1.) Water flows at 10m3/s in a 150-cm diameter pipe; the head loss in a 1000-m length of this pipe is 20.0m. Find the rate of energy loss due to pipe friction for the pipe. Use unit weight of Water : 9.79KN/m3. 2.) Given the two dimensional flow as shown in the accompanying figure. Determine the flow rate considering 1.5m of width perpendicular to the figure.

Q: 50 cm Water m kg/s 2 50 cm FR. Water If another (identical) elbow is attached to the existing elbow…

A:

Q: neqaned mormation A 90° elbow in a horizontal pipe is used to direct water flow upward at a rate of…

A: Diameter of elbow=10cm = 0.1m Momentum flux correction factor=1.03

Q: 2. A pitot-static tube (C=1.0) is used to measure air speeds. With water in the differential…

A: Density of air and head water is given and it has been asked to determine velocity through pitot…

Q: 3 m P Lower reservoir 100 m 1 m Upper reservoir 10 m

A:

Q: Water entering a pump through an 200mm diameter pipe at 27.6 kPa has a flow rate of 0.1 m^3/s. It…

A:

Q: Flow from a tank with falling head. For the tank shown in figure below, find the time required to…

A:

Q: A 30m long dam is made to with-stand 750kN of water pressure. The maximum height of the water it can…

A: Step 1:Step 2:Step 3:

Q: 4. If viscous effects are neglected and the tank is large, determine the flowrate from the tank…

A:

Q: 4. A 60-cm-wide belt moves as shown in the figure. Calculate the horsepower requirement assuming a…

A:

Q: Problem 1: Water at 60°C flows at a rate of 0.015 m³/s from the reservoir through the pipe system…

A: To Determine 1. If flow is laminar or turbulent inside the pipe 2. The energy loss, b, due to…

Q: As shown in the figure below, water behind a dam enters an intake pipe at a pressure of 24 psia and…

A: To solve this problem, first we need to calculate the specific gravity. Then the Bernoulli equation…

Q: A vertical dam has a semicircular gate as shown in the figure. The total depth d of the figure is 14…

A: d = 14 mh = 2 mw = 4mkg/m3

Q: A pump system is used to move water at a flow rate of 30 L/s from a lower to a higher reservoir in a…

A: Given, D = 150 mm  e = 0.3 mm L = 506 m

Q: A converging tube discharges water from a reservoir, into the air, at depth of 6 ft below the water…

A: step 1-

Highway Drainage

Highway drainage is the process of extracting and regulating the excess surface water on the pavement by giving the desired slope. The construction of a highway drain helps to divert the water present on the surface, and sub-grade by the means of slope. Highway drainage systems are a necessary part of smooth functioning of traffic, since the highway drainage systems provide proper disposal of unwanted substances from the highways.