1.4 1.3 1.2- 1.1- 0.9- 0.8- 0.7- 0.6- 0.5- 0.4- 0.3 0.2- 0.1 0+ 0 X:0.691 Y:1.249 X:0.394 Y:0.901 X:0.1 Y:0.106 0.5 T 1 1.5 X:2.456 Y:1.002 T 2 2.5 X:3.734 Y:1 T 3 3.5 T 4 4.5 5 5.5 10+ t T 6 6.5 T 7 T 7.5 8 8.5 T 9 9.5 10

Q: (a) X = A + B + C (b) X= (A + B)C (d) X = (A + B) + (AB + BC) (e) X = (A + B)(A + B)

A: Since you have asked multiple questions in a single request, we will be answering only the first…

Q: 120 VRMS www Select one: OA. 300 mA OB. 150 mA OC. 48.7 MA OD. 50 mA OE. 16.67 MA OF. 100 mA OG. 200…

A: The circuit diagram,The current in secondary,

Q: Please do the state table and state diagram

A: We have to complete state table and state diagram : Given:DA=XDB=QAY=QAQB

Q: Eliminate the exclusive-OR, and then factor to obtain a minimum product of sums: (a) D'B'+(DOCA) (b)…

A: “Since you have posted multiple questions with multiple sub parts, we will provide the solution only…

Q: Find the expression for the output function, F. Do not simplify. Vdd- B C B bar B bar A 0 A bar A…

A: According to the question, for the given circuit as shown below We need to find the output function…

Q: 7. Refer to the graphic appendix A. The peak to peak voltage is most near? 35 V 56.5 V 28.3 V 70 V

A: The solution is given below

Q: Given the following module ex1. module ex1 (clk, reset, in, out); endmodule Which of the following…

A: Verilog is a Hardware description language.The verilog used to design and verify the digita…

Q: 3) For the circuit shown in the following figure, Io - I3 are inputs to the 4:1 multiplexer. R (MSB)…

A: Given:I0-I3 are input to the 4:1 multiplexer. R (MSB) and S are control bits. To find :The output Y.

Q: 4. Variables A and B contain the values 0x80 and OxFF, respectively. What will be the content of…

A: Given,Variable A= 0×80Variable B=0×FFandThe instructions are,movlw 0×01movwf Aaddwf B, Wmovf A,W

Q: For the circuit shown below, Binary Number A = 1010 and Binary number B = 1110.  What is the…

A:

Q: Design a code converter that converts a decimal digit from BCD to excess-3 code, the input variables…

A:

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.