From question 1 to 4 1. What is the difference between pre-tensioning and posst-tensioning in terms of prestress transmitting?2. How the load is transferred from the slab to foundation in the RC structures?3. Why the additional stirrups are needed at the joint of the main beam and the secondary beam?4. What are the assumptions when we simplify mill bents to get the a computational model?

As per guidelines we need to answer only 1st question so please repost rest questions separately

Answered: 1. What is the difference between…

Engineering

Civil Engineering

1. What is the difference between pre-tensioning and posst-tensioning in terms of prestress transmitting?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: What are the characteristics of Error-Detecting Codes

A: Error-detecting codes - They are the sequence of numbers that are generated by specific procedure to…

Q: Given STATION GEORGE HILL SOLOMON HILL ANG HILL ELEVATION(m) 680 645 620 DISTANCE GEORGE HILL to…

A: There are three hill station which are George hill ,Solomon hill, ang hill. The elevation of this…

Q: Given in the accompanying sketch is a cross-section which has been plotted from soundings taken…

Q: Develop your personal definition for the practice of surveying.

A: Surveying is the practice of observing and assessing the relative positions of places in relation to…

Q: your answers are not in the choices. 1. A) 175 mm B) 150 mm C) 200 mm D) 250 mm 2. A) 820 mm B)…

A: The solution provided by the earlier expert is wrong. So, I am giving you a fresh solution.

Q: Area and perimeter of a parking lot Length= 168 ft Width= 60 ft Depth= 5 inches

A: Width = 60 ftLength = 168 ftDepth = 5 inTo find:The area and perimeter of a parking lot.

Q: The base and altitude of triangular-shaped figure were measured with certain mated probable errors…

A: b=(425.67+0.99) +/- 0.07 b=426.66 +/- 0.07 h=(138.65 + 0.99) +/- 0.06 h=139.64 +/- 0.06

Q: S = 1 : 18,000; f = 152.40 mm Express your answer in feet to three significant figures. H = Submit…

Q: QUESTION 1: ISOMETRIC Q1(a): Taking X as the lowest view point, sketch the isometric view of the…

A: Given details are- Top view , front view and side view The hand drawing of isometric view is…

Q: 1. What is Airspace Charting? 2. How do you read an Airspace Chart? 3. What charts do pilots use? 4.…

A: Note: Hi! Thank you for the question as per the honour code, we’ll answer the first question since…

Q: Draw figures to show N60E, S15E and S30W .

A: The figure showing N60E is given below.

Q: Discuss the importance of climatology in architecture and include sketches

A: Climatology plays a very important role in architectural and building forms. Where the comparison of…

Q: Convert a verbal scale of 1 in. = 100 mi to RF.

Q: The given shaded area in the figure below, it is the top plan of a flower garden (with a circular…

Q: Aerial photography is to be taken of a tract of land that is X-mi square. Flying height will be H ft…

A: Flying height, H = 4100 ft Focal length, f = 152.4 mm or 6 in Focal plane opening = 9in x 9in…

Q: What is the length of the dividing line? (Type your answer using 2 decimal places, numerical value…

Q: = 6x – 0.5x y(0) = 0 y(12)= 0 Finally, Find y (4)

Q: Discuss the nearest neighborhood resampling algorithm, as one of image rectification techniques

A: Nearest neighborhood re - sampling system selects the value of pixels to an unspecified pixel based…

Q: Q2/ Initial Map scale is 1: 1000. The playground is rectangular and on the map has dimensions 8 cm…

A: This question is related to the Surveying Engineering from Civil Engineering. In this question ask…

Q: Calculate the y-coordinate of the centroid of the shaded area.

A: It is asked to calculate the centroid of the shaded area.

Q: QUESTION 8 What is the flow of a pipe that has an 8" diameter and 1% slope? Use the Hazen Williams…

A: dia of pipe=8''slope=1%=0.01discharge=?

Q: Q2) It is required to measure the distance from A to C which was obstructed by a building (see the…

Q: Q4: The project company shown in the table has used the early and late times to answer the following…

Q: ing the epanet program, create a water network on this map, the percentage of personal consumption…

A: The Water Supply and Water Resources Division of the United States Environmental Protection Agency…

Q: Determine the y-coordinate of the centroid of the shaded area. 0.37h 54 --x Answer:F =

A: To find y coordinate of centroid

Q: What situation does Route Survey is applicable?

A: The situations that require application of Route survey are explained in the following step.

Q: A GPS enabled device has many uses. Write or record a short description of what GPS stands for, how…

A: Reference : Surveying/ Mapping and Photogrammetry, GPS To determine : 1. Small Description 2.…

Q: Aerial photography is to be taken of a tract of land that is X-mi square. Flying height will be H ft…

A: Flying height, H = 4500 ft Focal length, f = 152.4 mm or 6 in Focal plane opening = 9in x 9in…

Q: Station 10+50 (elevation = 1103.15') Compute the slope of the line from Station 5+85 to Stat answer…

Q: Consider the following rooms from a hotel: D2 Room 217 Room 218 D1 D3 Hallway D6 D4 Room 318 Room…

Q: Untitled Section A distance between point (A) and (B) is (170m) was measured by a tape of (20m)…

Q: Question 8 (1) Question 9 (1) What is the FS Reading What is the BS reading ? Answer: Answer: 4 2

Q: how can errors occur when trying to measure the average speed of a an actual car passing by with a…

A: It is important to measure the average speed of a passing car with a high precise methods instead of…

Q: A student recorded the following repeated paces of a given line: 456, 448, 462, 447, 452, 455. If…

A: Given: Pace factor= 0.628m/pace

Q: Determine 1. Coefficient Uniformity 2. Coefficient of Curvature of the table.

A: Mass retained are noted in laboratory experiment for each sieve. Total mass of soil = 2457…

Q: Determine coordinates of centroid of the following shaded area.

A: Centroid is the point where the whole weight of the body acts. If the section is made up of…

Q: Briefly discuss GPS applications in Civil Engineering

A: Global positioning system or (GPS) is a navigation facility which is based on sending and receiving…

Q: A 40 SITUATION 6

Q: Q1. Complete the statements 1 to 10 using the words/phrases given in the following box. Note: one…

Q: 50 F 10 m B 150 6 O 400 tlo o + 100 150 50 00 50 50 100 150 20 す。 F' of X K X X

A: profile graph would be according to the elevation i.e. the contour level given in the diagram as we…

Q: Based on the survey notes below, fill in the necessary data to answer the next set of questions. All…

A: Reduced level :- Elevation of a point with respect to mean sea level is called Reduced Level.Back…

Question

From question 1 to 4

1. What is the difference between pre-tensioning and posst-tensioning in terms of prestress transmitting?
2. How the load is transferred from the slab to foundation in the RC structures?
3. Why the additional stirrups are needed at the joint of the main beam and the secondary beam?
4. What are the assumptions when we simplify mill bents to get the a computational model?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Stresses in saturated soil without seepage

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

p.s. this is only my reviewer passed by my senior
solve the following problem with the correct answer please, please make sure to show all work so I can understand.
Differentiate GPS and Differential GPS (DGPS)?
With neat sketches, write a brief note on the following instruments used in chain surveying 30 m chain Ranging rod Cross staff Line ranger Optical square
unit rate of 51 minutes/ 6 miles
Describe the content of the GPS broadcast message
WHAT ARE THE THREE BASIC SUB- SYSTEMS OF RAILWAY SIGNALING?
Calculate the flight height above average terrain that is required to obtain vertical photographs at an average scale of Sif the camera focal length is f for the following data: ▾ Part A S=1:14,000; f = 152.40 mm Express your answer in feet to three significant figures. H= Submit Part B |VL]ΑΣΦ1 11 H= Request Answer S=1:9600; f=88.90 mm Express your answer in feet to three significant figures. vec 4 → ĊIE ΠΙΑΣΦΗ vec 4 ? ? ft ft
fast please!
According to the figure below, fill out the table showing all your calculations: a) find the elevation of TP2 b) perform the arithmetic check BS 1.27 BM Elevation 356.68 *All values are in feet. STA BM ΤΡΙ TP2 B.S. 1.27 FS 4.91 H.I. TP₁ BS 2.33 F.S. FS 6.17 Elevation TP₂
Help me, thank you! List of Surveying Instruments that are used in the field of Civil Engineering. Describe each instrument and put the uses, advantages and disadvantages.
using First Angle Projection Method. (a) Front View. (b) Top View. (c) Right Side View. (d) Isometric View