1. You will implement an 8-bit Ripple Carry Adder with two 8-bit inputs, a 1-bit Carry In, one 8-bit result output, and a 1-bit Carry Out. 2. Your circuit must have inputs named a, b, and cin, and outputs named sum and cout. Your file must be called 8-bit-ripple-carry-adder.dig

Q: weighted-input DAC in that it requires only two resistor values.

A: Step by step explanation is in given below.

Q: When given a 4-bit comparator, how do you give the value of the 3 outputs?

A: A comparator is a digital circuit or an electronic component that compares two input signals and…

Q: 4. What is a sign bit used for and where is it located?

A: Use of sign bit and its location The sign bit is a bit in a signed number representation that…

Q: Realize a 5-bit 2s complement adder/subtractor with a control input add/(sub) ̅. Simulate for the…

A: As per bartleby guidelines for more than three subparts, only 1st three are to be answered. Please…

Q: Q3. Derive the circuit for a 3-bit parity generator and 4-bit parity checker using an even parity…

A: We have used 2 XORs

Q: Hello.  The goal of the experiment was to find the largest adder that will fit into a GAL22V10.…

A: The largest adder that will fit into a GAL22V10 is a 4-bit ripple carry adder.

Q: Briefly explain one bit half adder with its truth table and expression?

A: It is a combinational logic circuit and it is used to add two one bit digits.It uses AND gate and…

Q: Realize a 5-bit 2s complement adder/subtractor with a control input add/(sub). Simulate for the…

A: Answer: Our instruction is answer the first three part from the first part and I have given answered…

Q: an 8x1 multiplexer using only 74LS153 and 74LS157. Show Pin connections for your design.

A: It is defined as a combinational circuit that has maximum of 2n data inputs, ‘n’ selection lines and…

Q: Explain how multiplexing and demultiplexing are different.

A: INTRODUCTION: Multiplexing, often known as muxing, is a method of simultaneously conveying many…

Q: 5 - Full adder can add two binary bit

A: Answer : yes , it is true .

Q: esign and simulate four bits binary to gray converter

A: Design and simulate four bits binary to gray converter

Q: A combinational device for comparing equality of two 2-bit values is illustrated below. Equal 0123 5…

A: 4-Bit  Mаgnitude  Соmраrаtоr  –А  соmраrаtоr  used  tо  соmраre  twо  binаry  numbers  eасh  оf…

Q: How do you use a 6 bit adder for 100000 + 111111

A: A 6-bit adder is a digital circuit that performs the addition operation on two 6-bit binary numbers.…

Q: Course: Digital Electronics   How to implement a full subtractor using a decoder IC 74138? and why…

A: IC 74138 is the 3*8 demux, which can be used in the full subtractor. Full subtractor has the three…

Q: Designa 4-bit by 2-bit  binary multiplier. with full diagram adder

A:

Q: it adder r

A: When performing arithmetic operations, an overflow can occur if an 8-bit adder reaches a 9-bit…

Q: Design a BCD to seven-segment converter.

A: In  Binаry  Соded  Deсimаl  (BСD)  enсоding  sсheme  eасh  оf  the  deсimаl  numbers(0-9)  is…

Q: Can you please help design or draw an 8 bit multiplier? Using logical gate!

A: 8-bit multiplier : A multiplexer is a device that enables the selection of one of numerous analog or…

Q: 3. In the 7483 circuit, where should the CARRY IN (CYI) be connected to be able to add 4 bits?

A: 1) 7483 is a 4-bit parallel binary adder chip. It adds a four-bit number (nibble) with another 4-bit…

Q: how to simplify: ac+b'c+a'c'd+bcd  to get: ac+b'c'+a'bd

A: Introduction: Boolean algebra is a branch of algebra that deals with binary variables and logic…

Q: n Coding methods an we represents a 0 bit by a low to high voltage ansition, and a 1 bit is…

A: yes In the coding method, we can represent a 0 bit by a low to high voltage transition, and a 1 bit…

Q: Assuming a 1-bit full adder, if A is 1, B is 1, Cin is 1, What will be S and Cout respectively?

A: For full adder,  The equation for S is S= A+B+Cin The equation for Cout is Cout = A xor B xor Cin

Q: Given the following truth table, abc F 000 1 001 1 010 0 011 1 100 1 101 0 110 0 111 0

A: Here the given terms in truth table are max terms. Max terms are POS (product of sum) form,

Q: The minimum number of 2-1 multiplexers required to implement 4-1 multiplexer is... O 2 3 O 4

A: A multiplexer is a circuit used to select and route any one of the several input signals to a single…

Q: Design and estimate the propagation delay of a 16-bit hybrid adder using ingle edTaid-1 yd triga…

A: Propagation delay: It is the amount of time which is essential for a signal to be received after it…

Q: An 8-bit of R-2DR DAC has Vs = 10V and R = 2kΩ. Calculate the value of Vout for a. LSB b. MSB c.…

A: The answer for the given question is given below:

Q: Suppose you want to add 2 bit half adder in this circuit. How do you modify this circuit ? Draw the…

A: SUMMARY: - hence, we got the desired output.

Q: Fill in the truth table for the One Bit Wide 4 x 1 Multiplexer.

A: In this 4x1 Multiplexer has four data inputs A(3), A(2), A(1) & A(0), two selection lines s1 and…

Q: r 10101 and 4 bits of error detection code, please design the hardw

A: The hardware circuit of encoder

Q: Topic: Logic Gates, Adders, Shifters a) Draw a 2-bit Full-Adder using AND, XOR, and OR logic gates…

A: We have to complete the 3 sub-tasks given in this problem.

Q: How can we implement full adder using 4:1 multiplexer?

A: Full adder using 4:1 mux: means we reducing the inputs,so we use kmap. we take all eight input given…