Answered: 1.18 In the circuit shown in the figure…

1.18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage V = sin2t? eeereern Vs (1 + j1) 2

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: a)For the inductive element of Figure 1 , the current in phasor form is B) the voltage in phasor…

A: The solution can be achieved as follows.

Q: For the following waveforms: i = 2 sin(wt – 60°) v =-50sin(wt + 30°) The relationship between the…

A: Given : Current waveform i=2 sin(wt -60°) Voltage waveform v=-50sin(wt +30°) In the voltage…

Q: Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an…

A: The given circuit isWe need to find The formula for the total impedance, Ztot.The formula for the…

Q: An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum…

A: Given: Expression for alternating current i=200sin314t+π/6 amperes

Q: For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re…

A: The period of the sinusoid is given; the frequency of the sinusoid is calculated as shown below:…

Q: H.W: A sinusoidal waveform, 3v2cosw,t, is added to a second 4v2coswzt, determine the rms value of…

A: Part (a): When the angular frequencies for both the sinusoidal waveform are equal, these signals are…

Q: Calculate the rms value of a sinusoidal current of maximum value of 20 A

A: Maximum value Im = 20 A RMS value of sinusoidal current IRMS = ?

Q: 18 In the circuit shown in the figure value of C will the current-I be in phase with the sinusoidal…

A: Given: Brief description: In the given circuit we have an AC circuit. The circuit consists of…

Q: Draw the waveform of voltage and current under the following conditions: A current which lags the…

A: In this question, We need to Draw the waveform of voltage and current under the following…

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…

Q: The sinusoidal voltage source in the circuit seen in (Figure 1) is operating at a frequency of 54…

A: For given coupled circuit, frequency, ω=54 krad/sec Supply voltage, Vg=429 cos 5.4×104 t =429 ∠0° V…

Q: The source in the circuit shown is a sinusoidal source. The supply voltages across various elements…

A: Given a series RLC circuit, Voltages across each elements are as, Resistance voltage, VR=3 V…

Q: 7 Find the average and effective values of voltage for sinusoidal waveform shown in Figure. Vm = 100…

A: Given Waveform in the question, Form the above figure, it can be observed that the waveform is an…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

Q: 12.6 Determine the phase relationship between the sinusoidal waveforms of the following set: v(t) =…

A: Note: As you have mentioned for a handwritten solution, I am solving it in both formats handwritten…

Q: Let's say you measure t1/2 to be 0.037 seconds and the resistance in the circuit is 68 Ohms. Then…

A: The half time, The resistance,

Q: Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine…

Q: shown in the Vps low is Write the FORMULA for the total impedance of the circuit Zut= R²+ cL- Write…

Q: what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms

A: The solution can be achieved as follows.

Q: The below figure shows the waveform of the voltage and current in a purcly inductive AC circuit.…

A: Consider the given waveform.

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: Determine the phase angle between v1 = -10cos(wt + 50) and v2 = 12sin(wt -10).

Q: The below figure shows the waveform of the voltage and current in a purely inductive AC circuit.…

A: Correct option is LAGS BY 90° we can see that the initiation of current is very much slower than…

Q: Q5)-a)For this figure shown below the phase relationship between the sinusoidal waveform Of this…

Q: Calculate average and RMS value of the voltage waveform given in Figure. 4V 2 t(ms) – 4V

A: Considering the given signal is periodic in nature then the time period of the signal is 2. The…

Q: 1) Two identical voltage waveforms of difference phase angles are shown in Figure B. Write down the…

Q: The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert…

A: Ohms law V = IRGiven R = 15 kohmFor i1 = 3.5sin(2500t) mACurrent in polar form = 3.5<0° mAMath in…

Question

1.18 In the circuit shown in the figure below, for what
value of C will the current-I be in phase with the
sinusoidal source voltage .= sin2t?
S
I
C
(1 + j1) 2
el eareern Vs
slinw

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b) Determine the voltage v(t) and current i(t) sinusoidal forms. Sketch one cycle of the waveforms in the same x-axis. Clearly indicating the peak value and the period of each waveform and the phase difference (in milliseconds) between the two waveforms. c) Determine the values of resistance R and inductance L. d) Determine the phasors V,, VR and Vc. e) Sketch the phasor diagram showing Vs, Vr, Vr, Vc and I.
A generator rated at 30MVA, 11kV has a reactance of 40%. Calculate its p.u. reactances for a base of 50MVA and 10kV. O 0.606 p.u. O 0.506 p.u. O 0.806 p.u. O 0.706 p.u.
400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is conducting 300 usec. what is the addition of conducting and non conducting period? (Write your answer in usec) Answer:
Please disregard the question on the picture. Here's the right question, at what frequency will the value of the impedance be twice that at 25Hz (refer to the given in question #20).
A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle of 50% and 1ms period. If it has a resistance of lohm and an inductance of 10mH, find the source voltage. output 5A -current 2A ten toff
Ac - 100 VrmsR1 - 1kR2 - 500Rload - 1kCapacitor - 2uF Q1. How much is the capacitor voltage lagging from the AC source
Do all questions
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
3- Please I want answer of this Electrical Principles question. Thanks
Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the characteristics of the waveform for each load. A. Pure resistor B. Pure inductor C. Pure capacitor
Q.4Determine the current flowing in the capacitor(-j25ohm) and its direction as shown in Figure below. Assume the voltage source to have negligible impedance.
The waveforms below represent one full cycle of the applied voltage vs and the supply current is. based on the waveforms below, which of the following statements is true. options: is leads vs is lags vs is is in phase with vs