1.42 Link AB is to be made of a steel for which the ultimate normal stress is 65 ksi. Determine the cross-sectional area of AB for which the factor of safety will be 3.20. Assume that the link will be adequately reinforced around the pins at A and B. 600 lb/ft 35° OE B D 5 kips 1.4 ft 1.4 ft 1.4 ft

Q: -5 @ 3m-15m- C F H J K ML boo I A 4@4m=16m B D G E 60 kips A For the truss shown, what is the force…

A:

Q: The cmposite beam is made of 6061-T6 aluminum (A) and C83400 red brass (B). The the height, h=40mm,…

A: Section Properties : For transformed section:

Q: The Link AB must be made of steel with a maximum normal stress of 450 Mpa. Any stress above that…

A:

Q: B D 3 600 lb

A:

Q: 2. The structure is used to support a distributed load of w = 5 kN/m. The bolts at A, B, and C each…

A:

Q: 1.51 In the steel structure shown, a 6-mm-diameter pin is used at C and 10-mm-diameter pins are used…

A:

Q: In the steel structure shown, a 6-mm-diameter pin is used at Cand 10-mm-diameter pins are used at…

A: To find value of load P

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.