R. Without the…

A: Resistance The Greek letter omega () represents the measurement unit for resistance, known as ohms.…

Q: RLC series circuit with V(in) (t) = 12cos (1000t), R = 1 ohm, C = 100uF , L = 2.5 mH . Please use…

Q: Problem In an oscillating LC circuit, L = 1.30 mH and C = 4.51 pF. The maximum charge on the…

A: Given,

Q: A 30V electromotive force is applied to an LR series circuit with .1 henrys of inductance and 50…

A: The expression for the LR series circuit is,

Q: What rms current flows in a 60-mH inductor when 120-V rms ac at a requency of 20 kHz is applied to…

A: Given:- The inductor L = 60 mH The RMS value of the voltage is vrms = 120 V The frequency that is…

Q: For the coaxial line filled with two dielectric media as shown in figure below, a) Find the…

A: Given:inner radius of the conductor, adielectric 1, has permittivity, ε1it has a radius of…

Q: The resistance in an RLC circuit is doubled. (a) Does theresonance frequency increase, decrease, or…

Q: A series RL circuit with R = 41 Q and L = 6 H has a constant voltage E applied at t 0 by the closing…

Q: information given in the figure for the series RCL circuit to determine the phase angle between the…

A: Given R = 150 Ohm L = 0.035 H C = 1.75×10-6 F f = 60 Hz angular frequency ω = 2πf = 2×3.14×60…

Concept explainers

Voltage Across Inductor

An actor is a passive electrical component that consists of a coil bent in the form of wire which uses electromagnetism to produce electric current through the coil. When the electric current flows through a conductor that is the coil, a magnetic flux is developed around the conductor. This flow of current through the coil creates a magnetic field based on Fleming's Right-hand thumb rule. If there is any decrease in the current passing through the inductor, then the magnetic field will also decrease and energy is released through the generation of electric current. There is also a secondary voltage inducing in the same coil due to the magnetic flux, since it opposes any changes in the electric current flowing through the circuit. An inductor is also called choke, coil, or solenoid. A choke is designed to block certain frequencies when the DC current passes. A winding coil is coated with insulation to give extra insulation and protect the circuit. They are usually tightly wrapped around a central core which is cylindrical in nature so that the magnetic flux can be induced. The solenoid is a three-dimension coil that is used to exhibit electromagnetism when the magnetic field is developed due to the current flowing through the coil. The sign convention of the inductor is the same as the power dissipating device. When the current flows into the positive side of the voltage across the inductor, the value is positive and the inductor dissipates power whereas when the inductor releases the power back to the circuit, the current has a negative sign convention. 

Question

100%

10
30
50
Wa (1000
d/s)
In an alternating current circuit,
the current amplitude versus the
driving angular frequency wa is
shown in the figure. The
inductance is 200 µH. What is the
capacitance of the circuit
approximately?
O 100 uF
O 10F
O 10 uF
O 1.25 uF
8F
1.25 F
8 pF
100 F
None of them
O O O O O O O O O
I (A)

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

"In the RLC circuit of the following figure: R = 100 Q, C = 0.1 µF, and L = 0.5 Henry. www QUESTION 21 What is the phase difference between the Current flowing through the circuit and the potential difference across the source at frequency of 1000 Hz? O 86 deg O 80 deg O 72 deg O 68 deg O None of these
The inductance in the drawing has a value of L = 9.0 mH. What is the resonant frequency fo of this circuit? 150 Q fo = Number i Units W L 0000 1.9 F HI-
The value of the rms current is most nearly A. 154 mA The current in the circuit is given by i(t) = I cos[(9580 rad/s)}), where I is the amplitude current. The voltage amplitude of the AC source is 112 V. B. 272 mA C. 384 mA D. 121 mA E. 334 mA R = 335 N C = 0.625 µF L = 75.8 mH
4, 6
Please give a detailed solution Thank you
For the desired resonant frequency of the circuit to be 1.0 kHz? What size capacitor should be placed in series with a 30-N resistor and a 40-mH inductive coil if the resonant frequency of the circuit is to be 1.0 kHz? Ο 0.63 μF Ο 3.3 μF O 4.5 µF Ο 6.0 μF Ο 2.0 μF
You have a series RL circuit. You are trying to decrease the time constant. Which of the values you should increase? Question 5 options: Inductance Resistance
Use the information given in the figure for the series RCL circuit to determine the phase angle between the current and the voltage. 60.0 Hz +90° O Zero degrees O +5.3° -84° 0.035 H -9.6° 1.75 X 10 F HH 150 2.
4, 6