1. What pressure will be exerted by 8.00 grams of helium in a 5000. L flask at 25°C? a. 39.1 atm b. 0.00978 atm c. 48.9 atm d. 9.79 atn e. None of the above 2. The wavelength of the yellow light given off by a sodium vapor street lamp is 589 nm. What is the frequency of this light in hertz (s¯¹)? 1.96 x 10-13 S-1 d. e. 1.77 x 10² S-¹ a. 5.09 x 105 s¯¹ b. 5.09 x 10¹4 S-¹ c. 1.96 x 106 S-¹ 3. Which of the following cannot function as a Bronsted- Lowry base? а. ОН b. NH3 c. CH,NH, d. CH₁ e. I

Q: Each row of the table below describes an aqueous solution at 25 °C. The second column of the table…

A: An acidic solution has a pH of less than 7. A basic solution has a pH of more than 7. A neutral…

Q: What is the pOH of a solution prepared by dissolving 1.75 g of hydrogen chloride in 870 mL of water?…

A: Volume=870mL= 0.870 litere.       (1 litere = 1000ml) Mass=1.75g pOH=?

Q: Classify each chemical compound listed in the table below. type of compound (check all that apply)…

A: 1)  HCIO4  are Ionic and Acidic compound. Explain : Perchloric acid  is reacting with the Water as…

Q: For eac the solu SO

A: Four multiple choice questions about solubility concept, which are to be accomplished.

Q: What does one do with the solutions after taking the measurements? What does one do with the…

A: The objective of the question is to understand the procedure to be followed with the solutions after…

Q: 2- Suppose a 0.020 Maqueous solution of sulfuric acid (H₂SO₂) is prepared. Calculate the equilibrium…

A: Given  Concentration of H2SO4 = 0.020 M H2SO4 is a strong acid. Hence ionization of 0.020 M of H2SO4…

Q: what is the molaity of the solution

A: Molality of a solution is defined as the no. of moles of solute present in 1 kilo gram of solvent.

Q: What is the difference between a 1 M solution and a 1 m solution?

A:

Q: how would you solve this question if it was 60.0ml

A:

Q: If 0.135 moles of NaCl are dissolved in a 250.0 mL solution, what is the concentration of the NaCl…

A: The most common way of expression solution concentration is molarity (M), which is defined as the…

Q: Assuming 100% dissociation which of the following solution will have the lowest boiling point. a)…

A: Introduction In order to determine the lowest boiling point, we need to calculate the van't Hoff…

Q: Each row of the table below describes an aqueous solution at 25 °C. The second column of the table…

A: Solution :     pH       pH is a quantitative measure for the acidity or basicity of the solution.…

Q: Many commercial sports drinks contain dyes. Could a beers law graph be constructed using…

A:

Q: How do I calculate the average value from my value and the two other students value ? my value is…

A:

Q: Each row of the table below describes an aqueous solution at 25 The second column of the table shows…

A: pH =  - log[H+] Therefore, more H+ releasing the compound lesser is its pH and hence more acidic the…

Q: How many millilitres of pure acid (100%) must be added to 500mL of a solutionthat is 10% acid (by…

A: The question is based on the concept of solutions. we need to calculate quantity of pure acid…

Q: Based only on their intermolecular forces, which of the following solutions would be immiscible in…

A: Like dissolve like principal" As per like dissolve like principal a polar molecule is dissolved in…

Q: Each row of the table below describes an aqueous solution at 25 °C. The second column of the table…

A: A. In the First solution KOH and H2O solution is made, the solution is basic as KOH tends to…

Q: Determine the initial concentrations of the species below, after the solutions are mixed. Volume…

A: Formula used M1 V1 = M2 V2 V2 = total volume = 20ml

Q: Some chemical compounds are listed in the first column of the table below. Each compound is soluble…

A: Molecular Bonds: Molecular bonds are formed by the sharing of electrons between two or more atoms.…

Q: Question: Comment on the solubility of the two dyes in water. In your answer consider intermolecular…

A: The solubility of a compound in the water or aqueous medium depends on couple of important factors:…

Q: why did you write .006045 mol for "before" for NaOh, wouldnt it be 0 mol. Wouldnt you put .006045…

A: Neutralization :- The reaction between H+ of acid and OH- of base to form H2O is known as…

Q: If i have 0.09079M HCL concentration solution & .09731M NaOH concentration solution  What amount…

A:

Q: Please give an equation to show why boiling water deviate from the neutral pH.

A: When water is boiled, both hydrogen ion and hydroxide ion concentration increases to same extent.…

Q: A student prepares a 0.41 mM aqueous solution of acetic acid (CH₂co₂H). Calculate the fraction of…

A:

Q: If you have 100ml of 1.0000M NaOH(aq) how many moles of NaOH do you have

A: Moles is defined as the fraction (ratio) of given mass to the molar mass of the substance. Here we…

Q: Will a weak acid/strong base neutralization have the same molar heat of neutralization as the strong…

A: Acids and bases are considered electrolytes, which on dissolution dissociate into their constituent…

Q: Draw a picture to represent the molecular view of the dissociation of HNO3 in water.

A:

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.