1. Water flows steadily down a vertical pipe of constant cross section. Neglecting friction, according to Bernoulli's equation, velocity decreases with height. 2. A liquid in an open right circular cylinder is given rigid body rotation about the axis of the cylinder. The pressure distribution in any vertical plane is uniform. 3. A curved surface is submerged in a static liquid. The horizontal component of pressure force on it is equal to the pressure force on a vertical projection of the surface. 4. A U-tube manometer measures the difference in total energy between two points.

1. Water flows steadily down a vertical pipe of constant cross section. Neglecting friction, according to Bernoulli's equation, velocity decreases with height. 2. A liquid in an open right circular cylinder is given rigid body rotation about the axis of the cylinder. The pressure distribution in any vertical plane is uniform. 3. A curved surface is submerged in a static liquid. The horizontal component of pressure force on it is equal to the pressure force on a vertical projection of the surface. 4. A U-tube manometer measures the difference in total energy between two points.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Q.2 3 A fluid of density 1200 kg/m at 1 atm pressure is compressed to 101 atm pressure isothermally. If the isothermal -5 compression is 4.8x 10 atm, the -1 increase in density in kg/m of fluid is
Q1: The U tube (in Fig.1) is open at (D) and closed in (A). What will be the pressure at point (A, B and C): 1- Uniform acceleration (az=10m/sec?) to the top only. 2- Uniform acceleration (ax =10m/sec²) to the right and (az=10m/sec") to the top. 0.6m 0.9m Fig.1
Please Answer Q2.
The U-tube at both ends is open to the atmosphere. And the liquid between water and oil does not mix on different sidesWhere d = 12.3 mm as shown and a = 67.5 mm, find the density of oil. [Let the water density be 1000 kg / m ^ (3)] and answer in kg / m ^ (3).
5. The bulk modulus of compression......... (a) is independent of temperature of pressure and viscosity (b) increases with the pressure (c) is independent (d) has a dimensionless unit 6. If a non-uniform solid body weighs 500 N in air and when it is completely submerged in water its weighs is 300 N. If it has a volume of 0.0136 m³ then its specific gravity is.......... (c) 2.5 (d) 3.0 (e) none of these (a) 1.5 (b) 1.7 7. A flat plate of area 1.5 m² is pulled with a speed of 0.4 m/s relative to another plate with a distance of 0.15 mm clearance between them. For a fluid viscosity of 0.1 Pa.s, the power required to maintain this speed is (a) 160 W (b) 100 W (c) 200 W (d) 400 W 8. A solid wooden cylinder (SG = 0.6) has diameter of 0.8 m and a height of 3 m, when the cylinder is floating vertically on its base in water then the submerged height of the cylinder is. (a) 1.1 m (b) 1.4 m (c) 1.8 m (d) 2.6 m 9. A wooden cube (SG=0.6), its base 5 cm x 5 cm and has 10 m height, floats vertically…
I need answers in less than an hour T.T. Thank you!
HW2.1 A V= im' volume of water is contained in a rigid container. Estimate the change in the volume of the water when a piston applies a pressure of Ap = 35MP..
A 5-gal, cylindrical open container with a bottom area of 120 in^2 is filled with water and rests on the floor of an elevator. If cylindrical container is accelerated upward at 3 ft/s^2, what resultant force does the container exert on the floor of the elevator during this acceleration? The weight of the container is negligible. (Note: 1 gal = 231 in^3)
2) In a static fluid (b) fluid pressure is zero (c) linear deformation is small (e) viscosity is nil. (d) only normal stresses can exist (a) resistance to shear stress is small
A vertical U-tube partially filled with alcohol (SG= 0.99) is rotated at a specified rate about its left arm. Compute for the following: (a) angular velocity of the tube's rotation if the alcohol is on the brink of spilling (b) pressure at point B during the rotation of the tube Please provide explanation per line of solution. thanks 10 cm 20 cm B +12.5 cm - 12.5 cm 25 cm
Water flows from a large tank as shown below. Atmospheric pressure is 100 kPa and the vapor pressure is 11.0 kPa. To avoid cavitation, should the value of D2 be increased or decreased? Please explain. Please use mathematical justification whenever necessary.