1. You are throwing a fondue party! You need to heat 800.0 mL of vegetable oil from 20 to 190.0°C using an ethanol burner. Assuming a perfect transfer of heat from the burner into the oil, what mass of ethanol would be required (Note - ethanol has a molar enthalpy of -1277 KJ/mol)? Assume your kitchen is at SATP, vegetable oil has a density of 0.920 g/mL and the specific heat capacity of vegetable oil is 2.000 J/g °C.

1. You are throwing a fondue party! You need to heat 800.0 mL of vegetable oil from 20 to 190.0°C using an ethanol burner. Assuming a perfect transfer of heat from the burner into the oil, what mass of ethanol would be required (Note - ethanol has a molar enthalpy of -1277 KJ/mol)? Assume your kitchen is at SATP, vegetable oil has a density of 0.920 g/mL and the specific heat capacity of vegetable oil is 2.000 J/g °C.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

es 20. How many Btu need to be added to change 5 lb of ice at 30°F to steam at 215°F? Refer to tables for latent heat values as needed for calculations.
From an experiment, the higher heating value of ethanol was obtained to be 1350 KJ/mol. a. Compute for the heat of formation of ethanol b. Using the heat of formation from Perry's Handbook, compute for the percent error
How much heat is needed to completely vaporized 100 kg of ice at -10 C if the pressure held constant 200kPa. latent heat of fusion at 200 kpa is 320 kj/kg latent heat of vaporization at 200 kpa is 2 202 kjkg. show t.s Diagram and all units.
9.106. A 1.0-kg sample of stainless steel is heated to 400°C. Suppose that you drop this hot sample into an insulated bucket that contains water at some known initial temperature. Assuming that there is no difficulty in transferring heat from the steel to the water, describe how you can determine the maximum mass of water that could be boiled with only the heat given off by this sample of steel. Be sure to list any quantities you would need to look up to solve this problem.
Please solve this in thermodynamics
On a 5 day wilderness expedition you'll need to heat 3.0kg of water to the boiling point each day. The air temperature will average 25°C. You have available canisters of compressed propane C3H8 fuel, which you'll burn to heat the water. Each canister has 100.g of propane in it. What is the minimum number of fuel canisters you must bring? The standard heat of formation of propane at 25°C is −103.85/kJmol.
Discussion: 3- Is a diesel oil of a high aniline point desirable as automotive fuel? Why?
3. Mention how freezing increases food storage time.
3.31 Explain the following pulverized coal burners: (1) Long flame burner (2) Short flame burner (3) Tangential burner
Subject: Thermodynamics Compute the mass of a 2m3 oxygen at 280 kPa and 40°C
Write the method with formula explanation and working steps Write down the formula and explanation and the equation
QUESTION 2 A new induced raft cooling tower is circulating 120 000 L/h of water that is cooled from 50 °C to 22 °C. How much blow-down and make-up is required to maintain the concentration of dissolved solids in the circulating water at four times the concentration in the make-up water? Assume the following: - The evaporated water contains no dissolved solids so all solids entering the system in the make-up must be removed by blow-down and windage. - The windage value of the induced draft cooling tower is 0.3% for each 5.6 °C. - The evaporative losses value is 1.1%.