1.20 m wide is mounted on the vertical wall of an open rectangular tank filled with oil. The top of the gate is 1.2 m below the surface of oil. What is the minimum force F applied at the top edge of the gate required to keep it close assuming the gate

Q: 3. A 3 rectangular gate is hinged at the top edge A and is restrained by a fixed ridge at B.…

A: Calculated the hydrostatic force exerted on the gate  and the location of line of action of force.

Q: (4) Explain how could you determine the resultant force on a curved surface inmnersed in a liquid?…

A:

Q: A rectangular gate (h = 3.5 m high, w = 5.5 m wide) is hinged at the top edge at A, which is a = 2.4…

A:

Q: A 2-ft-thick block constructed of wood (SG-0.6) is submerged in oil (SG-0.8), and has a 2-ft-thick…

A:

Q: A multifluid container is connected to a U-tube, as shown in the figure. For the given specific…

A:

Q: A solid cylinder made of cast iron has the dimension r = 30cm and h = 2m. The cylinder is to be…

A: Given: Dimension of cylinder: radius (r) = 30 cm, height (h) = 2 m Density of cast iron = 7.3 g/cm3…

Q: A glass tube of intemal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

A: Given that, d=3 mm=3×10-3 mσ=0.48 N/m

Q: ing oil (SG=0.90) with its top surface open to the atmosphere is shown below. determine the…

A: Given:SG=0.90d=4 mw=2 mR=1.5 m

Q: A closed cylindrical tank 2m in diameter and 8m deep with axis vertical contains 6m deep of oil (sp.…

A: Given that: diameter of the tank is 2 m height of the tank is 8 m height of the oil is 6 m specific…

Q: Figure 1 shows a fairly large U-tube manometer containing water (density p= 1000.0 kg.m³) and oil…

A:

Q: The left limb of a U-tube mercury manometer is connected to a water pipe line, with the mercury…

A:

Q: 2- An associate triangular plate of base 3 m and altitude 3 m is immersed vertically in an oil of…

A:

Q: An open tank contains 5.6m of water covered with 3.4m of kerosene (S.G=0.80). Find the pressure at…

A:

Q: An open tank contains y1 = 8.7m of water covered with y2 = 5.7m of kerosene (y=8 kn/m^3). Find the…

A:

Q: er is 1000 kg/m³, then total pressure force on the plate (in kg) is approximately

A:

Q: A glass tube of internal diameter 3 mm is immersed in mercury. The angle of contact of mercury with…

A:

Q: Looking for quick solution The utube manometer shown in the figure has legs that are 1.0 m long.…

A: When no pressure difference is applied across the manometer, each leg has 0.4 m of mercury

Q: The gate shown is hinged at (0) contains water on one side and oil on the other. What force (F) is…

A: The expression for the area of the gate on the water side can be written as, A1=0.7 m2.8 m=1.96 m2…

Q: A 1.5m semi-circular gate is submerged in oil having an SG of 0.95. Its base is 2m from the surface…

A:

Q: A semicircular gate with a diameter of 6 ft is installed at 50º as shown below. The top of the gate…

A:

Q: Bottle was filled with water and a hole is punched in the bottle.When the bottle is closed, water…

A:

Q: 3. A rectangular gate 1.4 m in base and 1.8 m high is placed on the face of the water reservoir, as…

A: Given: Length of the gate (L)=1.8mBreadth of the gate (b)=1.4Mass of the buoy (mb)=20kgMass of the…

Q: The gate shown below has a homogeneous depth into the page of 5 meters. Label all parameters and…

A: Given:The width is  the height is the density of water is

Q: Q3 :A plate ABCD hangs in water from one of Water Surface its corners (as shown in the figure).…

A: Consider the ABCD hangs as shown below, Where h* is the location center of pressure and h¯ is the…

Q: The pressure at point m in the figure shown was increased from 85 kPa to 125 kPa. This causes the…

A: Given DataPm1=85kPaPm2=125 kPaρm=13.6

Q: 3. The rigid surface shown on the left side of the figure has a vertical section and an inclined…

A:

Q: What are the pressures at the A(conjunction of water and oil), B (middle of water), C (bottom of the…

A:

Q: b- The right limb of a simple U tube manometer containing mercury is open to the atmosphere while…

A:

Q: 4. A sliding gate of height 14mand width 28lies in vertical plane that weighs 25AN. Determine the…

A: Given: Height of the gate→h=1.4 m Width of the gate→b=2.8 m And wieght of the plate→W=25 KN because…

Q: A tall cylindrical tank 150 mm in diameter contains water 200 mm deep and oil (S = 0.80) 30 mm deep.…

A: Given:D=150 mmH=200 mmS=0.80D=30 mmd=100 mmh=120 mmW=5 N

Q: For a vertical rectangular gate, one side has linseed oil (0.938) and the other has two…

A: Calculate the magnitude and direction of the net force acting on the gate.

Q: 3. Calculate the magnitude of the force acting on the cylinder cap of the tank filled with water as…

A: Given: Here is the given data, h=11 mL=3 mr=4 mα=30°ρ=1000 kg·m-3 To find: The magnitude of the…

Q: A square plate is submerged in water as shown below. Set up an integral to find thehydrostatic force…

A: Write the expression of pressure.   P=δdHere,δ=specific weightd=depth   From the given diagram, the…

Q: B3. A circular plate of diameter 2.5 m is vertically placed in water in such a way that the centre…

A:

Q: An open tank contains water with oil floating on top. The depth of water is 2m and that of oil is…

A: Write the given data with suitable variables. hw=2 mhoil=6 mPatm=760 mm of HgSHg=13.6Soil=0.8ρw=1000…

Q: The gate shown is hinged through a point A and is restrained from opening by a fixed ridge at point…

A:

Q: The gate is 160 cm wide, is hinged at point B, and rests against a smooth wall at point A. what is…

A: